也可以使用托管在Azure之外的外部定时器,但是这会导致可靠性的问题。
External timers hosted outside Azure could be used, but this leads to reliability issues.
以工程实例为基础,对使用外部定时器时给P LC系统带来的时间竞争问题进行分析,并提出解决措施。
Based on instances, the paper analyses the time conflict of PLC system caused by exterior timer, and provides the solution to the problem.
只在使用非静态的服务绑定时使用这两个lob;可选伙伴链接,代表到外部服务的连接。
Both LOBs are used only if a non-static binding of services is used; optional Partner links, which represent connections to external services.
介绍了由单片机控制的可控硅电路,该电路运用外部中断获得同步信号,用定时器做导通角控制,并给出实用程。
The controllable silicon circuit controlled by monolithic microcomputer is introduced, which adopts external interrupt to obtain sync signals and controls conducting angel with a timer.
本文详细讨论了实时数据的各种定时特征,包括数据的外部有效期、相互一致性、采样同步性、数据截止期等;
This paper discusses all kinds of timing characteristics about real time data including external validity interval, mutual validity interval, sampling simultaneous interval, data deadline etc.
这类应用必须及时响应外部事件,在规定时间内完成分布信息处理,并实时激励分布执行机构。
This kind of application must respond to external event in time, finish the process of distributed information, and activate the distributed execution mechanisms in real time.
引风机应定时清理风机内部及外部,风扇的空气通路,除去表面灰尘。
The induced draft fan should be regularly cleaned internally and externally. The dust should be removed from the surface of the fan for clear passage of the air.
它负责继电保护程序的执行,各定时功能的保持,以及与外部设备的通讯。
It is responsible for the execution of relaying programs, maintenance of various timing functions, and communicating with its peripheral equipment.
DMA可以被外部(INT3 - 0)、内部的(片内定时器和串口)中断触发运行,传输完成后可以向CPU发出中断请求。
DMA can run constantly or can be triggered by exterior interruption (INT3-0), interior interruption (timer and serial port), at the end of transfers, send interruption signal to CPU.
一般情况下,这两种定时器是步调一致的。外部信号常常调节人体时钟命使之达到更为便利的24小时周期。
Normally the two timers are in step, and the external cues tend to regularise the internal clocks to the more convenient 24 hour period.
将该数据作为定时器的时间常数,可实现定时器时间常数的外部输入。
Taking the data as the time constant of timer, its external input can be realized.
调整内部极限和扳机电压可以修正定时器的操作,扳机电压是通过将外部电压(或电流)应用于CONT来实现的。
The operation of the timer can be modified by modulating the internal threshold and trigger voltages, which is accomplished by applying an external voltage (or current) to CONT.
低功耗定时可以运行在以LSE,LSI或外部时钟驱动的情况下,包括停止模式。
The low-power timer has an independentclock and is running also in Stop mode if it is clocked by LSE, LSI or anexternal clock.
使用时需要一个外部认证定时器提供相应的时间。
An external approved timer is required to provide the purge time.
结果表明:依赖外部资本和技术可能获得一定时期的经济增长,却无法获得经济持续增长所需要的增长能力。
The result shows that external capital and technologies can bring about the economic growth for some time but without sustainable growth drive.
介绍了一种对定时器、计数器、数据寄存器的数据进行外部设定并显示的电路,并给出了相应的梯形图程序。
This paper introduces a circuit setting up and displaying the data of timer, counter and data register out of PLC. It gives the ladder-type Patterned program.
港口通过能力是港口企业在外部环境条件一定时的生产能力,在港口生产管理中有着非常重要的作用。
Port capacity is the production capacity of port enterprise under constant exotic environment, and plays a significant role in production control.
单片机与CPLD共用外部RAM,采用中断和软件定时策略解决了访问冲突问题。
Visiting conflict that MCU and CPLD visit the same RAM in same time can be avoided by applying interruption and software timing strategy.
将其数值按二进制数在P 1口驱动LED灯上显示出来。2、外部事件计数脉冲由P 3.4引入定时器t0。
Its value according to the binary number displayed on the P1 mouth drive leds. 2, external event count pulse introduced by P3.4 T0 timer.
将其数值按二进制数在P 1口驱动LED灯上显示出来。2、外部事件计数脉冲由P 3.4引入定时器t0。
Its value according to the binary number displayed on the P1 mouth drive leds. 2, external event count pulse introduced by P3.4 T0 timer.
应用推荐