高强度的纱线要求有相当大的捻度，但是超过最佳捻度后，附加的捻度会使纱线扭结，最终降低纱线的强力。
Strong yarns require considerable twist. However, beyond an optimum point additional twist will cause yarns to kink and finally to lose strength.
长丝比短纤维需要的捻度少。
Filament yarns generally require less twist than do staple yarns.
纱线毛羽与捻度不匀严重影响织物质量。
Yarn hairiness and twist unevenness affect fabric quality seriously.
用于测定各种纱线的捻度及捻度不匀率。
Used for testing the twist and twist irregularity of all kinds of yarns.
复合纱线存在临界捻度；
用于单纱、股纱等进行直接计数法捻度测定。
Used for direct twist measurement of single yarn and plied yarn by counting.
用于测定粗纱的捻度。
粗纱捻度过大。
认为在设计和生产过程中，纬纱捻度的选择较为重要。
The selection of twist for weft is much important in design and production.
降低筒装绢丝捻度不匀率是绢纺行业的研究课题之一。
Lowering the twist irregularity of cone winded spun silk is one of the research projects inwaste silk spinning.
在假捻过程中捻度随时间变化的规律一般用假捻方程表示。
The variation of twist with time is represented by a false-twist equation.
当纱线被加捻的时候，在捻度的方向上也会相应地形成内应力。
As the yarn is twisted, internal forces are built up in the direction of the twist.
全真丝纬向弹力机织物的弹力主要利用强捻纬线的捻度释放来形成。
The elasticity of silk woven fabrics is formed by the twist release of hard twist on weft yarn.
纺纱是对纤维集合体牵伸加捻的过程。长丝比短纤维需要的捻度少。
Spinning is the process of drawing out and twisting a mass of cleaned prepared fibres. filament yarns generally require less twist than do staple yarns.
纺纱是对纤维集合体牵伸加捻的过程。长丝比短纤维需要的捻度少。
Spinning is the process of drawing out and twisting a mass of cleaned, prepared fibres. Filament yarns generally require less twist than do staple yarns.
在细纱生产中，粗纱被拉伸至所需要的细度，同时加上适当的捻度。
During spinning the roving is attenuated to the desired diameter, and the desired amount of twist is inserted.
结果表明，芳香族聚酰胺纤维的强度及断裂伸长随捻度的增加而下降。
The tests show that the strength and breaking extension of aramid fibres decrease with twisting.
针对转杯纱的结构特点及其对捻度测试的影响，提出了转杯纱的解捻模型。
The untwisting model of OE yarn is pointed out according to the structure of OE yarn and its influence on the twist measurement.
通过控制前罗拉与后罗拉的转速，由软件实现对粗纱牵伸倍数与捻度的控制。
By controlling the speed of front roller and back roller, the software controls the pulling times and twisting degree.
长丝首先被加捻，再被加热，在加热时使捻度定型；然后冷却，最后除去捻度。
The yarn is twisted, exposed to heat which sets the twist in place, cooled and untwisted.
注：特殊规格及捻度可在供需合同中规定。外观质量。无机纸绳外观紧密整齐。
Note: Special specifications and twist can be stipulated in contracts. Appearance quality. Inorganic paper ropes looks close and tidy from outside.
结果表明，织物组织、经纬线密度和捻度，对织物的热湿移动特性有明显的影响。
The results suggest the fabrics texture, the warp and weft density and the twist of yarn have obvious effects on the properties of heat and wet vapour transfer in fabrics.
用于测定棉、毛、丝、麻、化纤等纱线的捻度，并能自动打印测试数据和统计结果。
Used for measurement twist of the cotton, wool, silk, bast & chemical fibre yarn, it cans print the test data and statistical result automatically.
分析了几种引起捻度误差的主要因素和其误差估算方法，并提出了减小捻度误差的办法。
Analyses are made on some major factors affecting twist deviations and the relevant estimations, with measures to narrow twist deviations suggested.
第一，光滑表面的纤维只要求较少的粗纱捻度，以取得满意的卷装运输和下一步纺纱性能。
First, fibers having smooth surfaces require less roving twist for satisfactory packaging, handling, and performance in spinning.
本文研究环锭纺动态捻度传递过程，对导纱钩的捻陷作用及捻度损失的计算进行了分析探讨。
This paper studies the dynamic twisting process in ring spinning; analyses and calculates the loss of yarn's twist.
可以从此方程中，根据四个因素的具体纺纱条件和机器设计捻度直接求出气流纱的实际捻度。
With this equation, it is, possible to find out the practical twist of OE yarns directly from the four factors under the actual spinning conditions and the designed twist of these yarns.
羊绒纤维细而短小，如果纱线支数、捻度、织物结构、编织密度搭配不当，则很容易起毛起球。
Cashmere fiber thin and short, if the yarn count, twist, fabric structure, weave density, with properly, it is very easy to pilling.
纺纱过程的平衡点受成纱捻度、纺纱张力、须条隔距及超喂率的影响，它们之间存在一定的关系。
In the spinning process equalization point of the yarn is influenced by twist, spinning tension, roving interval, and overfeed ratio. Certain relationship exists among them.
纺纱过程的平衡点受成纱捻度、纺纱张力、须条隔距及超喂率的影响，它们之间存在一定的关系。
In the spinning process equalization point of the yarn is influenced by twist, spinning tension, roving interval, and overfeed ratio. Certain relationship exists among them.
应用推荐