认为总应力强度随干密度的增大和含水量的减小而变大；
The results indicated that the strength of total stress increases with accretion of dry density and with decrease of moisture content;
结果对于软骨总应力，两种参数设置的结果之间差异很小。
Results For the total stress of cartilage, there was no remarkable difference between two parameter configurations.
考虑残余应力的情况下，薄膜在大挠度时总应力的解析表达式。
Considering the residual stress, the total stress analytical solutions for square-shaped boron-doped silicon diaphragms with large deflection are presented.
随初始含水量的增大，总应力指标始终小于相应的有效应力指标；
With the increase of initial moisture content, total stress indices are always smaller than corresponding effective stress indices.
经过分析，作者认为当采用总应力法计算时，原则上应采用卸载强度指标。
According to the analysis, the authors conclude that the unloading shear strength parameters should be used when applying total stress method.
此外，对于基坑开挖采用总应力法分析时，应按卸载总应力强度指标计算。
Furthermore, the unloading shear strength parameters should be applied when using total stress method to analyse excavation problems.
应力路径对总应力强度指标有较大的影响，但对有效强度指标基本没影响。
The stress path has obvious influence on the total stress shear strength indexes, but almost no influence on the effective shear strength indexes.
结合实际地基中情形，说明了总应力分析时考虑固结应力和应力路径的必要性。
In association with the practical condition of ground the necessity of considering consolidation stress and stress path during analyzing total stress is stated.
采用初参数法对贴板钢丝缠绕区筒体应力进行了分析，得到筒体总应力表达式。
By means of original parameter method, the stress on cylinder's winding area is analyzed, formula for total stress of the cylinder is obtained.
鲁布革水电站心墙堆石坝采用总应力法和有效应力法计算程序进行计算和分析。
The calculation and analysis of the core type rockfill dam of Lubuge Hydropower Station are conducted by the programs of total stress method and effective stress method.
水力劈裂的常用计算方法分有效应力法和总应力法，但其计算结果却常有很大差异。
There are two analysis methods of hydraulic fracture: effective stress method and total stress method. Their computation results are quite different.
对整体平衡方程关于空间坐标积分，根据边界条件可确定总应力，并进而求得孔隙压力。
By integrating the dynamic equilibrium equation of porous media and using the boundary condition, total stress and fluid pressure are determined in turn.
结论不同的软骨力学参数设置对软骨总应力的结果几乎没有影响，但对软骨内流速场则影响很大。
Conclusions Different parameter configuration has negligible effect on the total stress of cartilage, but it is influential to the flow velocity.
研究了试样总应力、循环孔隙水压力、有效应力随时间的变化规律及试样有效应力与轴向应变的关系曲线。
Curves of total stress and time, of cycle pore water pressure and time, of effective stress and time, of effective stress and axial strain are respectively studied.
给出了小挠度下，在外界载荷作用下总应力表达式和薄膜机械灵敏度表达式，并分析了残余应力对二者的影响。
We present an analytical solution for the total stress and mechanical sensitivity of highly boron doped si diaphragm with small deflection considering effect to result from the residual stress.
将材料响应的总应力表示为平衡态应力和非平衡态过应力的和，分别定义描述率无关和率相关变形过程的内时。
The total stress response of material is decomposed into a sum of an equilibrium stress response and a non-equilibrium overstress response.
通过双江口堆石坝掺砾黏土心墙试验与计算，并与现有的总应力法计算结果比较，验证该总应力法算法的可行性。
The consolidation deformation can be calculated by new method. The superiority of new method is confirmed by model parameters test and stress-strain calculation for Shuangjiangkou dam.
当应变很大时，大变形法和小变形法计算的沉降和孔压差异很大。因此，大小变形法分析结果的比较应采用总应力法。
So the comparison of large strain method and small strain method should be carried out with total stress method.
当应变很大时，大变形法和小变形法计算的沉降和孔压差异很大。因此，大小变形法分析结果的比较应采用总应力法。
So the comparison of large strain method and small strain method should be carried out with total stress method.
应用推荐