文中设计了三个控制误差区域,将控制器作用在合理的偏差范围内,避免了因控制测量误差而消耗大量燃料。
Three control error boxes enabling the controller to work in the reasonable error areas to avoid fuel wastage for the error measure were also allocated.
采用文中给出的鲁棒控制器,能保证机械臂的实际跟踪误差在有限时间内减少到预先给定的包含原点为内点的区域。
Results shows the following fact: it can be guaranteed that the practical tracking error in operating process of rigid robot manipulator attenuates to the given region around the origin.
在设计的控制器中,采用这种动态边界层,以使得跟踪误差收敛到这种边界层所确定的区域,保证闭环系统在给定时间区间上可实现完全跟踪。
We use a dynamic boundary layer for the controller design, where the initial rectified attractor is introduced and adopted for forming the boundary layer.
本文概述了采用微处理器分区,自动控制三管式彩色摄像机的区域误差,提高其重合精度的新方法。
In this paper the author introduces a new method of improving the coincident accuracy of a 3-tube color camera by using a microprocessor for automatically controlling its partial errors.
PQI必须针对不同的测试区域以及不同的测试情况进行相应的标定,使测量误差能够控制在2%以内。
PQI must be demarcated in different structure pavements and areas so as to keep the error under 2%.
条纹频率分析产生可靠性模板,基于该模板的排序算法将误差范围控制在局部最小的区域。
Reliability mask is produced by the analysis of fringe frequency. Then the error is limited to local minimum areas by using the ordering algorithm based on the reliability mask makes.
条纹频率分析产生可靠性模板,基于该模板的排序算法将误差范围控制在局部最小的区域。
Reliability mask is produced by the analysis of fringe frequency. Then the error is limited to local minimum areas by using the ordering algorithm based on the reliability mask makes.
应用推荐