所设计的多变量内模控制器能使系统稳定解耦，所得到的闭环系统根据开环系统时滞来描述。
All the stabilizing IMC controllers and the resulted closed-loop systems were characterized in terms of the open-loop system's time delays.
本文讨论了存在未知扰动情况下如何设计双线性多变量系统的观测器问题。
The problem of designing an observer for bilinear multivariable systems in the presence of unknown disturbances is considered.
实际的生产运行证明，该系统设计合理，运行稳定可靠，基本实现了干法脱硫过程中的多变量连续过程控制要求。
The practical running results show that this system is designed reasonably and satisfies the requirement of the multi-variables continuous process control in the CFB-FGD.
如果将被动式电液力控制系统看作多变量系统，可以设计解耦调节器抑制系统中多余力。
Taking it as a multivariable control system, the additional operating force can be constrained by a decoupling regulator.
文章针对单元机组负荷控制的特点，采用最优预见控制（OPC）策略设计了基于多变量预见控制原理的单元机组负荷最优预见控制系统，并讨论了预见步数对控制品质的影响。
This paper designed a multivariable load Optical Preview Control (OPC) system for a thermal power unit, and discussed the effect of preview step number on control performance of the load OPC system.
本文讨论了用逆奈氏阵列法对一类非方阵多变量系统进行解耦设计。
In this Paper, decoupling design for non-square multivariable systems using inverse Nyquist array (INA) method is discussed.
本文讨论了多变量系统的解耦问题，给出了一种简便的解耦补偿矩阵的设计方法。
This paper deals with the decoupling of multivariable control systems and presents a simple method to design dynamic compensator matrix.
针对多变量强耦合的被控系统，提出了一种简化的内模解耦控制设计方法。
In view of strong coupling system, a kind of simple internal model decoupling control designing method is presented.
在概率描述框架下，针对含有参数摄动的线性多变量系统，提出一种新的鲁棒LQ优化设计方法。
A new approach to robust LQ optimization design for linear multivariable systems with parametric uncertainties is presented within probabilistic framework.
最后，设计了以多变量内模控制器作为局部模型控制器的模糊多模型协调控制系统。
At last, the fuzzy multi-model coordinated control system which USES multi-variable inner model controller as the local controller has been designed.
具有不可测输入的多变量线性系统状态观测器的设计方法有判定法和建模法。
It is well known, the design methods of an observer for linear multivariable systems are decision method and modeling method.
在工艺设计和工艺调整时不能孤立片面地考虑某个因素，而应采取多变量分析方法，力图使整个系统优化，从而减轻内裂现象的出现。
So we shall take every factor into consideration and take multi-variable analytical methodology to optimize the whole system in order to prevent the internal crack.
本文介绍了一种简化方法，供设计多变量控制系统时计算补偿传递矩阵及补偿网络之用。
This paper presents a simplified approach to evaluation of compensation transfer matrix and compensation network for designing multivariable control system.
为保证闭环控制系统的鲁棒性，设计了基于交流电机的矢量变换模型的多变量解耦控制器。
To ensure the system robustness, a multi-variable decoupling controller was designed based on the vector transform model of AC motor.
最后，针对工业过程中常见的多变量多时滞输入输出系统，提出了一种双内模解耦控制器矩阵的设计方法。
At last, a decoupling dual internal model controller matrix design method is proposed for multi-variable time-delay input-output system in industrial processes.
此系统利用了回归正交设计方法，可进行多变量变化的各种模拟试验；
This system utilizes the regression-orthogonal method, so it can be used for the multivariable simulation test.
本文的主要工作是模型仿真、系统的耦合性分析、多变量pid解耦控制器设计及多变量预测控制器设计。
The main focuses of this thesis are model simulation, coupling analyses, decoupling PID controller design and multivariable predictive controller design based on wastewater treatment Benchmark.
针对多变量饱和线性系统的时变参考输入跟踪问题，研究了一种组合非线性输出反馈控制器的设计方法。
A new composite nonlinear output feedback controller is proposed to track the time-varying reference inputs for multivariable linear systems with input saturation.
本文回顾了结构不确定性线性多变量系统鲁棒控制的分析与设计中，过去与近来对系统稳定鲁棒和性能优化方面的进展。
This paper reviews past and recent contributions to stability robustness and optimal performance in analysis and design for linear multivariable structured uncertain systems.
在系统设计中，窑炉烧成系统作为一个多变量耦合的非线性系统，是控制的难点。
In system design, firing system of kiln is a multi-variant coupling non-linear system, which is the difficulty of system control.
本文主要研究时滞多变量系统的内模控制方法的设计，以期找到简单、有效、实用的方法。
This paper mainly studies internal model control designed for the multivariable time-delay system in order to find simple, effective and practical method.
针对实际多变量强耦合非线性温控系统，设计了基于PC104嵌入式系统的拟人智能温度控制系统。
Simulating Human Intelligent Controller based on PC104 system is presented for a nonlinear temperature control system, which is multivariable and strongly coupling.
定量反馈理论（QFT）是一种设计具有不确定性的多变量控制系统的直接而有效的方法。
The quantitative feedback theory (QFT) is a direct and powerful design method for multivariable control systems with plant uncertainties.
基于多变量控制系统理论，本文提出了火电厂中间储仓式制粉系统的一种解耦控制设计方法。
Based on the general theory of multivariable process control systems, this paper proposed a new design technique of decoupling control for storage pulverized-coal systems in the power plant.
针对多变量非线性离散时间系统设计多模型神经网络解耦控制器。
A multiple models neural network decoupling controller is designed to control the multivariable nonlinear discrete time system.
为解决双转子涡喷发动机多变量系统的控制问题，采用了输入变换和状态反馈的方法，并对解耦后的系统设计了伺服跟踪控制器。
The input transform and state feedback are used for multivariable control system, and the integral servo tracking controller is designed for the decoupled systeins.
本文介绍了线性多变量系统分段设计方法——即将多变量系统按高频段和低频段分别设计出相应的子控制器。
A design method for Linear multivariable systems of high and low frequency region is introduced in this dissertation.
提出了逻辑函数“系统简化法”的计算机辅助设计方法，从而实现了对多变量逻辑函数的自动简化。
CAD method by using logical function as systematical simplication methods is proposed. The simplication of multivariable logic function is obtained automatically.
针对多变量不确定线性系统，提出了一种新型的输出反馈变结构调节器的设计方案。
We propose a direct output feedback variable structure control to stabilize the uncertain system whose states are not available and can not be estimated.
本文将多变量频域法与大系统理论相结合，提出了一种大系统分散镇定的频率设计方法。
Combining the multivariable frequency domain technique with the large-scale-systems theory, this paper presents a new method for decentralized stabilization of large scale systems.
应用推荐