• 松开固定时间子午线指示环的定位螺丝。

    Loosen the setscrew that secures the ring with the time meridian indicator.

    youdao

  • 松开刻度固定环,拆卸旋转指示器总成。

    Loosen scale retaining ring and remove turn indicator assembly.

    youdao

  • 松开赤经兼小时刻度环的定位螺丝后把赤经兼小时刻度环“0小时”位置对准赤经指示箭头。

    Set "0 hour" on the R. A. and hour graduation ring to the R. A. indicator after loosening the graduation-ring setscrew.

    youdao

  • 如果抛油环用在内侧驱动小齿轮内圈的后面,从针盘指示表读数中扣除抛油环的厚度,垫片的选择用这个总数。

    If an oil slinger is used behind the inner pinion bearing cone, deduct the thickness of the slinger from the dial indicator reading and use that total for shim selection.

    youdao

  • 一旦确定正确的流量设置,则将记忆止动装置朝着指示器板的开启位置顺时针方向旋转,直到记忆止动环触到指示器板为止。

    Once correct flow rate setting has been established, slide memory stop clockwise towards open side of indicator plate until memory stop ring hits indicator plate.

    youdao

  • 松开刻度上的固定环,旋转指示器刻度使其对齐手轮上的「0 」 。用手紧固刻度上的固定环。不要过紧。

    Loosen the scale retaining ring and rotate the turn indicator scale to align with the " 0 " on the handwheel. tighten the scale retaining ring by hand. do not overtighten.

    youdao

  • 如果你乘出租车或者自己开车,向北绕三环走。按照路牌的指示走就可以。

    If you take a taxi or drive, go north round the Third Ring Road. Follow the signs.

    youdao

  • 如果你乘出租车或者自己开车,向北绕三环走。按照路牌的指示走就可以。

    If you take a taxi or drive, go north round the Third Ring Road. Follow the signs.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定