结果成纤维细胞和对照组细胞生长良好，而实验孔的各组癌细胞逐渐减少，出现融合、裂解。
Results Fibroblast cells and control group cells grew well, whereas the growth of tumour cells in experimental groups reduced gradually, and cells fusion and lysis appeared.
然而在科学园的另一头的另外一个实验室中，研究者致力于将数千个纳米孔整合在一个整体中，以便能在一天内获取整组的基因编码。
So, in another laboratory on the other side of the science park, its researchers are working on ways of integrating the thousands of nanopores needed to read a genome in a day.
为了进一步确认这一实验结果，研究人员在孔附近充满氨溶液的培养基种培养细菌菌落，发现了同样的粘液梯度。
To further confirm their results, the researchers grew bacterial colonies near wells filled with a solution of ammonia and found the same slime gradient.
海军研究实验室空间科学部辐射检测小组正在研发基于孔或沟槽阵列半导体的新型辐射探测器。
The Radiation Detection Section in NRL's Space Science Division is developing novel radiation detectors based on hole- or trench-arrays in semiconductors.
其他实验室已经试验过类似的纳米孔测序方法，但研究人员发现，很难控制DNA链穿过纳米孔的速度。
Other labs have experimented with similar nanopore-based approaches to sequencing but have found it difficult to control how quickly the DNA strand feeds through the nanoscale hole.
研究者们在实验室里将一些蚊子感染了西尼罗河病毒、罗斯河病毒以及基孔肯雅病毒。
The researchers infected mosquitoes in the lab with West Nile, Ross River or chikungunya viruses.
实验结果表明，NKA-9型大孔吸附树脂对白藜芦醇的吸附、解吸性能较好。
The experiment results show that a resin type of NKA-9 is better in adsorption and desorption to resveratrol.
实验结果表明，偏心不耦合装药在孔壁上形成明显的偏心应力场。
It showed that eccentric pressure is produced by eccentric decouple charge blasting on borehole wall.
著名的杨氏实验最初是用双孔，就像两个相干点源一样。
In Young's famous original experiment there were two pinholes, something like two coherent point sources.
由于没有狭缝孔内该反应的实验数据，因此比较了用经典热力学预测与RCMC方法得到的主体相平衡组成。
Because of no experiments reported for the reaction in slit pores, the chemical equilibrium compositions in bulk phase from RCMC method are compared with those from classic thermodynamic prediction.
实验结果表明，通孔泡沫铝有明显应变率效应，随应变率上升，泡沫铝流动应力提高。
Experimental results show that the flow stresses of the aluminum foams increase with increasing strain rate, demonstrating a distinct strain rate effect in the open-cell aluminum foams.
自行研制的低熔点合金型芯，经压铸实验，铸件孔成形完好。
The paper developed low-melting-Point alloy cores, through die casting experiment, the cores hole deformed well.
工业实验结果比小试结果更佳，制得了泡孔密度均匀、柔软、弹性好的海绵背衬地毯。
Commercial experiment had better results than that of bench test. Soft sponge back-lining carpet with symmetrical bubble hole density and high elasticity carpet was produced.
实验结果表明，采用有机成孔剂AUM和无机成孔剂活性炭混合使用效果好；
The experimental results showed that better effect was obtained by adding the mixtures of organic AUM and active carbon.
实验以WC- 70潜孔锤为对象，研究泡沫对风动潜孔锤的影响。
This experiment based on WC-70 DTH hammer, study the influence of foam on the DTH hammer.
实验结果表明，用本文公式计算孔槽型平膜片的爆破压力，完全符合工程要求。
Experiments showed that the bursting pressure of hole-slot flat rupture discs calculated by the formula well met the requirements of engineering.
实验表明，测量系统可快速、精确地测量工件孔心距。
Measurement results and precision analysis indicate that workpiece hole heart distance can be fast and accurately obtained with the method.
这些实验包括带孔板件的拉伸实验、板件的振动实验、板件的转动实验。
These experiments include tension experiment of a plate with a hole, vibration and turn experiment.
实验结果表明，冷却孔射流下游附近存在明显的尾迹区域。
The test results show that there exists an evident wake zone near the downstream of the cooling hole jet-flow.
本文通过理论分析了压力容器封头超标大开孔的可行性及安全性，并用实验手段验证了这种结构的安全可靠性。
The feasibility and safety of over code openings of pressure vessel covers were proposed through theoretical analyses, and the reliability of the structure was verified by using experiments.
通过分析振动切削的机理，提出选择深孔超声振动切削参数的方法，并通过实验数据加以验证。
Through analyzing the principle of vibratory cutting, the methods of choosing parameters for ultrasonic drilling of deep holes are presented and proved by experimental method.
采用正交实验研究了阳极氧化时温度、时间、电压对氧化铝膜厚度、孔径和孔有序度的影响。
The influences of temperature, time and voltage on the thickness of oxidation film, aperture and order degree during anodic oxidation were studied by orthogonal test.
论文通过正交实验分析和电镜照片分析，讨论了实验工艺参数对样品孔结构的影响。
Through the experiments and SEM analysis, the effect of processing parameters on porous structure was studied.
实验结果表明，与均匀开孔的波纹塔板相比，这种新型波纹塔板的板效率有较明显的提高。
The results showed that the tray efficiency of the ripple tray was raised more than homogeneous perforated ripple tray.
实验还研究了温度对连接孔静挤压强度和疲劳寿命的影响。
The testing program also was performed to study the effect of temperature and the fatigue life.
实验还研究了温度对连接孔静挤压强度和疲劳寿命的影响。
The testing program also was performed to study the effect of temperature and the fatigue life.
应用推荐