多路驱动程序并不都是一样的：有些可以处理更智能的负载均衡，有些只能处理故障转移。
Multipath drivers are not made equal: some are able to handle more intelligent load balancing, while others can handle only failover.
多路径软件层可以使用冗余路径交付性能增强，比如动态负载平衡、传输监控、自动路径管理和动态重配置。
Multipath software layers can use redundant paths to deliver performance enhancements such as as dynamic load balancing, traffic shaping, automatic path management, and dynamic reconfiguration.
注意，负载平衡功能可用于一些这样的多路径驱动器，使用多个HBA时，这样的驱动器能够提高流量。
Note that load balancing is available for some such multipath drivers that would increase the throughput when multiple HBAs are used.
许多路面十分狭窄，卡车和重型负载都不能通过。
Many of the road surfaces were not paved properly and were too narrow for trucks with heavy loads.
通过对电液比例多路阀进行负载敏感控制，实现泵和负载之间的功率匹配，显著提高系统效率。
Electro-hydraulic proportional sectional valves are realized with load sensing control, and the pump output power is adaptive to load, the system effectiveness is highly enhanced.
仪器具有整机功耗低、能同时通断多路大负载的特点。
The device has not only small energy losing, but also opening or closing multiple road loads at same time.
其多路径负载平衡能力能够有效缓解网络中的负载不平衡状况，提高网络带宽，降低网络延迟。
It can balance the load on the network across multiple paths when the traffic pattern is unbalanced which will improve network bandwidth and decrease network delay.
总线控制协议是高速多路串行数据总线的关键，它决定了多路串行数据总线的实时响应能力以及在高负载和低负载情况下的串行数据总线的特性。
Bus control protocol is the key or high rate multiplex data bus. The capacity of real—time responseness of multiplex data bus and properties in high and low load are decided by the protocol.
其次它支持多网关与多路由的通信方式从而能够提供更好的切换功能和负载平衡机制；
The rest of this Paper is about the Gateway selection algorism, which we called it "MG-MMS", can efficiently provide load balancing capacity.
本文介绍了协同学理论，并提出了多路径负载预测基于最大熵原理的自动协调的方法。
This paper introduces synergetic theory and proposes multi-path load forecasting automatically coordinated approach based on the maximum entropy principle.
分析了实现均衡路由的功能模型和算法，重点研究了LDM(多路径负载分配)算法。
This paper analyzes the functional model and algorithms used for proportional routing. (Among) proportional routing algorithms, we focus on LDM (load distribution over multi-path) algorithm.
该模型考虑到多路径的数目、路由的选取方法以及网络中节点的密度等条件，能够对不同网络条件下的负载进行较好的分析与理论计算。
This model took the number of paths, the way of route selecting and the density of the network nodes into account and could analyse or compute the load in different network conditions.
该模型考虑到多路径的数目、路由的选取方法以及网络中节点的密度等条件，能够对不同网络条件下的负载进行较好的分析与理论计算。
This model took the number of paths, the way of route selecting and the density of the network nodes into account and could analyse or compute the load in different network conditions.
应用推荐