使前、后连杆分担总扭矩的比例问题建立在较精确的计算基础上。
So the calculation of the proportion of twisting moment between the front bar and back bar is based on an accurate calculation.
作者把掩护梁和前、后连杆一起考虑，引出掩护梁和前、后连杆组成的虚拟系统。
The author derives a virtual system of debris shield and the front and rear linkage.
连杆螺钉在加工完成后成品交验前，要求进行预拉伸试验。
Before completing linkage screw in the machining, finished products are needed to do the pre-tensile test.
对12V240ZJ型柴油机进一步强化后，主轴承和连杆大端轴承的可靠性进行了分析计算。
The reliability of main bearing and connecting rod large end bearing for 12V240ZJ diesel engine whose power has been increased up to the E type grade was analyzed.
采用数控技术对旧式普通车床进行了改造，并将改后的车床用于柴油机连杆等异型复杂件的加工。
The old conventional lathe is innovated with the help of NC technology. It can be applied to manufacturing complicated parts with special forms, such as connecting lever of diesel motor.
这包括超长连杆衬套和一个标准的超大穿带(对活塞后所在地)。
This includes an extra long rod bushing and a standard oversized wear band (located on the rear of the piston).
结果表明，由于连杆锻后宽度尺寸不够，在增加了热矫形工序后造成其变形量处于临界变形区，导致分模面切边带区出现严重的混晶和魏氏组织。
The result showed hot sizing was the main factor to cause critical deformation, to make mixed grain and coarse grain widmanstatten appear in parting face.
优化后，在剪切区，剪刃剪切倾角和连杆水平速度均匀性两项指标均有所提高。
After optimization, the cutting Angle and the difference between the instantaneous velocity and the average velocity in the cutting area of the shear are decreased.
这包括超长石墨填充铸铁连杆衬套和一个标准的特大型穿带（位于活塞后）。
This includes the extra long graphite filled cast iron rod bushing and a standard oversize wear band (located on the rear of the piston).
投掷部分的组成中包括球托、前推杆、后推杆、驱动杆、连杆、驱动气缸、支架等。
A throwing part comprises a ball seat, a front push rod, a back push rod, a drive rod, a connecting rod, an actuating cylinder, a support frame, etc.
介绍平移式后发动机舱门的结构及工作原理，四连杆机构尺寸的确定及动力学校核，以及空气弹簧、门锁的选用等。
Hence, this paper mainly focuses on the dynamic analysis of the two-side four-bar beating-up motion of an air-je.
介绍平移式后发动机舱门的结构及工作原理，四连杆机构尺寸的确定及动力学校核，以及空气弹簧、门锁的选用等。
Hence, this paper mainly focuses on the dynamic analysis of the two-side four-bar beating-up motion of an air-je.
应用推荐