纤维的吸水特性有助于保持皮肤干爽凉快，为避免摩擦力和剪应力的伤害提供了进一步的保护。
Absorbency properties in the fabric help keep the skin dry and cool, providing further protection against friction and shear.
分析表明，载荷、密封间隙、橡胶密封筒高度对应力最大值有影响，而摩擦系数影响很小。
The result shows that load, seal gap and seal height have influence on the maximum stress while friction coefficient has little influence on it.
在压缸内的摩擦力和铝锭的流变应力引起温度变化。
The temperature change is caused by the friction in the container and the flow stress of the aluminum.
文中以一菌型叶根为对象，分析了界面摩擦系数和初始间隙对接触力分布、载荷分配及最大应力的影响。
Aimed at a straddle blade root, the influence of the interface friction coefficient and initial clearance on the contact force distribution, load distribution and the maximum stress is analyzed.
本文讨论了摩擦系数对渐开线圆柱齿轮传动啮合效率和齿根弯曲应力的影响。
This article discusses the effects of friction coefficient fon the engagement efficiency of involute cylindrical gears and the bending stress of the dedendum.
研究了埋头弹火炮弹带挤进时的流动应力和摩擦系数，针对其特殊结构数值计算了挤进阻力，分析了挤进过程对内弹道性能的影响。
The stress and the friction coefficient of band during the engraving process were researched, and the resistance of this special structure was calculated.
同时，给出了不同条件下密集颗粒样本的生成方法，分析了边界应力、初始构型、加载速率、粒子间的摩擦系数等对颗粒系统目标构型的影响。
The influences of boundary stress, initial configuration, loading rate and friction coefficient between particles on the state and configuration of dense granular system are also examined.
反射裂缝裂尖位于面层中且裂缝长度大于某一值时，应力强度因子随着摩擦系数的增加而减小。
The SIF decreases with the friction coefficient rising when the surface crack tip lies in the base and the reflective crack length is more than a certain value.
在对轮-轨系统进行有限元分析的基础上，研究了轨道的受力情况和摩擦系数对应力分布的影响，讨论了轨道的弹塑变形和安定极限。
The finite element analysis of the wheel rail contact shows that the maximum stress under the subsurface exceeds first yield strength, which leads to plastic deformation.
结果表明：随着锥角和摩擦系数在一定范围内增大，锚环的应力会逐渐减小；
The results show that with the increase of the cone angles and the coefficients of friction in the certain range, the stress of the anchor ring can gradually decrease.
预应力张拉施工中夹片、钢绞线和锚环之间存在着很大的摩擦阻力。
There is much prestressing loss for friction resistance among wedge, steel strand and anchor-ring in engineering.
分析研究表明导致立井壁破坏的主要原因是井壁负摩擦力和温度应力。
The main causes of shaft wall fracture contain the reverse friction force and the temperature stress.
分析了滑动摩擦副疲劳损伤的产生机理，指出疲劳损伤产生的根本原因是动应力状态。
The originating mechanism of fatigue damage of sliding friction couples is analyzed and that the ultimate causation of fatigue damage is dynamical stress state is pointed out.
结果表明，剪力盒壁摩擦力将会影响试验土样中的应力分布和剪切面上的正压应力值。
The results show that the frictions caused by the wall of shear box will influence the distributions of stresses in specimens and the normal pressure stresses on the shear plane.
砂固结预应力锚杆的锚固力是由砂体与锚孔壁之间的摩擦力提供的。
The anchorage force of consolidated anchorage with prestressed bolt is actually the friction resistance between sand and the wall of drill hole.
分析结果表明，在地应力和支护阻力一定时，岩石的内摩擦角对深埋巷道围岩位移的影响最为明显。
The results show that the internal friction Angle of rock has importance affect on the displacement of surrounding rock for deep roadway when in-situ stress and support resistance all are certain.
并且表面摩擦力对涂层体系的应力分布有显著影响。
Furthermore, the effect of friction force on the stress fields of the integrated coating systems is considerable and cannot be neglected.
考虑岩石粘聚力和内摩擦角的变化，进行了一个和二个隧道周围的应力分布的参数研究，内摩擦角？
By considering the variations of the cohesion and the Angle of internal friction for rock, the parameter studies on the stress distribution around one and two tunnels were carried out.
地震动态应力使围压产生低值波动，一方面使围压减小、摩擦力减小；
The dynamical stress produced by superposition or interference of reflected stress wave makes confining pressure reduce and change at low values.
对V形密封在整个工作寿命中，轴向挤压应力、轴向压力分布、摩擦力等特性变化进行实验研究。
The variation laws of wearing character on V - packing are studied in the whole working life. The wearing character include the friction force, axial extrusion stress and axial pressure distribution.
即使断层裂开，也不会发生地震，因为那样的话，就不再有摩擦力了（摩擦力会使相接触的断层应力不断积累而最终诱发地震）。
Movement occurs along the plane of a fault, not perpendicular to it. If faults opened up, no earthquake would occur because there would be no friction to lock them together.
当接触面被完全剪断后，模型中的剪切应力出现了一定程度的下降，此后的剪应力在摩擦力的作用下基本保持不变。
However, as the interface was fully damaged, shear stress would decrease to a certain degree, and the residual shear stress nearly kept a constant value which equal to the friction force.
分析结果表明，在地应力和支护阻力一定时，岩石的内摩擦角对深埋巷道围岩位移的影响最为明显。
The results show that the internal friction angle of rock has importance affect on the displacement of surrounding rock for deep…
分析齿轮摆辗凹模的失效形式，并且通过改变直齿圆锥齿轮摆辗的工艺参数的有限元模拟，探讨了凹模进给量、摩擦系数和摆头倾角的改变量对凹模应力影响以及对凹模失效形式的影响。
The failure form of rotary roll cavity die for straight tooth bevel gear was analyzed, and the finite element simulation method was employed to change the processing parameter of rotary roll.
直线电机在执行重复性跟踪控制任务时，负载扰动、端部效应力及摩擦力会呈现周期性变化。
Load disturbance, end effect and friction likely appear periodically when a linear motor carrys out task repeatedly.
无粘结预应力筋摩擦力小，且易弯曲成各种形状，特别适合建造需用复杂的连续曲线配筋的大跨度楼盖和屋盖。
The tendons of unbounded PPC have smaller fraction force and are easier to bend to many shapes , so it is more suited for building these rooms whose span are large.
无粘结预应力筋摩擦力小，且易弯曲成各种形状，特别适合建造需用复杂的连续曲线配筋的大跨度楼盖和屋盖。
The tendons of unbounded PPC have smaller fraction force and are easier to bend to many shapes , so it is more suited for building these rooms whose span are large.
应用推荐