喇叭单元的共鸣决定于电路中的总电阻。
The resonance of a loudspeaker unit depends on the total resistance in the circuit.
额定电流和总电阻等参数均在铭牌上标明。
Rated current and the total resistance and other parameters are indicated on the nameplate.
实际上，这就是把负电阻接入电路，使电路的总电阻为零。
In effect, a negative resistance is inserted in the circuit so that its total resistance is zero.
两线测量方法用于低阻测试时的主要问题是测量结果中增加了引线的总电阻(RLEAD)。
The main problem with the two-wire method as applied to low resistance measurements is that the total lead resistance (RLEAD) is added to the measurement.
当总通道电阻超过了开关卡的指标时，则认为使用寿命终了。
End-of-life is generally considered to be the time when the total channel resistance exceeds the specifications for the switch card.
本文讨论了矩形脉冲激励的对称驻波天线的能量方向图、总辐射能量、辐射效率和辐射电阻等问题。
The energy pattern, total radiation energy, radiation efficiency and radiation resistance of standing-wave dipole excited by rectangular pulse are discussed.
给出了一定分布电流下，整数倍半波天线辐射场的平均能流密度、辐射总功率及辐射电阻。
The article presents the average energy density, the total radiant power and the radiant resistance of the integral multiple semi-wave antenna with the electrical current of certain distribution.
所以输出电压可以用来度量输入电流，总的灵敏度由反馈电阻器（RF）决定。
Thus, the output voltage is a measure of input current, and overall sensitivity is determined by the feedback resistor RF).
目前实验室测量岩石复电阻率一般都采用集总电路模型，没有考虑测量电缆的影响。
The Resistivity measurements of rock in lab are generally based on the lumped circuit model, so the effect of cable is usually neglected.
脉宽调制技术是用来降低总功率交付给了负荷，没有造成损失，这是通常发生时，电源是有限的，由电阻芫件。
Pulse width modulation is used to reduce the total power delivered to a load without resulting in loss which normally occurs when a power source is limited by a resistive element.
该结构提供了一个集总声阻抗具有声波电阻与频率成正比，和声学惰性是与频率成反比。
The structure provides a lumped acoustic impedance having an acoustic resistance proportional to frequency, and an acoustic inertance that is inversely proportional to frequency.
为了减小器件的接触电阻和电流的非均匀性，使用了独特形状的集电极，总的电流密度也因此提高。
A special shape of collector is designed in order to reduce contact resistance and non-uniformity of the current; as a result the total current density in the device is increased.
要确定评估适当的命令，对待电路网络，把他们当作是电阻器，并且确定混联的总主抗由他们形成。
To determine proper order of evaluation, treat the contacts as though they were resistors, and as if you were determining total resistance of the series-parallel network formed by them.
要确定评估适当的命令，对待电路网络，把他们当作是电阻器，并且确定混联的总主抗由他们形成。
To determine proper order of evaluation, treat the contacts as though they were resistors, and as if you were determining total resistance of the series-parallel network formed by them.
应用推荐