用于电子器件的外部绝缘和线圈的末端。
Using for end of coil and outer insulation of electric component.
将热水器上的入口面板拆卸下来，把温度控制器的外部绝缘层拿下来。
Remove the access panels or front panel on table tops, fold the insulation outward away from the controls.
而且，这种热收缩套管的用途，可应用来包覆各种导体和作为各种导体的外部绝缘包覆。
This kind of heat shrinking sleeve can be used as the coats and insulating coats of all kind of conductors.
Cor的外部构局确保结构完整，配备绝缘热式质量器和环保的辅助设备。
Plus, the exoskeleton provides thermal mass for insulation and other eco-friendly assistance .
它的外部由etfe氟塑料覆盖，这层氟塑料即构成内部结构又作为内部的绝缘层。
The exterior is covered in ETFE cushions, which provides both structure and insulation for the interior.
为了御寒，内部和外部的木墙之间都填充了一层绝缘材料，它们是由人们缝在被子里的碎海草做成。
To help keep out the cold, the space between the inner and outer wooden walls of the hut were stuffed with an insulating layer made of shredded seaweed sewn into quilting.
特别在外部环境中，太阳能连接软管的绝缘层可有效地降低水循环时的能量和热量的损失。
Especially in external environments, preferring hoses with insulating prevents energy and heat losses which are exteremely important for the whole system.
外部的分流电阻，例如：漏电的电缆和肮脏的绝缘子也可能引起负载误差。
External shunt resistances, such as leaky cables and dirty insulators, may also cause loading errors.
因此通过何种方法解决，使介质损耗因素值能不受或少受外部原因的干扰，从而较准确的实时反映设备绝缘状态就显得尤为重要。
Therefore, it's very important to find out how to avoid or reduce the external interfering to the data of dielectric lose factor, then help us to get the accurate status of equipment insulation.
鉴于单层绝缘结构，本电缆不能用做外部设备的电源连接线（不作为拖链电缆使用）。
For the monolayer insulation construction, the cable can not be used in external equipments(not works as tray cables).
对国内外部分高压交联聚乙烯(XLPE)电缆系统的绝缘损坏作了统计，分析了电缆及其附件绝缘老化原因和形态，叙述了XLPE电缆绝缘老化的机理。
With the statistics on insulation damages of some HV XLPE cable systems at home and abroad, the causes, modes and mechanisms of insulation ageing of XLPE cables and their accessories are analyzed.
该法对电缆绝缘接头处VHF和UHF信号的时域和频域分析可有效地识别被测电缆绝缘接头部内、外部的局放信号。
This method analyzes VHF and UHF signal of detected cable joint, using time and frequency analysis. This method can be used for detecting PD pulse inside or outside the insulating joint.
该法对电缆绝缘接头处VHF和UHF信号的时域和频域分析可有效地识别被测电缆绝缘接头部内、外部的局放信号。
This method analyzes VHF and UHF signal of detected cable joint, using time and frequency analysis. This method can be used for detecting PD pulse inside or outside the insulating joint.
应用推荐