发电机、电动机定子线圈温度测量。
对关键部件定子线圈进行了设计计算。
不论哪种情况，均需更换定子线圈和屏蔽套。
No matter what the situation would require the replacement of sets of stator windings and shielding.
介绍了一种新的检查水冷定子线圈堵塞的方法。
A new plugging test method for water cooled stator coil was described in this paper.
适用定子线圈，变压器线圈需排线的线圈绕制。
Be suitable for coil winding of stator winding and transformer winding which need wire arrangement.
在这一点上，我有线所有定子线圈每半年到系列。
At this point I wired all the coils on each stator half into series.
示教是为定子线圈包扎绝缘带过程中关键的环节。
Teaching is a crucial step in the process of insulating generator stator′s bars with insulating tape.
介绍了一种汽车起动机定子线圈整体绝缘处理的新工艺。
A new technology of whole body insulation treatment of automobile initiating motor stator coil has been developed.
电动机定子线圈通上电源，电动机转子就和锭杆一起转动。
When the motor stator coil is electrified, the motor rotor rotates together with the spindle blade.
用于线圈包扎，马达定子线圈覆盖，及电源变压线圈包扎。
Used for loop packing, motor stator loop covering, and power resource transforming loop packing.
电动机定子线圈连通电源，电动机转子就和锭杆一起转动。
When the stator coil of the motor is communicated with an electrical source, the rotor of the motor rotates with the spindle rod.
介绍了GE390 H燃气轮发电机定子线圈的制造工艺研究。
This paper introduced the stator coil manufacturing technology of GE390H gas turbine generator.
将旋转变压器固定在电机内部定子线圈端部的下面，旋转变压器的引出线在后部。
A rotary transformer is fixed below the end part of a stator coil in the motor, and an outgoing line of the rotary transformer is arranged at the rear part.
本文从电机的基本定子线圈及笼型转子的基本回路出发，研究了其数学模型的建立。
Therefore, the model development in this paper starts from a consideration of basic stator coil and the basic loop that constitutes the rotor winding.
现代的感应电动机一般是定三个(或更多)定子线圈，每个定子线圈单独通以交流电流。
Modern AC induction motors usually have three (or more) sets of stator windings, which smooths things out and allows more torque to be generated.
本文对以环氧粉云母带为主绝缘的高压定子线圈，经低温真空处理的后果进行了探讨和分析。
This paper discusses and analyzes any efficiency through vacuum treating at the moderate temperature on the stator coils insulated with epoxy micapaper tape of H. V. electrical machine.
实验结果证实，基于相关分析得到的谱特征可以作为感应电机定子线圈短路故障诊断的依据。
Experimental results demonstrated that the spectrum characteristics based on coherence analysis can be used to diagnose the stator winding inter-turn faults of induction motors.
本标准适用于交流发电机、同步调相机和交流电动机定子线圈及绕组绝缘交、直流耐电压试验。
The standard is applicable to stator coil and winding insulation alternative and direct current voltage withstanding test for AC generator, synchronous phase modifier and AC motor.
针对该问题，分析了泄漏的原因，并采用气、水共振法对发电机定子线圈进行冲洗，取得了较好的效果。
In order to solve the problem, the reasons for the leakage are analyzed in the paper, and the gas-water resonance method is adopted to wash the generator stator coil. Good results have been achieved.
本文从定子线圈所受到的作用力，电晕和环流等方面分析了对定子线圈的危害，并提出综合性防止措施。
This paper analyzes harm of force, corona and circular current on the stator coil. And a synthetical measure is presented.
在分析了定子线圈电路特征和系统运动特性后，建立了多级电磁发射系统模型，并由此导出了系统方程。
After analyzing the characteristic of driving coil circuit and kinematics, the system model of multi-staged electromagnetic launcher is built and equation-solution is derived.
采用有限单元法，编制了适用于微机系统的槽部电场计算专用软件，计算了大型发电机定子线圈槽部电场的分布。
The special microcomputer software for calculation of slot electric field is worked out with fe method, and the field distribution in stator slot winding of large generator is calculated.
由于环境恶劣及电流过载，造成了电机内部起火烧损了定子线圈和转子过热变形及轴承损坏等情况造成电机无法使用。
The firing inside the motor that caused by bad environment and current overload made the stator coils overburned, overheated rotor deformed and bearing damaged, which led to the motor out of service.
汽车用交流发电机的皮带轮、定子线圈、整流器的故障率相对较高，本文给出了其故障的处理对策，以延长其使用寿命。
The belt sheave, stator winding and rectifier of the vehicle alternator have a rather higher breakdown rate. Therefore, this paper gave out their solutions to extend the alternator life.
通过在地面定子线圈中注入高次谐波电流和在列车的磁极上加绕一组直线发电机线圈，实现磁悬浮列车在低速运行时车载蓄电池的充足供电。
It is realized by adding a high frequency current to the original current of the stator and adding linear generator windings to magnetic pole.
与并在非铁磁材料槽(90)槽口处设置了定子槽楔(70)以便固定定子线圈(60)，定子铁芯(40)和转子铁芯(10)之间为气隙。
Meanwhile, a stator slot wedge 70 is arranged in the non ferromagnetic material slot 90 opening to fix the stator coil 60, air gap is provided between the stator core 40 and the stator core 10.
本文介绍了空冷135MW汽轮发电机定子线圈的成型及封焊模具的设计。通过对线圈自身成型模的改进，可以同时在成型模上进行引线封焊。
This paper introduces the design of the mould for shaping and sealing braze of copper bars used in stator coils of 135mw aircooled turbogenerator.
为解决发电机定子线圈槽的异常升温现象，利用扫描电子显微镜、能谱仪等现代分析手段对300MW发电机定冷水系统不明异物进行了表征和分析。
To solve the problem of abnormal temperature rise of generator stator slots, unknown foreign powder in the 300MW generator stator water cooling system was characterized and analyzed by SEM and EDS.
为解决发电机定子线圈槽的异常升温现象，利用扫描电子显微镜、能谱仪等现代分析手段对300MW发电机定冷水系统不明异物进行了表征和分析。
To solve the problem of abnormal temperature rise of generator stator slots, unknown foreign powder in the 300MW generator stator water cooling system was characterized and analyzed by SEM and EDS.
应用推荐