本文对非比例双滑移的变形规律和运动学进行了一般的数学分析。
This paper presents a general kinematical analysis for nonproportionaldouble slip in fcc and bcc crystals.
本文阐述了双联滑移齿轮在适当传动出情况下，轴向移动一个齿轮宽度就可以进行变速的可行性及适用场合。
This paper brings out feasibility and applicability to make change drive of double step sliding gear by moving one gear width along axis under conditions of Corresponding ratio of gear.
研究双轴滑移齿轮机构变位系数的选择理论，是合理设计这种机构的关键问题。
Study of the theory of choosing modification coefficient of double shaft move wheel gear is the key to the rational design of this mechanism.
对双剪统一屈服准则所表征的材料屈服极限和滑移面方向特性作了分析。
Two aspects of the yield limits and the slip directions for materials in the twin-shear unified yield criterion are analyzed in this paper.
由此可见，双剪统一屈服准则尚不能很好地描述材料屈服时的滑移特性。
So it is summarized that the twin-shear unified yield criterion could not give a proper descriptions to the slip characteristics for the materials when yielding.
栓钉剪切刚度与滑移呈双曲函数关系，影响其剪切滑移刚度的因素是栓钉直径和混凝土强度。
The diameter of stud and strength of concrete are main factors to affect the shear stiffness.
研究表明采用环氧类树脂粘结剂进行钢套管和GFRP筋的连接，技术可行；环氧类树脂粘结剂的粘结滑移关系曲线上升段具有双折线特性。
The results show that the technique of using epoxy resin adhesives as bonding materials between steel thimble and GFRP bars is practicable.
研究了单伸臂简支组合梁和双伸臂简支组合梁钢与混凝土板之间相对滑移和栓钉受力的关系；
The relations between the steel concrete slips and the studs' loading forces of two kinds of simply supported composite beams with one or two cantilevers respectively are studied.
采用双毛细管流变仪详细研究了聚乙烯及其共聚物的挤出畸变、管壁滑移及挤出压力振荡现象。
The effect of blending was investigated by analyzing the viscoelasticity, pressure oscillation, flow curves and extrudate appearance.
采用双毛细管流变仪详细研究了聚乙烯及其共聚物的挤出畸变、管壁滑移及挤出压力振荡现象。
The effect of blending was investigated by analyzing the viscoelasticity, pressure oscillation, flow curves and extrudate appearance.
应用推荐