平均功率是所做的功除以做功所需的时间。
The average power is the work performed divided by the time required for the performance.
膝屈伸肌的平均功率随测试速度增高而增加。
Conversely, the average power increased as testing velocity increased.
非线性折射率与泵浦平均功率的平方成正比。
Nonlinear refraction index change is proportional to square of mean pump power.
衰减系数平均功率随距离的延长而降低的比率。
Attenuation Coefficient The rate at which average power decreases with distance.
文中指出了非正弦平均功率的计量标准丞待建立。
It indicated that the test standard of nonsinusoidal average power must be set up urgently.
介绍了非正弦周期电流电路的平均功率测量原理。
The measurement principle of the average power for non sinusoidal period current circuit is introduced in this paper.
故平均功率为零。
针对于此，本文主要研究降低峰值平均功率比算法。
So this thesis studies the algorithms which reduce the PAPR.
那么你做功产生的，平均功率，是35000焦耳除以36000秒。
Then the average power that you have done, that you have generated, is 35,000 joules divided by 36,000 seconds.
你会产生160瓦的平均功率，比人体的热量还多，当然是在这两小时内。
You will have generated an average power of 160 watts more than the body heat during those two hours, of course.
采用了最大平均功率定时同步算法和最大似然载波相位估计算法。
The maximum mean power estimation timing recovery algorithm and the maximum-likelihood carrier phase estimation algorithm are employed.
文中报道了用于高平均功率板条状工作物质激光器的谐振腔设计。
The paper discusses resonator design of high average power solid-state slab geometry laser.
PLCCH符号在一个时隙上的平均功率将不能超过高层设置的限制。
The average power of transmitted PLCCH symbols over one timeslot shall not exceed the limits set by higher layers.
它的主要缺点是对频率同步比较敏感，并且峰值平均功率比（PAPR）过高。
Its main disadvantages are sensitivity to synchronization errors and high peak-to-average power ratio (PAPR).
计算结果表明这种用于高平均功率自由电子激光的注入器的设计方案是可行的。
Here we give the design proposal of a new DC-RF injector used in high average power FEL.
计算结果表明，这种热效应对激光输出平均功率与光束特性有不可忽视的影响。
The calculated results show that its effects on the average laser output power and beam quality are noticeable.
在相同的平均功率、峰值功率和脉宽比下，脉冲宽度是影响切缝宽度主要参数。
In the same of average power, peak power and duty cycle constant, pulse width is the primary parameter which affects the kerf width.
最后介绍了应用电子学研究所高平均功率片状及固体热容激光器研究的最新进展。
Finally the newest progress of high average power disk type laser and heat capacity solid-state laser achieved in Institute of Applied Electronics were introduced.
结果表明，当平均功率和脉冲宽度相同时，切缝宽度随着脉冲频率的增大而减小；
The results show that kerf width decreases with pulse frequency increases under the same average power and pulse width.
降低OFDM - CPM系统中的峰值平均功率比(PAPR)是关键技术之一。
One of the key techniques is to reduce the peak-to-average power ratio (PAPR) of the OFDM-CPM system.
功率计经常用于手机生产测试，因为它能快速的测量峰值功率，平均功率，峰均比。
Power meters are often considered for mobile-telephone production testing, because they can quickly measure peak power, average power, and peak-to-average ratio.
给定具体的数字调角形式，用这种方法可在计算机上计算所给信号的平均功率谱密度。
Giving concrete digital-modulated form, the mean power spectrum density of the signals discussed can be obtained in this way. The calculation can be done on computers.
多载波信号的峰值平均功率比远远大于单载波系统，而且峰平比随着子载波个数无限增长。
The ratio of peak and average power in multi carrier system is much larger than that in single carrier system, and may grow unboundedly as the number of subcarriers grows to infinity.
本研究着重分析了耦合系统设计和光纤参数设计等高平均功率光纤激光器的关键技术环节。
The designs of coupling system and fiber parameters were analyzed, which are the most important technique for high average power fiber lasers.
该算法首先计算序列的平均功率，然后对其进行谱分析并作平滑处理而完成伪码速率的判定。
This algorithm firstly calculates the average power serial, and then finishes the detection of PN code rate through the analysis of frequency spectrum and smooth processing.
改变滤波器电阻阻值，研究滤波器上平均功率损耗、峰值功率损耗与滤波器电阻阻值的关系。
Changing the resistance of filter, it studies the connection of the average power and peak power loss with filter resistance.
定性分析结果表明高平均功率重频脉冲激光更容易对星载探测器造成有效干扰和永久性损伤。
The feasibility of high average repetitive pulse laser disturbance and damage satellite-borne detector is qualitatively analyzed.
据报道疲劳时肌纤维动作电位传导速度(MCV)和肌电图平均功率频率(MPF)均有下降。
The decrease in muscle fibre action potential conduction velocity (MCV) and electromyographic mean power frequency (MPF) has been reported by many researchers.
试验建立起了凹坑深度与脉冲功率密度、激光平均功率、脉冲重复频率和离焦量之间的关系曲线。
Crater depth versus pulse power density, average laser power, pulse repetition frequency and focal distances are built up through experiment.
第一阶段将制造出具有200毫瓦平均功率同时具有4%插接效率的热电制冷激光器，并将其封装为1瓦的模块。
Phase I calls for making a 200 mW average power, thermoelectrically cooled laser with at least 4 percent wall-plug efficiency (WPE), and planning for combining those into a 1-watt module.
应用推荐