• 证明用有限元分析软件对点焊结构进行失效模拟的可行性,甚至可以部分替代剪切拉伸试验。

    Finite element analysis software is feasible to simulate the failure analysis of tensile shear test, even partial replacement of shear tensile test.

    youdao

  • 在其生命周期中,一个组件经历一系列的转换、旋转、缩放、剪切和拉伸,最后才显示在屏幕上。

    During its life cycle, a component undergoes a series of translations, rotations, scaling, shearing, and stretching before it's finally displayed on the screen.

    youdao

  • 环氧胶粘剂的耐蚀性能是通过测定其拉伸剪切强度来评定的。

    The corrosion resistance of epoxy adhesive was assessed by its tensile shear strength.

    youdao

  • 本文介绍纺织结构复合材料在剪切、压缩、拉伸和弯曲情况下的破坏机理,分析其特点和存在的问题,提出了发展趋向。

    This paper describes the failure mechanisms based on shear, compression, tension and flexure, analyzes characteristics and problems of those models and then discusses the future trend.

    youdao

  • 测定了低温下聚氨酯硬泡沫塑料拉伸、剪切和压缩弹性模量与泡沫密度、方向以及温度的关系。

    Measurements have been made to determine the relation of the tension, the compression and the shearing of PUR foam at low temperature with its density, direction and temperature.

    youdao

  • 测定了铝合金的微型剪切试验和拉伸试验的性能参数,研究了这些性能参数之间的数量关系式。

    The characteristic values of micro shear test and tensile test of alloy aluminium were determined and the quantitative expressions of these characteristic values were studied.

    youdao

  • 本文是对自锁锚杆在拉伸和剪切荷载共同作用下的锚固机理进行研究。

    The anchorage mechanism of the locking anchor under tension together shear loads is studied in the paper.

    youdao

  • 用碳纤维进行了性能研究,测试了拉伸、压缩、剪切和冲击性能。

    The tensile compressive shear and impact properties of carbon fibre are tested.

    youdao

  • 针对岩盐这一特殊性质的岩石,进行了基本的力学特性试验,包括单轴压缩、间接拉伸及变角剪切。

    Testing study is made on the basic mechanical property of thenardite salt rock, which includes uniaxial compressive, indirect tensile and Angle changed shear tests.

    youdao

  • 试验结果表明,拉伸强度表现出混杂负效应,而剪切强度表现出混杂正效应,两种强度的混杂效应都随混杂比的增大而降低。

    The results show that the tensile strength presents negative hybrid effect, while shear strength presents positive hybrid effect, and their hybrid effect decreases with the hybrid ratio increasing.

    youdao

  • 为此把带有波纹的底板和腹板分别等效为正交各向异性平曲板,并通过拉伸和剪切试验得到了其两个方向的等效材料常数。

    The web and flange plates with a large number of corrugations are equivalent to orthotropic curve plates and their equivalent material coefficients are obtained by stretching and shearing experiments.

    youdao

  • 结果表明,在销钉的作用下,粘性流体既发生剪切变形,又发生拉伸变形,正是这两种变形的同时存在,强化了混合效果。

    The result shows that both shearing and tensile distributions in the viscous fluid exhibit under the action of the pins. The mixing effect is intensified by these concurrent strains.

    youdao

  • 泰盛结构胶具有较强的拉伸、剪切与剥离强度,耐冲击、耐压、抗振动。

    Tightsen structural adhesives have excellent tensile, shear and peel strength combined with maximum impact, stress and vibration resistance.

    youdao

  • 包括拉伸、剪切以及弯曲等载荷。

    Some of the loads include tensile, shear and bending.

    youdao

  • 实验结果表明,该算法具有较好的不可感知性,可以有效抵抗线性拉伸攻击,并且对于剪切、旋转、噪声,滤波等攻击都具有较强的鲁棒性。

    The results of experiment proved that this algorithm is invisible, can efficiently against linear stretching attack, and has better robustness to crop, rotation, noise or filter attack.

    youdao

  • 并对试样进行了拉伸强度、剪切强度、剥离强度等多项测试。

    And get on multinomial testing to the sample such as tensile strength, shearing strength, peeling strength and so on.

    youdao

  • 如果压缩力和拉伸力足够大,使得材料的各层次间相互滑移,那么就产生了剪切力。

    If the compressive and tensile forces are greater enough to make the layers of the material slide upon each other, a shearing force results.

    youdao

  • 本文介绍了微型剪切试验与拉伸试验、断裂力学试验等参数之间的对应关系。

    This paper describes the correlation between the characteristic values of the micro shear test and those of the conventional tensile, fracture mechanical tests.

    youdao

  • 介绍了一种高强度光敏胶拉伸剪切强度测试方法,分析了影响测试结果的几种主要因素。

    An introduction to the testing method for tensile and shear strength of high strength photosensitive glue is given and the main causes that have influence on the testing result is analyzed.

    youdao

  • 测试了热循环前后胶接试样的拉伸剪切性能、质损率和表面残余应力,观察了拉伸剪切断口形貌。

    The tensile shear properties, mass loss ratio and surface residual stress of the bond samples before and after the thermal cycling were measured. The tensile shear fracture morphologies were observed.

    youdao

  • 得出了在不同拉伸速度和边框长度条件下装置处于准静态时的临界剪切角,并且分析了织物试样尺寸大小对准静态范围的影响。

    The critical shear Angle of quasi-static state was given under different loading speeds and frame lengths condition, and the influence of specimen size on this shear Angle range is also discussed.

    youdao

  • 形成拉伸盆地的大陆岩石圈伸展构造作用,一般认为是沿大型缓倾角正断层(滑脱断层)的剪切作用过程。

    The extension of the continental lithosphere that gives rise to extensional basins is generally considered as a shear process on major, gently dipping normal fault.

    youdao

  • 经典成核理论假设气泡核的形成是在静态条件下发生的,它没有反映在口模流场中动态因素(拉伸、剪切等)对气泡成核的影响。

    Because classical nucleation theory supposes that bubble formation is occurred under static state, it doesn't reflect the effects of dynamic factors on bubble nucleation, such as shear and elongation.

    youdao

  • 理论分析证明,在剪切载荷作用下裂纹扩展是由于拉伸应力引起的,并非剪切破坏。

    Theoretical study shows that the crack extension under shear loading is caused by tensile stress, and it does not belong to shear fracture.

    youdao

  • 准静态下纤维增强复合材料在偏轴拉伸和剪切时有明显的非线性。

    Nonlinear behaviour occurs when partial tension and shear are exerted on quasi-static fibre reinforced composite.

    youdao

  • 锻件比铸件能承受更高的剪切力和拉伸力。

    Forgings can withstand higher shear and tensile forces than the castings.

    youdao

  • 本文以NOL环研究了F- 12/碳纤维混杂复合材料的拉伸性能和剪切性能。

    The tensile and shear properties of F-12 aramid fiber and carbon fiber intem1y hybrid NOL ring composites are presented in this paper.

    youdao

  • 这可能是由于它们产生剪切形变局部化的滑移面硬化率对瞬时拉伸应力的临界比值不同之故。

    Presumably, it is due to their different critical values of the ratio of slip plane hardening rate to current tensile stress for shear localization.

    youdao

  • 结果表明:周向剪切应力场可明显改善管材的周向强度,轴向拉伸可实现管材轴向增强。

    It was found that the circular shearing and axial tensile increased the circular and axial strength of the pipe, respectively.

    youdao

  • 结果表明:周向剪切应力场可明显改善管材的周向强度,轴向拉伸可实现管材轴向增强。

    It was found that the circular shearing and axial tensile increased the circular and axial strength of the pipe, respectively.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定