需要咨询喷涂厂家确定适当的固化时间和方法。
The coating manufacturer shall be consulted to ascertain the proper cure time and methods.
相对湿度大于50%将增加所需要的固化时间。
Relative humidity greater than 50% will increase required cure specified.
测定对照组和实验组的固化时间及最大抗压强度；
The maximum compression strength and setting time of the materials in experimental and control group were tested.
研究了炭黑含量对浆料粘度以及固化时间的影响。
The influence of carbon black on the slurry viscosity and gelation time was studied.
固化时间极快。
所需要的固化时间与温度、管道直径和应用压力有关。
Required cure time depends on temperature, pipe diameter, and pressure application.
与化学固化粘合剂相比，其操作使用方便，固化时间短。
Compared with the chemically cured adhesives, it is convenient for practical use, and its curing time is short.
减小闸道尺寸：闸道越大则固化时间越长并会使方向性增加。
Reduced gate size: larger gates take longer to freeze off and permit increased orientation.
研究两种晶种对骨水泥固化时间、抗压强度和产物微观结构的影响。
The effects of seeding on the setting time, the compressive strength and the microstructure of the CPC were studied.
通过实验分析了影响室温硫化硅橡胶脱模剂表面固化时间的各种因素。
The influence factors on surface curing time of silicone rubber release agent vulcanized at room temperature were analyzed by experiments.
通过试验，提出改进单组份RTV型氯丁橡胶胶粘剂固化时间的途径。
The measure of developing the setting up time of one pack RTV CR adhesive was taken by the test.
该组合物在成型的早期阶段提供改善的和可重现的流动而不损害固化时间。
The composition provides improved and reproducible flow during the early stages of molding without compromising curing time.
用该加热池测定快速固化粉末涂料的固化时间，其结果与经典的差热分析方法相近。
The solidifying times of rapidly solidified powder coating materials are in close agreement with the results of conventional differential thermal analyses.
研究表明，利用微波固化环氧胶时，不仅固化时间短，而且剪切强度优于加热固化。
The result showed that, in comparison with cure by heating, the microwave curing was much faster and obtained better shear strength.
较小的膜层厚度、较小的光束夹角和较短的曝光聚合固化时间有利于衍射效率的提高。
With the same recipe, shorter cure time, comparative smaller degree of two laser beams and thinner PDLC film give rise to higher diffraction efficiency.
目的：考察热固化时间及温度对喷雾干燥牛血清白蛋白微球表面活性氨基含量的影响。
OBJECTIVE: Effects of heat denaturation time duration and temperature on the surface reactive amino group content of spray dried bovine serum albumin microspheres were investigated.
试验表明，环氧灌浆料具有较高的粘结强度，而且固化时间短，尤其能在潮湿界面中使用。
The experiment shows that the epoxy grouting material has binding strength more powerful and solidified time shorter, and can be especially used in the moist surface.
方法通过测定两种胶体的动力黏度、固化时间和对钙离子的作用，探讨相应的黏合性能。
Methods The adhesive capabilities were analysed and discussed by measuring their kinetic viscosities, solidification time and the reaction with calcium ions.
结果表明，在相同固化条件下，纳米微波吸收剂能明显降低改性环氧胶粘剂的微波固化时间。
The results show that nanometer microwave-absorber can obviously decrease the microwave curing time of modified epoxy adhesive under the same curing condition.
研究了对紫胶改性酚醛树脂胶粘剂的固化时间、接胶合板的粘接强度和甲醛释放量进行了测定。
The research of phenol-formaldehyde (PF) resin modified with lac can be expected to widen the application of the lac and enlarge the utilization of the renewable resource.
评价了固化时间、固化温度、催化剂的类型和用量以及不同粒径石英砂等因素对固砂效果的影响。
The effects of solidification time and temperature, types and amount of catalyst, and different grain sizes of quartz sand on sand consolidation effectiveness are discussed.
本文研究了固化时间与粘接强度的关系，而且应用红外光谱研究了第二代丙烯酸酯胶的固化机理。
In this paper, the relationship between the solidification time of SGA and its shear strength has been studied. On the other hand, solidification mechanism of SGA also has been studied by the IR.
结果表明：添加晶种可以降低产物成核所需克服的势垒、促进成核、大幅度缩短骨水泥的固化时间。
The results show that the seeds appear to reduce the setting time and increase the compressive strength.
提出了选择固化温度的原则，以及三种不同树脂固化体系粘度随固化温度、固化时间变化的函数关系。
The author proposed the principle to select the curing temperature and functional relations of the viscosity with curing temperature and time for three different resin systems.
研究了PAE用量、热固化时间和温度对麻浆、桑皮浆和针叶木化学浆手抄薄型纸湿强度特性的影响。
The wet-strength properties of three thin handsheets made of hemp pulp, softwood pulp and mulberry pulp with the wet-strength resin (PAE) as the additive were studied.
探讨了固化温度、固化时间、耐介质性、携砂液的种类和用量以及支撑剂粒径等对纤维复合防砂体的影响。
Effect of curing temperature, curing time, resistance to media, kind and volume of the sand-laden fluid, and particle size of proppant on fibre compound sand control system were discussed.
由于改性乳化沥青稀浆比普通的稀浆封层固化时间快，所以改性乳化沥青稀浆封层可以比传统的稀浆封层厚。
Modified emulsified asphalt as a result of slurry seal than the ordinary fast curing time, it can be modified emulsified asphalt slurry seal than the traditional thick slurry seal.
目的：研究异氰酸酯基材料固化时间控制方法，以完善基于此材料的伤员固定转运器械的制作方法和操作规程。
Objective To study controlling method for curing time of the materials based on isocyanate , and perfect making means and operating rules of transmitting apparatus for the wounded.
目的：研究异氰酸酯基材料固化时间控制方法，以完善基于此材料的伤员固定转运器械的制作方法和操作规程。
Objective To study controlling method for curing time of the materials based on isocyanate , and perfect making means and operating rules of transmitting apparatus for the wounded.
应用推荐