独特技术，压缩包装后回弹率为85%。
Unique technology, compressed package for 85% after rebound rate.
表9 钢纤维混凝土试验板侧面回弹率。
密度柔性石墨板的拉伸强度、压缩率和回弹率等力学性能。
Tensile strength compression and resilience rates of flexible graphite sheets were measured.
提出了报高pp纤维的模量和回弹率以及地毯的耐倒伏性的新途径。
The new way to improve modulus and resilience of PP fiber and lodging-resistant property of PP carpet yarn is suggested.
选择合适的材料和施工工艺，可有效地降低干喷纤维混凝土的回弹率。
It is also concluded that the rebound rate of dry-sprayed fiber concrete can be reduced obviously by adoption of rational materials and techniques.
测量了不同密度柔性石墨纸的抗拉强度、压缩率、回弹率和基本断裂功。
The tensile strength, compressibility, resilience and essential fracture work of flexible graphite sheet were measured.
作者研究了热定型条件对丙纶弹性回复率的影响，并将回弹率与纤维的其它力学性质作了对比。
The effect of heat setting conditions on the elastic resilience of IPP fibers has been investigated. The elastic resilience compares with other mechanical properties.
该模型可以预测镍基合金薄壁筒在不同胀形工艺参数匹配下的回弹率，也可以用于优化胀形工艺参数。
The model can predict the bulging rebound rate of thin tube of nickel-based alloy at different process parameter, it can also be used to optimize the process parameters of bulging.
高固含量PIPA多元醇泡沫相对于POP多元醇泡沫，具有更好的压陷硬度、回弹率、 拉伸强度、 伸长率以及撕裂强度等机械性能。
Relative to the foam added with POP polyol, the foam added with high solid content PIPA polyol has the better mechanical performance on the resilience coeffi…
通过对阻燃腈纶纱的瞬时拉伸测试，分析重复拉伸条件下腈纶纱的瞬时回弹特性，定量地阐明腈纶纱瞬时拉伸回弹率与经纱开口变形的关系及其对织造加工的影响。
The relationship between the instantaneous resilience of the yarn and the shedding deformation along with its influence on weaving performance were discussed on a quantitative basis.
简要介绍了曲线光顺时的国率法、回弹法及磨光法。
Circle ration method, spring back method and polish method for curve smoothing have been briefly introduced.
木材弯曲后，控制木材的含水率是降低回弹的一个重要方面。
Controlling moisture content is one of the most important aspects to debasing reversion after bending.
研究了染色条件对聚对苯二甲酸丙二酯（PTT）纤维上染率、纤维截面直径、力学性能和回弹性能的影响。
It was studied that the effects of dyeing conditions on the dye-uptake, cross sectional diameter, mechanical properties, and elastic recovery properties of PTT filament.
产品的性能与特点：可以提高胶料的拉伸强度，撕裂强度和伸长率，且生热小、低回弹性。
Product Characteristics: it can improve tensile strength, tearing strength, elongation of rubber compound, and it has lower heating and low resilient.
对两条回弹曲线的回归误差进行对比分析，结果表明，考虑含水率的回弹曲线具有更高的检测精度。
Furthermore, regression errors of the rebound curves are compared and analyzed. The results show that rebound curves considering water content have higher test precision.
回弹法检测混凝土强度时，检测结果受构件含水率影响显著。
In concrete strength measurement with rebound method, the result is obviously influenced by water content of specimens.
材质为T2紫铜料表面镀锡，保证了可靠的导电率，端头尾部内孔有螺纹线，绝缘套为硬质，不断裂，不回弹。
They are tinned T2 copper which assure the credible conductivity. There is thread in the inner hole of the afterbody of terminals, the insulation covering is hard, there is no break no rebound.
产品具有速溶性好，瞬间硬化，附着率高，回弹性小，易喷补等特点。主要用于各种碱性炼钢炉、镁碳质、镁质炉衬的喷补。
It is mainly used in all kinds of basic steel-makeing furnaces, the gunning of magnesite carbon nature and magnesite nature lining materials.
产品具有速溶性好，瞬间硬化，附着率高，回弹性小，易喷补等特点。主要用于各种碱性炼钢炉、镁碳质、镁质炉衬的喷补。
It is mainly used in all kinds of basic steel-makeing furnaces, the gunning of magnesite carbon nature and magnesite nature lining materials.
应用推荐