运用故障总时间法初步确定数控冲床的故障概率模型。
The model of the failure probability distribution was obtained by applying total failure time method for the numerical control punch.
在求得状态转移矩阵后，再建立离散动态事件树，来求得系统故障概率。
After calculating the matrix, the discrete event tree is established and used to solve the system fault probability.
随着SOC芯片故障概率的增加，嵌入式存储器的修复变得越来越重要。
The problem of embedded memory fault repair is becoming increasingly important with the growing fault rate of SOC.
针对该系统底事件和中间事件发生故障概率情况获取不足的情况，建立了故障树模型。
It uses separate-type and touch switch components, with complicated structure and high failure rate. The failure tree analysis method for controlled system is formulated.
要计算您的RAID - 0卷的故障概率，只需将所有组成驱动器的故障概率相加即可。
To figure out the probability of failure of your RAID-0 volume, simply add together the probabilities of failure of all constituent drives.
基于系统的状态划分，以统计理论的观点分析了容错控制系统中的故障概率、容错能力和可靠性问题。
The fault probability, the degree of fault tolerance and problem of reliabilty in the fault tolerant control system are analyzed in the view of statistics.
从可靠性的立场来看，RAID - 0模式与线性模式具有同样的特征——向阵列中添加的驱动器越多，卷的故障概率就越高。
From a reliability standpoint, RAID-0 has the same characteristics as linear mode — the more drives you add to the array, the higher the probability of volume failure.
本方法主要特点是计算工作量少，易于在计算机上实现，能在可靠性计算中反映各组分的最大负荷量和故障概率的影响。
The most responsibility and the contribution to the failure probability for each component are determined and this short-run calculation will be easily computerizable.
分析了IGP路由恢复时间对IBGP会话的影响，提出一种新的基于IGP路由恢复时间概率分布的IBGP会话故障概率计算方法。
A new approach is proposed to calculate the failure probability of IBGP sessions based on the probability distribution of IGP routing recovery time.
由于零件更少，因此电动汽车的保养更加便宜，出现机械故障的概率也降低了。
Having fewer parts makes the electric car cheaper to maintain and less likely to have mechanical problems.
以故障条件概率和搜索检测代价组成启发函数。
The heuristic function consists of condition possibility of fault and search cost.
论述了共模故障的有关概念和常见的共模故障类型，并给出了计算共模故障发生概率的方法。
It discusses the relevant concepts and usual types of common mode faults, and presents the methods for calculating the probability of common mode fault to occur.
充分考虑所需导航性能参数和不确定的噪声的因素，运用概率优化方法进行故障监测。
Proba-hilistic optimization design offers tools for fault detection by considering the required navigation performance (RNP) parameter and the uncertainty noise.
提出了一种基于元胞自动机的电路故障传播概率模型。
A probability model of circuit fault propagation has been proposed based on CA.
因果图理论是可以进行故障分析的概率推理方法，但是缺乏对故障模式的重要性的分析。
Causality diagram methodology is a probabilistic reasoning, which can be applied to fault analysis. However, it lacks analysis on the importance of failure mode.
对导致反应堆控制系统故障的事故序列进行了识别，计算了该系统顶事件的概率。
The event sequences leading to the reactor control system failure are identified and the top event probability of this system is calculated.
给出强度和应力的分布，六西格玛黑带应能计算出故障的概率。
Given distributions of strength and stress, the Six Sigma Black Belt will be able to compute the probability of failure.
本文提出了一种基于故障树分析和统计概率的模块化专家系统，作为此大型指挥控制系统电路的故障实时监测之用。
A modularization expert system based fault-tree analysis and statistical probability for real time fault detection of large anfractuous circuit is proposed in this paper.
其运用信度函数表达概率大小，通过多诊断设备测试被诊断对象，得出属于各类故障的信度函数。
The trust function is used to describe the probability; based on multi-diagnosis equipment to test diagnosis objects, the trust functions of every kind fault are acquired.
多计算机系统的容错性可以用互连网络中出现故障时，隔离这些故障设备后网络保持连通的概率来刻画。
The fault tolerance of an interconnection network can be measured by the probability of connectedness of the surviving network in the presence of failures.
通过自动变速器故障现象及原因表、故障原因概率图，可实现自动变速器故障的快速诊断。
The fast diagnosis of the troubles in automatic transmissions can be carried out by means of trouble phenomenon and cause lists and trouble cause probability graph.
同时利用贝叶斯网络实现概率推理，便于描述故障特征的变化及对变压器故障原因的快速分析。
At the same time, probability reasoning can be realized by BN, which can be used to describe changes of fault symptoms and analyze fault reasons of transformer.
由于试验数据和训练数据有限，传统的故障树分析难以对“卡管”事故原因及出现概率做出准确评价。
Because of the limitation of test and training data, the traditional fault tree analysis (FTA) method cannot provide accurate diagnosis.
平衡配置不分主备的双前置机的使用，减轻了前置机的负担，降低了前置机故障时下发报文丢失的概率；
The balanced dual FEP configuration reduces the loads of FEP and the probability of downward message loss, which occurs when one FEP is in failure.
提出了一种完全脱离马尔可夫模型的求解动态故障树顶事件发生概率的方法和一种最小顺序割集的生成方法。
Then this thesis presents a new approach to solve top event occurrence rate and a new generation algorithm of minimal cut sequence of dynamic fault tree that deviate from Markov model completely.
将结构概率设计方法与系统可靠性分析方法相结合，采用耗损故障分析模型，对系统的可靠性特征和寿命特征进行了研究。
According to the fault model analysis method, system reliability model for structure is presented based on structure probability design. The life and reliability characteristic measures are studied.
利用概率分析方法研究在实故障源作用下，由函数单元构成的控制系统的可靠性，并给出了系统不可靠度的下界估计。
The reliability of the systems affected by the failure sources is studied and a lower bound of the unreliability is presented.
通过对各部件多维故障特征参量的预测和故障模糊评判，可以自动分析出部件存在的故障及可能性概率。
Potential faults of parts and their probability will be analyzed automatically through the forecast of Multidimensional faulty characteristic parameters and fuzzy assessment.
通过对各部件多维故障特征参量的预测和故障模糊评判，可以自动分析出部件存在的故障及可能性概率。
Potential faults of parts and their probability will be analyzed automatically through the forecast of Multidimensional faulty characteristic parameters and fuzzy assessment.
应用推荐