并总结了壁面温度对放电的影响规律。
And summed up the impact on discharging by the wall temperature regularity.
在实测基础上，对壁面温度波动及瞬时热流量进行了分析。
Based on the experimental results, the undulation of wall surface temperature and instantaneous heat flux are analysed.
交叉肋通道壁面温度沿流体流向的梯度要比平行肋通道的小。
The stream wise wall temperature gradient for the crossed rib one is lower than that for the parallel rib one.
实验结果分析发现，随着壁面温度的升高，推力器的性能下降。
It is found, from analysis of experimental result, that thruster performance declines along with wall temperature arise.
讨论了壁面热流、壁面温度及流动阻力对无因次熵产强度的影响。
The effects of the heat flux, wall temperature and flow resistance on the nondimensional entropy generation density have been discussed.
壁面温度用热电偶测量，温度控制仪显示，数据板卡采集温度信号。
Wall temperature is measured by thermocouples, instrument displays temperature, and data is collected by data card.
气缸盖各缸燃烧室壁面温度分布不同，其中三缸燃烧室壁面温度较低。
Differential distribution of wall temperature in combustion chamber is founded in cylinders, and the lowest wall temperature is in cylinder No.
壁面温度仅对出口平均温度的影响较大，对火焰最高温度的影响较小。
The wall temperature has remarkable effect on the averaged exit temperature, whereas, it has small effect on the maximum combustion temperature.
考察流体流速、壁面温度、主体温度和溶液浓度等参数对结垢速率的影响。
The effects of some factors on the fouling rate have been studied, such as flow velocity, wall temperature, bulk temperature and solution concentration.
存在最佳的反应物组分比，从而获得较低的壁面温度和较高的出口氢气含量。
There is an optimal inlet concentration, which corresponds to the lowest wall temperature and the highest hydrogen fraction at the outlet.
对具有陶瓷隔热涂层的气膜冷却式火焰筒壁面温度和热流提出一种计算方法。
This paper provides a new method suitable for calculating wall temperature and heat flow of ceramic-coated flame tube.
对比再生冷却分析了不同注入率对壁面温度、冷却效率以及边界层厚度的影响；
The influences of porosity on the local blowing ratio, wall temperature and boundary layer thickness were compared with the effects with regenerative cooling.
涡轮叶片内部冷却特性直接影响到叶片的壁面温度分布，必须对其展开详细的研究。
The temperature distribution of the nozzle guide vanes are affected greatly by the flow and heat transfer of the internal cooling passages.
通风开始后，壁面温度随着暴露时间的增长而降低，显热比也随通风时间增长而降低。
The sensible heat factor decreases with the increase of ventilation time after the rock surface is exposed due to the decrease of the surface temperature of the rock.
结果表明，随着磁场的增强，激波脱体距离逐渐增加；总阻力系数和壁面温度逐渐减小。
The results show that the shock standoff distance is increased and total drag coefficient and wall temperature are reduced with increasing external magnetic field.
在锅炉系统中，过热器的壁面温度是非常重要的监测参数，关系到机组安全及运行效率。
It is very important for improving boiler's efficiency and safety to monitor on wall temperature of heat exchanger in boiler.
测量结果显示：当隧道内有列车通过时，气温和壁面温度都瞬间升高，气温变化幅度较大。
The results show that the air and wall temperature rises instantly with high amplitude of temperature variation, when the train moves through the tunnel.
针对烟气换热器壁面温度会低于排烟露点的情况，提出了正压通风燃气锅炉排烟热能利用系统。
Aimed at the fact that the wall temperature of heat exchanger is lower than the dew point of flue gas, the thermal energy utilization system for flue gas of positive draft gas boiler is proposed.
实验结果表明，污垢热阻随时间变化曲线为典型的渐近线型，且随着壁面温度的升高，污垢的结垢速率增加。
The results shows that fouling grow curve is representative asymptote. Besides, the fouling growth rate increases while surface temperature increases.
本文研究了气缸盖火力面喷涂不同厚度的PS Z层对气缸盖金属壁面温度降低的情况及对发动机性能的影响。
In this paper, the temperature reduction of cylinder head metal wall and the influence on engine performance are investigated by different thickness of PSZ coating on cylinder head combustion surface.
壁面温度对最高燃烧温度、壁面最大热流和平均热流影响不明显，但烟气出口温度随壁面温度的升高而增加较大。
Wall temperature had a remarkable effect on smog exit temperature, whereas its effect on other parameters was not obvious.
对高温热管翅在不同功率下起动与运行性能进行实验研究，给出各种功率下高温热管翅的壁面温度分布及相应的温差分布。
The experimental behavior of a high-temperature heat pipe fin was described during startup and running with the different power. The surface temperature distribution was given.
质量浓度为5%的悬浮液在在整个质量流量范围内总是表现出比水好的冷却性能，它对应的是更低的壁面温度以及更好的传热系数。
The 5% suspension always shows better cooling performance than water with lower wall temperatures and enhanced heat transfer coefficient within the whole range of mass flow rates.
本文在对等离子发生器内部纯空气流场的模拟过程中，分析了不同进口气流角、不同进口总压以及不同气流压缩角对发生器电极壁面温度的影响。
The article analyses the influence to the generator electrode temperature from different inlet Angle and inlet total pressure and the compressive Angle of fluid in the situational process.
壁面最高温度及达到最高温度的时间随壁面方位不同而不同。
The maximum temperature and the time when the maximum temperature is reached are different with different slab directions.
本文利用红外热成像仪对不锈钢微管内水的流动沸腾的壁面瞬态温度场进行了测量。
The transient temperature field at surface of a stainless steel micro-tube, in which flow boiling of water occurs, is measured by the Infrared Radiometer.
同时，对油冷柴油机的燃烧室壁面进行了稳态和瞬态温度测试。
Both steady and transient temperatures on combustion chamber wall surface were measured under various working conditions.
根据数值模拟的结果，描绘出炉膛内的壁面热负荷分布、两相流场、温度场、煤粉颗粒轨迹等。
The wall heat flux distribution, two-phase flow field, temperature field and pulverized coal particles trajectory in furnace are described according to the calculation results.
分析了各种气体模型对激波脱体距离、壁面热流、温度分布和密度分布等的影响。
It is analyzed that the thermal and chemical model have a effect on the shock detached distance, heat transfer rate, the distributions of temperature and density.
结果表明燃烧室壁面能够得到要求的高温，且温度分布均匀。
Results indicated that a high and uniform temperature can be obtained along the wall of the flame tube.
应用推荐