底涂的作用是极其重要的。
如果污迹依然很明显，则需再上一层底涂。
If the stain is still very evident, it would take to a layer of primer.
WK 8584作为助剂用于阳离子的预底涂和底涂中。
WK 8584 is used as auxiliaries in pre-bottom and base coat of cationic finishing.
对陶瓷，铝材，大理石等大多建材无需底涂均能产生好的粘接力。
It has good adhesion to most construction materials without primer, e. g. Marble, ceramic aluminium.
用在深色或黑色底涂的皮革上可获得明显的虹彩效果或金属效应。
When used in the finishing of black or dark color leathers, We can obvious obtain the rainbow or metal effect.
水性底涂层：选用荣扬水性底涂，搅拌均匀后，施工方式为滚涂。
Construction explanations of thin coating: primer coating: Rongyang primer coating is used and constructed by roll coating after even agitation.
HS 6428用于制作凸版和凹版印刷油墨、光油、涂料及底涂。
HS 6428 can be used as a vehicle for both flexo and gravure inks, overprint lacquers and primers.
在处理清洁、平整的砼表面，采用高压无气喷涂或辊涂，环氧封闭底涂料一道。
Use high voltage gas-free spraying or roller coat to deal with the cleanness and roughness of the surface. And paint a coat with epoxy closed primary coat paint.
用途：甲基三乙氧基硅烷是一种重要的有机硅偶联剂、交联剂、塑料硬涂层的底涂剂、憎水剂。
Application: It is an important crosslinking agent, coupling agent, water-repellent agents, mainly used in two-parts room temperature vulcanizing silicon rubber as a cross-linking agent.
研究了四种涂层材料粉末静电喷涂、悬浮液喷涂、悬浮液电泳底涂等涂装方法工艺对涂层质量的影响；
It is studied that powder electrostatic spray, suspend fluid spray, suspend fluid electrophoresis underside coat etc. technics influences on coat quality coated with above four anticorrosive material.
WR 9138可以直接喷涂在皮革上，也可用于底涂、顶涂及水性光亮剂等配方中，防水能力与其使用量成比例。
WR 9138 is used in the finishing after it is diluted with water. It can give good water-proof properties.
无需底涂或活化剂可直接粘合至各类不同表面如：不锈钢，铁，铝合金，铅，碳纤维，玻璃钢制品，PVC等几乎任何材质。
Generally No primer or Activators required for all kinds of bonding to substrates like stainless steel, steel, aluminium, lead, carbon fiber, fiberglass, glass, PVC etc.
涂适量在干净的皮肤上，早晚使用，可以用在妆底。
Apply to clean skin in the morning and evening. May be used under makeup.
涂层、涂覆底材、粘合剂、薄膜或片材的制备方法，由该方法获得的产品，以及用在该方法中的涂料混合物。
Process for the preparation of coating, coated substrate, adhesive, film or sheet, for the thus obtained products and the coating mixture to be used in the process.
具体介绍了涂前底材处理的磨料配套比、涂料配套体系和施工应用方法。
The abrasive subsidiary ratio, paint subsidiary system and applicating method of base coat treatment before painting are specifically introduced.
试验结果表明：加入附着力促进树脂的氟涂料对其综合性能基本上无影响，但可改善涂膜的耐水性和提高其对多种底材的附着力。
It was found that incorporation of adhesion promoters will not influence the other properties of fluorocarbon resin coating, and will improve the water resistance and adhesion on various substrates.
分别对材料选择、底材处理、底着色、涂一道底漆、涂二道底漆、面修色、涂面漆工艺进行了处理。
The coating procedure thereof is described in terms of the material selection, substrate treatment, stain primer, binding primer, surface primer, finishing and et al.
讨论并分析了不同单官能单体在光固化涂料应用中对涂膜的固化速率、硬度、对底材的附着力、以及抗蚀性等各项指标的影响。
This paper analyzes the influence of different single-function monomer for UV-curable coatings on curing rate, hardness, adhesion to substrate and corrosion resistance.
提出了将底胶涂于镍表面的涂胶新工艺。
A new process of rubber covering on the surface of nickel is given.
介绍了该涂料的原材料和制法，以及底材预处理方法。列举了涂料的性能指标和实涂鎏金文物的结果。也讨论了影响涂层性能的诸因素。
The raw materials, preparation, pretreatment of substrate, properties of the paint and the results were described, and factors that affect the film properties were discussed.
由上述组分混合制成的涂料由有机物构成，涂于金属底材上，其涂层耐化学品特性是耐高温下化学品的腐蚀。
Since the coating made from the mixed components consists of organic substances, when being coated on a metal substrate, the coating can resist the corrosion of chemical under high temperature.
将物料倒于基面，用橡胶刮板刮平，要求不得漏涂，使底料渗透于水泥基层中。
Pour the materials onto the base and use the rubber scratch board to make the surface flat and make the bottom materials permeate into the cement base. Do not leave some areas unpainted.
将物料倒于基面，用橡胶刮板刮平，要求不得漏涂，使底料渗透于水泥基层中。
Pour the materials onto the base and use the rubber scratch board to make the surface flat and make the bottom materials permeate into the cement base. Do not leave some areas unpainted.
应用推荐