将唇口滑动而上的传热归结为第二类边界条件；
The authors assume that the heat flux at the sliding surface of the lip occurs for the second boundary condition.
汽车水泵轴承密封圈的密封性能与唇口过盈量密切相关。
The performance of automotive water pump bearing seal is closely related with the magnitude of interference of the sealing lip.
本文介绍了“可更换唇口橡胶油封”的设计，试制及试验结果。
This paper introduces the design, manufacture, and testing results of rubber seals with replaceable lip.
本实用新型的要点是：在主封油面的另一侧还有一个封油唇口。
The utility model has a main point that the other side of the main oil seal surface is also provided with an oil seal lip.
变唇口加杆可模拟具有中心高压区且周向畸变较小的总压分布。
The contour map of small circumferential total pressure distortion with high pressure area at centre can be simulated by the method of the combination of lip and rod.
本实用新型的工作原理是利用门密封圈的内圈唇口与冲压门体之间的挤压来实现密封功能。
The operational principle is that the utility model makes use of the extrusion between the inner ring lip of the seal ring and the stamping door body to achieve seal function.
终端开口与转动风扇的比较表明，无隔道进气道的后向散射主要来源于外罩唇口的电磁波散射。
The comparison results of the bump inlet with opening terminal and with rotating fan at the outlet indicate that the electromagnetic scattering comes mostly from the mouth of inlet.
移动唇口板以减小内收缩比可以实现侧压式进气道自起动，主要是因为侧板分离包被排出进气道。
Moving cowl, decreasing interior contraction ratio also can realize the hypersonic sidewall compression inlet's self-starting because of separation bubble on sidewall spilling out.
刮片胶条通过弹簧条压向玻璃表面，它的唇口必须与玻璃角度配合一致，方能达到所要求的性能。
Only when the tip of the blade is in a certain Angle with the glass can the required function be realized.
此外，对农业工程机械中的密封提出反装油封产生微泄漏，以形成对唇口接触区域清洗作用的设想。
In addition, an imagination of using the reverse setting of oil seal to produce the microleakage inord er to make clean the lip contact region using in the agricultural construction Mach...
唇口的设计对进气道的侧滑角性能有着重要影响，进气道性能的进一步提高应考虑唇口设计的改进。
The design of cowl lip is of great importance to the inlet performance at yaw, therefore, further improvement of the inlet performance will rely on the lip shapes of the cowl chosen.
必须有效控制支承辊两侧轴承座的间距、保持密封件唇口良好接触状态及采用性能、尺寸合格的备件。
To control the clearance between both sides of bearing chuck in back-up roll, keep sealing tips in a good touching state and use correct spare parts both in function and dimension.
随着安装过盈量的增大，油封唇口接触宽度不断增加，唇口最大接触压力先是有所增加，后逐渐趋于一定值。
Thirdly, along with the increase of the interference the width of the contact field on the air side become larger, but the max contact pressure increase first and then come to a constant value.
U型圈是液压缸中最常用的油封，它是一种典型的唇口密封件，无论用于活塞还是活塞杆都能获得良好的密封效果。
It's typical lip seal, which is able to gain good seal effect no matter in piston or piston rod.
在没有失稳之前，油封唇口接触宽度随油封内腔压力有明显增大，而最大接触压力先是不断增大，后由于接触宽度增大的缘故，最大接触压力开始减小。
Before the break, the width of the contact field on the air side has a great increase, but the max contact pressure increase at first and then become smaller due to the increase of the contact width.
胃肠道症状通常为便秘与腹泻交替，伴有口、舌发炎，唇与口角皲裂并有鳞屑。
Diarrhea usually alternates with constipation, along with mouth and tongue inflammation and cracking and dry scaling of the lips.
结论在肠道通畅情况下，对实验家兔采用带蒂腹直肌瓣早期填塞瘘口可以快速治愈唇状肠瘘。
Conclusion on the condition that the intestinal tract is unobstructed, the labiate intestinal fistula can be cured by packing the fistula orifice with pedicled straight muscle of abdomen flap.
结果解决了新生儿唇裂整复术因上唇嫩小，结构特征难以准确对合及口轮匝肌重建等问题。
Results The problems of restoring skill of newborn babies's cleft lip because of labrum tender little, structural feature hardly accurate for suit, and ship circle muscle reconstruction.
方法分析5例口底癌患者，接受联合根治术后应用双侧带蒂鼻唇沟岛状肌皮瓣进行口底及舌的一期修复。
Method 5 cases of intraoral defects were repaired with bilateral nasolabial myocutaneous flap after radical operation of mouth floor carcinoma.
最为显著的例子即连接舌头和口底、唇和牙龈的舌系带。
The most obvious example is the fraenum which attaches the tongue to the bottom of the mouth, or the lip to the gum.
德伐日先生经过青砖铺地的人口走进青砖铺地的楼梯口时，对他往日的主人跪下了一只脚，把她的手放到了唇边。
In the gloomy tile-paved entry to the gloomy tile-paved staircase, Monsieur Defarge bent down on one knee to the child of his old master, and put her hand to his lips.
钟的各部位都有着特定的名称，上部称为钲，下部谓之鼓，钟口两角为铣，钟唇曰于，钟顶名舞。
The bell has a specific name of the site, known as moving the upper and the lower part is called the drum bell mouth 16.20 for milling, bell onthe lips say, Name-minute dance.
探讨双侧鼻唇沟轴型带蒂肌皮瓣修复口底大面积缺损后皮瓣生长变化及对供区的影响。
To assess the efficacy of bilateral axial pedicle nasolabial myocutancous flaps which were used to repair the large area of defect in oral floor and the influence of them on donor sites.
探讨双侧鼻唇沟轴型带蒂肌皮瓣修复口底大面积缺损后皮瓣生长变化及对供区的影响。
To assess the efficacy of bilateral axial pedicle nasolabial myocutancous flaps which were used to repair the large area of defect in oral floor and the influence of them on donor sites.
应用推荐