设计并实现了基于ADSP21060的通用高速实时数字信号处理系统，并以随机脉位调制与随机二相码调相复合脉冲串信号处理为例，给出了软硬件设计方法。
We design and implement a generic high-speed real-time digital signal processing system using ADSP21060 processors, and introduce software and hardware design methods for the CPS signals.
斯科尔斯和他的研究小组利用激光脉冲模拟太阳光的吸收，研究了海藻的聚光蛋白复合物。
Scholes and his team studied the light-harvesting protein complexes within algae by using laser pulses to mimic absorption of sunlight.
采用ANSYS软件对脉冲发动机复合壳体进行了优化设计研究。
Optimum design of the composite shell of pulse motor has been presented using ANSYS soft ware.
介绍了制备纳米镀层的电沉积方法，主要有直流电沉积、脉冲电沉积和复合共沉积。
The electrodepositing method for the preparation of nano-deposit was introduced, including direct current electrodeposition, pulse electrodeposition and composite electrodeposition.
本文研究了一种新型混沌编码的脉冲位置和相位复合调制的脉冲压缩雷达信号。
In this paper, a new Chaotic Pulse Position and Phase Coded Pulse Compression Radar (CPPPC PCR) signal is studied.
同时本文还对超声波—脉冲电流电化学复合抛光进行了试验探索。
This paper also tried to do some experiments of combined ultrasonic electrochemical polishing.
研究了两种分离式射孔脉冲压裂复合弹。
Two kind of separated perforating and pulse fracturing composite charges are studied.
从作用情况的对比看，液电效应声脉冲优于超声波，复合场的效果优于单一场。
Comparison of the physical fields show that the effect of liquid puncture acoustic pulse is better than the ultrasonic effect and complex fields are better than single one.
针对具有侧向脉冲推力和气动力复合控制的动能拦截弹，需要解决姿控发动机的组合点火问题。
To the kinetic interceptor with lateral impulse thrust and aerodynamic force, it is required to solve the problem of combined fire of motors for attitude control.
结果证明这种复合探测系统具有很好的脉冲压缩性能、距离截止特性及其它雷达信号不可替代的优越性。
Research results show that the combined detecting system possesses fine pulse compression performance, range cut-off characteristic and the superiority which other radar signals are not provided with.
结果表明：脉冲复合镀层的抗高温氧化性比直流复合镀层优异；
The oxidation resistance of pulse composite coating was better than that of direct current composite coating.
介绍了使用低浓度复合电解液，锻模的脉冲电流电解加工的设备及加工实例。
This is a introduction to the Pulse Current electrolytic machining of forging die equipment using low density compound electrolyte, and examples are also given.
本文最后部分对输出光脉冲的模式稳定性也做了研究，研究和分析了能够实现单模输出的典型复合腔结构及具体的选模方法。
The final part of the paper we analyzed the stability of the mode of the output optical pulse, as well as the mode's selection the design of complex cavity for realizing single mode.
在多个短脉冲驱动时，除了与严重过电离的复合等离子体有关的实验外。理论模拟与实验也基本符合。
And in the case of multiple-pulse, theoretical simulations are also consistent with experiments except the experiments with seriously over-ionized recombination plasmas.
信标信号为线性调频信号和脉冲编码信号的复合信号，其中脉冲编码信号用来表征发射信号序号。
The beacon signal is the reunite signal of linear FM signal and pulse code signal, and the pulse code signal is used as a token of emit signal.
本论文研究的复合封装材料以双酚A型环氧树脂EP828／E51作为基体，以氧化铝作为填充材料，有望替代纯环氧固化物作为脉冲压电电源用新型封装材料。
The encapsulate composite for pulsed piezoelectric power supplier was investigated in this paper, in which a bisphenol A liquid epoxy EP828/E51 was resin matrix and aluminum oxide was filler.
结果表明，脉冲电镀能获得晶粒度细小、致密、光亮、均匀且高硬度的复合镀层。
The results show that the pulse plating can gain a compact, bright and uniform composite coating with fine grain and high h...
对复合自身预热烧嘴、脉冲燃烧控制技术进行了重点介绍。
The dual self-preheating burner and pulse burn control technology are emphatically introduced.
铝塑复合管产品质量直接受塑料挤出机、模具、交流脉冲氩孤焊机、牵引机等设备的机械性能及原材料质量的影响。
The quality of aluminum_plastic composite tube is affected by plastic extrude machine, mode, welding machine of TIG AC/DC, traction engine etc. and also affected by raw material.
由于再强化效应的作用，经过热处理后的纳米复合电铸层，尤其是由脉冲电沉积所得纳米复合电铸层，其显微硬度的提高程度尤为明显。
The micro-hardness of heat treated nano-composite electroforming deposits prepared under pulse current is markedly increased owing to the re-strengthening effect.
光电导开关的超快特性主要由触发光脉冲脉宽和开关芯片材料载流子复合寿命决定。
The main results obtained are as follows:1. The ultra-fast characteristics of photoconductive switches were mainly determined by the optical pulse width and the carrier lifetime of the chip material.
室内试验表明：利用脉冲电镀法制造复合片及其钻头是可行的，使用结果比较理想。
Lab tests show that it is feasible to use the Pulse ElectroplatingMethod to manufacture PDCs and PDC bits. The application results are fairly ideal.
实验表明，采用非线性放大复合环形镜构成复合腔光纤激光器，有可能获得高重复频率的锁模脉冲。
It is suggested that using a NACLM as a passive mode locking element, generation of ultrashort pulses of very high repetition rate is promising with a fiber laser.
分别给出了固化剂、分散方法、偶联剂对复合材料闪络特性的影响和纯环氧表面抛光前后的脉冲真空闪络特性。
The effects of coupling agent, dispersion method, curing agent, and surface roughness on the flashover properties are investigated respectively.
分别给出了固化剂、分散方法、偶联剂对复合材料闪络特性的影响和纯环氧表面抛光前后的脉冲真空闪络特性。
The effects of coupling agent, dispersion method, curing agent, and surface roughness on the flashover properties are investigated respectively.
应用推荐