当凸轮机构主要用于传递运动时，基圆半径的选择可使滚子做连续滚动为优先考虑条件。
When the CAM is chiefly transferred movement, the choice of radius of base circle firstly is considered the roller's continuous rolling.
在满足机构许用压力角条件下，采用0．618法最优确定盘状摆动凸轮机械的最小基圆半径。
Meeting requirement of the mechanical pressure angle, the minimum base radius of a plate cam for oscillating follower is determined by the 0.618 optimization method.
这里讨论了“叠加基圆法”中基圆半径的选取原则及其对不圆度评定的影响，并作出关系曲线。
Here the selection of base circle radius and its effect upon the assessment of departure from roundness is discussed, and the corresponding curve is given.
基于解析几何法导出的最大压力角表达式，导出了偏心凸轮机构和对心凸轮机构的基圆半径和偏距的计算公式。
According to the allowed pressure Angle, this paper determines the disk CAM with translating followers basic circle radius and eccentricity by using the analytic method.
基于解析几何法导出的最大压力角表达式，导出了偏心凸轮机构和对心凸轮机构的基圆半径和偏距的计算公式。
According to the allowed pressure Angle, this paper determines the disk CAM with translating followers basic circle radius and eccentricity by using the analytic method.
应用推荐