弹簧钩，连接环，卸扣，华兰，卡头，秋千钩，圆环，S。
Snap hook, Quick link, Shackle, Tuenbuckle, Clip, Swing hook.
这优美，是展示女性设计的一个18英寸的锚链，随着弹簧钩环扣紧。
This graceful and feminine design is showcased on an 18-inch cable chain that fastens with a spring ring clasp.
也可使用一个弹簧钩将两绳连接在一起，钩子受力最少在2000KG。
This connection may also be done using a karabiner – with a breaking load of at least 2000 kg.
一些主要部位的铝弹簧钩必须每二年更换一次。由于长期使用，可能会导致结构损坏，从而导致隐患的出现。
The main aluminium karabiners must be replaced every two years. Impacts may create undetectable cracks that, because of the continuous loads, could result in structural damage.
设计了摆钩分型式、弹簧分型式、导柱定距式等双分型面模具的定距分型机构。
Given-distance parting mechanism in the mould with bi-parting surface was designed including pendulum-hooked parting, spring parting and given-distance leader parting.
通过采用斜导柱，弹簧等为动力实现了侧孔，卡钩等注塑件上的侧成型特征。
Through the use of ramp post, spring achieved to provide the side molding characteristics such as a side hole and a hook for driving force.
四钩柄扁平，必需保证在弹簧伸缩时始终保证钩尖朝上。
The four hook handles are flat, and the four hook handles are required to maintain the hook points to be upward when the spring stretches.
该弹簧夹可以以悬臂形式从基座处延伸并且包括玻璃保持钩，玻璃保持钩与该基座间隔开并且与保持孔接合。
The spring finger may extend in a cantilevered fashion from the base and include a barb spaced from the base and engaged with the retention hole.
内装式、单端面、单弹簧、非平衡型，带钩弹簧传动，弹簧旋向与轴旋向有关。
It is of built-in type, single seal face, single spring and unbalanced type with hook spring transmission, and the direction of rotation of spring depending on that of axis.
锁钩板、铰链和弹簧限位凸子均设置在装配弯折边的内侧面上。
The locking plate, the clasps and an elastic position-limiting convex are all provided on the inside of the curved line.
锁钩板、铰链和弹簧限位凸子均设置在装配弯折边的内侧面上。
The locking plate, the clasps and an elastic position-limiting convex are all provided on the inside of the curved line.
应用推荐