那么我从某个初始温度T1开始。
粒度对微滴初始温度有较大影响；
The size of droplets has great effect on the original temperature.
热载体初始温度对热解气组成影响显著。
The initial temperature of solid heat carrier has great influence on the gas composition.
脱脂则使糊化初始温度和峰值粘度均下降。
Defatting reduces both pasting temperature and peak viscosity.
初始温度。
研究结果可以为加氢站等对于初始温度有要求场合的设计提供参考。
The results can provide reference for equipment design on occasions which has requirement for initial temperature such as in design of hydrogen refueling stations.
当土壤含湿量大、土壤初始温度高时，对于系统的设计与运行是有利的。
More moisture content and higher soil initial temperature are favorable to the design and operation of GSHP systems.
数值模拟显示当等离子体初始温度适度增大时可以得到更高的质子产额。
Simulations show that high proton yield can be obtained by increasing the initial plasma temperature moderately.
浇注温度和砂型初始温度越高，热节处粘塑性应变越大，而热应力越小。
The higher the pouring temperature and initial mold temperature are, the larger the plastic strain while the smaller the thermal stress is.
油藏初始温度对火烧油层驱油效果影响较大，而油藏初始压力则影响较小。
The influence of initial temperature of reservoir is fairly important, and the initial pressure of reservoir is little important.
煤粉气流的着火界限主要受初始温度、点火源温度、煤种和煤粉细度的影响；
The pulverized coal-air flow ignition limit is mainly influenced by such parameters as initial temperature, ignition source temperature, coal rank and the fineness of the pulverized coal.
结果表明，果实初始温度、比表面积、果肉厚度、瓜水比例均影响降温速度。
The results showed that initial fruit temperature, specific surface area, flesh thickness and melon to water ratio affected temperature decreasing rate of melon fruits in well water.
基于混沌变量，提出一种混沌模拟退火优化方法，给出了初始温度的确定方法。
Based on chaotic variable, a chaos simulated annealing algorithm is proposed and the method of defining the initial temperature is given.
计算结果表明，粒子初始温度、半径不同，粒子参数随飞行距离的变化也不同。
The results show that the change is different with the initial parameters of the particles.
此外，液滴下落以前的初始温度也与玻璃形成、晶体的成核和长大有密切联系。
In addition, it is indicated that the initial temperature of the drop before it droped down is related closely to the nucleation and crystal growth of the alloy.
当初始温度不同的二个气块混合时，结果是形成一个具有较高相对湿度的混合物。
When two parcels of air with different initial temperatures are mixed, the result is a mixture with a higher relative humidity.
观察到不同的等离子体初始温度会影响靶前激波的形成时间，进而影响质子产额。
It is found that the time required for the shock formation can be affected by the initial plasma temperature, which influences the energetic proton generation in the shock.
模型中包括有血流和代谢热的影响，且允许生物组织的初始温度高于其相变温度。
In this model, the contribution of blood flow and metabolic heat generation has been included and it is not required that the tissue be initially at its phase change temperature.
然后探讨了初始温度和降温速率等对温度应力的影响以及不同材料的低温抗裂性能。
Then the authors analyse the effect of initial temperature and cooling rate on thermal stress and the low temperature cracking performance of different asphalt cement.
研究证实，二次缺陷形成的初始温度，可近似代表辐照绿柱石的最佳热固色温度点。
The research also indicates that the temperature resulting from the secondary defects may represent approximately the optimum temperature for the thermal color concentration.
可燃气体初始温度和压力对起爆临界马赫数都有影响，但是初始温度的影响大得多。
The critical Mach number is influenced by the initial pressure and temperature, but the temperature is the main factor.
当基准经历一个温度变化且返回初始温度，它们并非总能获得与初始电压相同的电压。
When references experience a temperature change and return to the initial temperature, they do not always have the same initial output voltage.
本文主要考察了电极材料、电流密度、阴极液酸度及料液初始温度对还原效果的影响。
This article mainly describes the influences on the reduction results, such as: the electrode material, electric current density, acidity of cathode liquor and initial temperature of feed liquid.
探讨了不同初始温度、果实大小、成熟度及不同瓜水体积比例对甜瓜预冷速度的影响。
The effects of original temperature, fruit size, maturity and melon to water volume ratio on pre-cooling efficiency of muskmelon in well water have been discussed.
研究两个不同温度的圆柱体在相互热压时，不同初始温度及压力条件下两试件的传热特性。
Tile purpose of this article is to study the heat transfer character of two specimens under different initial temperature and pressure condition as two non - isothermal cylinders contact each other.
热分析中考虑了坯料的初始温度、外加热源和冷却源的热流密度以及坯料和空气的对流传热。
In the thermal analysis, the initial temperature of billet, beat fluxes (heat flow per unit area) of positive and negative value and convections to surrounding air are considered.
温度变化对复合材料板应力场的影响与温度变化幅值、加载方式和初始温度的大小有很大的关系。
The influence of temperature to the composite stress is very complex, it relates to initial temperature, temperature range and the way to give loads.
板坯初始温度的高低对干法纤维板中心层到达胶粘剂固化温度所需加热时间的影响可以忽略不计；
The influence of the original temperature of mat, high or low, to the time spent to heat the center layer to the curing temperature could be neglected;
季节冻土层中的地温呈非线性分布，改变了冻土墙形成时的初始温度条件以及形成后的结构形式。
The existence of the seasonal frozen soil layer provides a favorable environment for the formation of the artificially frozen wall; also it changes the wall's configuration.
在可视化实验中随着prz初始压力的增加，以及CMT初始温度的增加，压力平衡响应时间减小。
In visible experiment, the time of pressure balance decrease with the initial pressure of PRZ and temperature of CMT.
应用推荐