刚性系统就是无法演进或者很难演进的系统，只能停止服务才能实施更改的系统也属于其中。
Rigid systems are ones that can't evolve, or only do so with difficulty and downtime.
人类智能可以学习，扩展和变化，但很多专家系统是刚性的，并且缺乏学习能力。
The human mind can learn, expand, and change, but many of the Expert systems are too rigid and don't learn.
因为是悬臂加工，特别是小孔、深孔及硬质工件的加工时，工具系统的刚性尤为重要。
Because of the cantilever processing, especially the small hole, deep hole and hard workpiece processing, the rigidity of the tool system is particularly important.
最后提出了抑制信息系统刚性的方法，即面向过程的开发方法。
Then it is pointed out that the process-oriented development method is a solution to systemic rigidity.
针对振动状态的不可测量性，应用刚性控制规律设计了控制器，给出了一种补偿系统动力学对位置控制影响的方法。
A rigid controller for the unmeasured vibration states was designed and a compensatory method for the impact on position control caused by system dynamics was given.
本文借助连续系统理论分析了一个放置于刚性物体振源和刚性基础之间的单个隔振器的力绝对传递率特性。
The transmissibility of the isolator placed between a rigid body and a rigid base is analyzed by the use of the continuous system theory in this paper.
将全身CT机的机械回转系统简化成一个刚性转子系统，该系统的静子与支承之间存在间隙。
The rotating system of CT machine is simplified into a rigid rotor system. There exist clearances between the stator and the elastic support.
介绍在刚性连接方式下，用两台交流伺服电机同时驱动同一负载方案的组成、硬件和软件，给出了该系统的实验结果。
Introduce the composition, the hardware and software for two AC servo motors which drive loads simultaneously under rigid connection. Also Present the experimental results.
主轴系统具有很高的刚性和精度。
刚柔耦合多体机械系统动力学微分方程组具有刚性和高频振荡的特点。
The dynamical equations of rigid flexible coupling multibody systems have characters of stiffness and high frequency oscillation.
最后，以一类刚性约束的非线性动力系统为例，揭示了局部映射在其动力学分析中的重要作用。
Finally, an important role of local map is shown in the dynamical analysis of a given nonlinear dynamical system with rigid constraints.
转子-轴承系统中包括弹性轴、刚性圆盘以及具有阻尼和刚性的径向轴承。
The system consists of elastic shaft , rigid disks and bearing which has damping and stiffness.
建立了一类柔性基础、刚性设备的复杂系统主动隔振模型，考虑了设备、隔振器、作动器和柔性基础的耦合作用。
An active isolation model is established for the flexible base and rigid equipment systems, taking account of the coupling of equipment, isolators and the foundation.
在此基础上结合信号采集与预处理处理方法研制出一套针对刚性转子的单片机动平衡测试系统。
An embedded intelligent dynamic balance testing system for rigid rotator is developed based on the methods and theory of data sampling and processing.
我国尚处在单机自动化、刚性自动化阶段，柔性制造单元和系统仅在少数企业使用。
Our country is still at the single machine automation, rigid automation stage, flexible manufacturing unit and system only in a few enterprise use.
用柔性联接器代替旋转系统各转子之间的刚性联接。
The rigid jointer is replaced by the flexible jointer in a revolving system.
本文在刚性转动与量子系统集体转动特征基础之上，提出了一个计算偶偶变形核基态转动惯量的有效方法。
A effective method of calculating moment of inertia at ground state of even-even deformations nuclei is derived based on rigid rotation and collective rotation nature of quantum systems.
这些在1984年系统已经接受各种不同环境和天气情况下的刚性试验。
These systems had received rigid tests in various environment and weather conditions in 1984.
此外，系统本身刚性不足，也会引起压力转换滞后现象的产生。
Furthermore, the hydraulic system lacking of rigidity can also lead to the delay of pressure switch.
企业资源计划（ERP）系统刚性太强是其实施成功率较低的一个重要原因。
The strong rigidity of enterprise resource planning (ERP) system is an important cause of the relatively low success rate of implementation.
其次分析了该系统在刚性条件下稳定运行时各构件的运动情况，求得各传动构件的额定速度、额定角速度等。
Secondly, by analyzing kinematics of members when the system operates stably in the conditions of rigid, acquired velocity rating and rated angular velocity etc.
当拴连卫星系统的拴连约束假设为刚性且无质量时，在构造镇定律时，必须应用有关临界镇定的一些结果。
It is observed that results from the critical stabilization must be applied in the construction of the stabilizing law for a tethered satellite system when the tether is assumed rigid and massless.
用近代非线性动力学理论分析了弹性支承有间隙的非线性刚性多转子系统的复杂运动。
Modern nonlinear dynamical system theory is used to analyze the complicated motion of a nonlinear high_speed rigid multi_rotor system with pedestal looseness.
仿真结果还表明，车辆系统在弹性轨道条件下的运行平稳性优于刚性轨道条件下的运行平稳性。
The simulation results also show that the running stability of the vehicle system under the resilient track conditions is better than that under the rigid track conditions.
基于复杂自适应系统视角提出了核心刚性进化机制模型。
The evolution mechanism model for core rigidities was put forward in complex adaptive system perspective.
本文系统的介绍了和传统刚性管截然不同的埋地柔性管道的设计原则、具体的设计方法。
Detailed design method and design principles for buried flexible plastic drainage pipe which differs entirely from traditional rigid pipe are introduced systemically.
本文针对一类刚性悬臂梁电液位置跟踪系统，提出一种简便、有效的智能控制新方法。
In this paper, a simple and effective control method for electrohydraulic position tracking system in a rigid rotating cantilever beam is proposed by using AI technology.
本文简单叙述了机械阻抗法的概念，系统推证了刚性基础下单级和双级隔振的传递率。
The concept of this technique is given in this paper and the transmissibility for one and two-stage mounting systems supported on rigid foundation is derived systematically.
从铜-镍合金的俄歇谱分析可知，合金能带的刚性能带理论并不适合本研究系统。
The analysis of Auger spectra of Cu, Ni and Cu-Ni alloy also shows that the "Rigid Band Model" is not suitable for Cu-Ni system.
从铜-镍合金的俄歇谱分析可知，合金能带的刚性能带理论并不适合本研究系统。
The analysis of Auger spectra of Cu, Ni and Cu-Ni alloy also shows that the "Rigid Band Model" is not suitable for Cu-Ni system.
应用推荐