回火钢柄支持和稳定你的整个身体,减少脚和身体的疲劳。
Tempered steel shank supports and stabilizes your entire body, reducing foot and body fatigue.
阐述了超高强度的淬火回火钢(调制钢)在深海半潜式钻井平台中的应用。
This paper describes the application of high strength quenched and tempered steel in semi-submersible drilling platform.
国产新型塑料模具钢主要有预硬钢、时效硬化钢、淬火——回火钢、冷挤压成型模具钢、耐蚀钢等类型。
The new domestic - developed plastic mould steels include prehardening steel . age hardening steel, quenching-tempering steel, cold -forming steel, and anti - corrosion steel, etc.
研究了淬火、回火工艺对低碳马氏体型高强度高韧性非调质钢的组织和性能的影响。
The effect of hardening and tempering process on the organization and performance of high-strength and high-toughness non-hardened-and tempered steel of low carbon martensite is researched.
结果表明:回火对试验钢的硬度和强度均有较大影响。
Results show that tempering has considerable influence on both hardness and strength.
回火完全淬硬钢得到的最终组织结构被称为回火马氏体。
The final structure obtained from tempering a fully hardened steel is called tempered martensite.
钢的热处理操作主要有三种,即:淬火、回火和退火。
There are three main operations in the heat treatment of steel: hardening tempering and annealing.
钢的热处理操作主要有三种,即:淬火,回火和退火。
There are three main operations in the heat treatment of steel: hardening, tempering and annealing.
本文介绍国产A508-3钢在不同的淬火、回火和退火条件下的热处理实验的某些结果。
This paper presents some results of heat treatment experiments of A508-3 steel at different quenching, tempering and annealing conditions.
同时,提出了一种确定淬火钢回火工艺的新方法。
And, a new method of determining the technology of tempering of the hardened steel is also advanced.
关于钢的淬火和回火有两个要点需要注意。
Two important points are to be noted in connection with the quenching and tempering of steel.
弹簧为低应力、油回火、螺旋缠绕在整体钢轴上扭力型弹簧。
Springs shall be low-stress, oil tempered, helical wound, torsion type on continuous shaft, Solid CRS or tubular as required.
研究了T10钢在低温盐浴渗铬后直接淬火并回火工艺。
Immediate quenching and tempering process of steel T10 after low temperature salt bath chromizing was studied.
通过热处理试验对t 23钢的回火脆性进行了研究。
The temper brittleness of T23 steel was studied through heat treatment experiment.
钢的热处理工序包括硬化、回火、退火和表面硬化。
The procedures of heat treatment of steel include hardening, tempering, annealing and case hardening.
研究了回火温度对钢淬火后性能的影响。
The effects of tempering temperature on properties of quenched link-chain steel were studied.
在保证强度满足要求的前提下提高回火温度可以提高钢的耐延迟断裂性能。
It was observed that the delayed fracture resistance of 30MnSi steel bars increases with tempering temperature at a sufficient strength.
磨削热导致回火引起淬硬钢磨削后表面硬度变化。
Tempering resulting from grinding heat caused surface hardness changes of hardened steels after grinding.
结果表明,随回火温度的升高,45钢组织的大幅度软化导致耐磨性明显下降。
The results show that the microstructure of 45 steel is substantially softened, the wear resistance rapidly decreases with the tempering temperature rising.
试验结果表明H13钢在最佳完全退火温度、淬火温度、回火温度下可得到最优综合性能。
The test results show that the surface of H13 steel can obtain the optimum performance at temperature of complete annealing, quenching and tempering.
经过回火之后,钢的强度增大,因为其晶粒变细了。
After having been tempered, the steel becomes stronger because its grains get finer.
铬钒钢盘条金属丝和弹簧。高负荷地线。淬火和回火。规范。
Chromium - vanadium steel wire rod, wire and springs - high duty ground wire - hardened and tempered - specification.
结果表明:回火索氏体是最佳的组织形态;微观硬度的不均匀性显著影响钢的表面加工质量。
The results indicated that the tempered sorbite was the optimum microstructure, the inhomogeneous distribution of micro hardness affected markedly the finish quality of the steel surface.
采用焊接热模拟技术和显微分析方法,研究了回火焊道热处理对X80级管线钢焊接热影响区韧性的影响规律。
The effects of tempering weld-pass treatment on toughness of HAZ of X80 pipeline steel were studied by the technique of welding thermal simulation and the method of microscope analysis.
另一方面,为了评估回火温度对疲劳性能的影响,将MIM钢试样于不同温度下进行了回火。
On the other hand, the MIM steel specimens were tempered at various temperatures in order to evaluate effect of tempering temperature on fatigue property.
钢是通过加热再放进冷水里回火炼成的。
Steel is tempered by heating it and then putting it into cold water.
钢是通过先加热后冷却来回火的。
研究了低碳奥氏体—马氏体双相不锈钢在不同回火温度下硬度变化规律。
This paper has studied hardness changing law of low carbon austenite-martensite double phases stainless steel at different tempering temperatures.
MIM钢试样的疲劳强度随着回火温度升高而减低。
Fatigue strength of the MIM specimens declined with increasing tempering temperature.
MIM钢试样的疲劳强度随着回火温度升高而减低。
Fatigue strength of the MIM specimens declined with increasing tempering temperature.
应用推荐