其中成骨细胞对剪切应力最敏感。
嫩度指标应以剪切应力值表示。
And the index of tenderness is expressed with shearing strength.
计算出了与沟坡相关的临界剪切应力。
Critical shear stress as related to bed slope was calculated.
传质速率及壁面剪切应力的测量采用电化学方法。
Mass transfer rates and wall shear stresses are measured by the electrochemical method.
这些现象主要是由于准静水压下剪切应力的作用。
These drastic changes of superconductivity were mainly due to the shear stress under quasi-hydrostatic pressure.
应力-应变图可以用来表现剪切应力与剪切变形。
A stress-strain diagram can be plotted using shear stress and shear strain.
临界分剪切应力。
磁流变离合器是通过磁流变液的剪切应力传递转矩的器件。
A magnetorheological (MR) clutch is a device to transmit torque by the shear stress of MR fluids.
给出了剪切应力强度因子和裂纹面接触区尺寸的数值结果。
The numerical results of shear stress intensity factor and the length of the crack face contact region are given.
修正后的计算模型考虑了土壤受剪速度对其剪切应力的影响。
The effect of shear rate on shear stress is included in the revised model.
计算结果表明，体外反搏可以明显有效地改变血管壁剪切应力。
The computation results show that the external counterpulsation can effectively change the blood vessel pipe_wall shear stress.
当外加磁场增大至粒子达到饱和磁化时，剪切应力达到饱和值。
The shear stresses increase with the external magnetic field, but have saturation values.
提出了采用人工模拟降雨试验数据直接计算临界抗剪切应力的方法。
A direct calculation method of the critical shear stresses was established according to experiment datum on simulated rainfall.
接触带构造变形特征显示岩体侵位受控于区域左旋剪切应力场作用。
The contact deformation shows that the Fenghuangshan pluton was controlled by a regional sinistral shear stress field.
结论低血管壁面剪切应力，是动脉粥样硬化的危险性血流动力学因素。
Conclusion Low wall shear stress is a risk hemodynamic factor in the development of atherosclerotic plaque.
研究表明，随着马氏体含量的增加，双相钢的最大剪切应力随之增加。
The research results show that the maximum shear stress of dual-phase steel raises with the increase of martensite content.
目的研究体外反搏治疗心肌缺血时血管对剪切应力各频率分量的影响。
Objective To study the effect of enhanced external counterpulsation (EECP) on frequency components of shear stress in myocardial ischemia condition.
计算中的底部剪切应力由波流边界层模型给出波—流共同作用下的形式。
In calculation, the bottom shear stress under the effect of waves and currents is supplied by the wave-current bottom boundary layer model.
兔子和小鼠的剪切应力特殊点超过人类10-20个单位，这个发现已经被证实了。
This is evidenced by the finding that typical shear stress levels in rats and mice exceed those of man by a factor of 10-20.
通过分析可得，粘贴层剪切应力的分布与致动器端部附近的应变分布有相似的特征。
This paper shows that the shear stress distribution in bonding layer has similar characteristics as the strain distributions near the ends of the actuator.
通过分析可得，粘贴层剪切应力的分布与致动器端部附近的应变分布有相似的特征。
This paper shows that the shear stress distribution in bending layer has similar characteristics as the strain distribution near the ends of the actuator.
根据本文给出的数学模型，可以确定出在给定剪切位移下剪切面发挥的抗剪切应力。
Using the model given in this paper, cutting stress with given cutting displacement can be determined in given cutting section.
虽然在这些部位剪切应力将会以斜拉应力的形式被提供，而斜拉应力是不可计算的。
Although it is really the diagonal tension for which shear reinforcing must be provided, diagonal tensile forces are not calculated.
通过计算得到的粘度场，由物料的本构方程反推出流道中的剪切速率场和剪切应力场。
Through deduction to the constitutional equation of viscosity, field and shear stress field of the runner were achieved.
讨论了共混物的组成、剪切应力和剪切速率以及温度对熔体流变行为、熔体粘度的影响。
Influences of composition of the blends, shear stress, shearing rate and temperature on the rheological behavior and viscosity of the melt were discussed.
建立剪切应力和动脉粥样硬化之间关系的主要机制是血管壁剪切应力基因表达的控制机制。
A central mechanism establishing the relation between shear stress and atherosclerosis is the control of gene expression by wall shear stress.
岩浆的侵位受区域性大断裂左旋剪切应力控制，空间上呈现由南东往北西逐渐变新的特点。
Controlled by sinistral shear stress of the regional major fault during magma emplacement, the granite distributed from the southeast to the northwest.
提出了一种用细沟在坡面发生的位置和相应的水流特性来直接计算土壤临界抗剪切应力的方法。
A direct calculation method of the critical shear stresses was established through observing initial place of slope erosion arising and the characteristic of runoff.
由试验资料发现，剪切面上的剪切应力与剪切位移关系可分为逐渐硬化和峰值后软化两种类型。
It is found that the relationship between cutting stress and displacement can be divided into two types of gradually hardening and softening alter peak value.
由试验资料发现，剪切面上的剪切应力与剪切位移关系可分为逐渐硬化和峰值后软化两种类型。
It is found that the relationship between cutting stress and displacement can be divided into two types of gradually hardening and softening alter peak value.
应用推荐