对三角形底盘筒形件的成形工艺进行了分析，决定采用弯曲、拉深、胀形复合模等进行复合成形。
As the shape technology of triangle chassis canister is analyzed, then the processes of bending, stretching and bulging compound mould are adopted to reunite the shape.
分析了高压涡轮冷却外壳的成形工艺，并介绍了聚氨酯胀形模的结构设计和模具工作过程以及模具调试改进。
The forming technology of skin-cooling high pressure turbine was analyzed, introduced polyurethane bulging die structure design and the working process and die debugging improvement.
采用多点模具拉形时，由于弹性垫的使用，拉形后成形件的回弹量与使用整体模拉形时有所不同。
Because clastic cushions are used in stretching based on multi-point die, the springback in this process is different from that in traditional solid die stretching process.
介绍了管材无模轴压胀形的实验，研究表明，适度的褶皱有助于提高成形极限。
It has been experimentally indicated that moderate wrinkle will make a contribution to enhancing the formability of the dieless tube hydroforming.
成形极限图通常是通过钢模胀形试验测得，实际测量的成形极限图与ASAME自动应变测试分析系统模拟计算的成形极限曲线吻合较好。
FLD is usually measured with swell test in rigid die. The tested FLD is good fit that one measured by analogue computer in ASAME (Automated Strain Analysis and measure Environment).
优选地，成形器在打开位置和闭合位置之间枢转并且具有略微V形的基部，当V形的基部紧靠模具或模壳时促使凹部成形器处于闭合位置。
Preferably the former is pivoted between open and closed positions and has a slightly V-shaped base which when abutted against a mould or formwork, urges the recess former into the closed position.
优选地，成形器在打开位置和闭合位置之间枢转并且具有略微V形的基部，当V形的基部紧靠模具或模壳时促使凹部成形器处于闭合位置。
Preferably the former is pivoted between open and closed positions and has a slightly V-shaped base which when abutted against a mould or formwork, urges the recess former into the closed position.
应用推荐