分接头控制是换流器控制系统中重要组成部分。
The tap changer control system is important component of converter control system.
同时也考虑了变压器分接头对中低压侧电压的调整。
Voltage adjustment by transformer taps at medium_low voltage supply are also considered.
我们公司提供各种带分接头的线圈，用于不需要防止湿气和溶剂的应用领域。
We produce a wide variety of taped wrapped coils for applications that do not required protection from moisture and solvents.
计算结果提供优化前后的有功总损耗大小、电容器组状态和变压器分接头位置。
Computed results will provide the active power losses, shunt capacitor states and transformer tap values.
仿真与实际运行结果表明，该方法能有效地减少变压器分接头和电容器的动作次数，改善控制效果。
Computational test proves that this approach can validity effectually reduce the adjust times of transformer-tie-in and capacitor, improve the control effect.
该设备向有载分接头转换器连续地提供氮气，并具有通气孔，以保持略高于极端气候条件范围的超压。
The apparatus applies a continuous supply of nitrogen to the load tap changer, and has an orifice to maintain a slight overpressure over an extreme range of climatic conditions.
建立了补偿电容器和变压器分接头的实时控制解决方案，给出了系统框图，并从硬件上实现了该方法。
The real time controlling scheme of compensating capacitors and tap joint of transformer is established, the systematic block diagram is provided, and the hardware based on this method is realized.
电压调整问题包括两个方面，一个是馈线末端电压升问题，另外一个是有载调压变压器的分接头频繁动作或者振荡。
Voltage regulation includes two fields: one is voltage rise near the end of the feeder: another is the tap hunting phenomenon of tap change under load (TCUL) transformers.
在此基础上确定了溪洛渡—株洲特高压直流输电工程换流变压器的额定功率、电压、电流和分接头的变化范围等参数。
After illustrating the operation theory of six pulse converter, author gives the calculating method of UHVDC transmission parameters such as operating power, voltage, current and tap changer range.
本文从电压无功综合控制的基本原理出发，说明了变压器分接头的调节与并联电容器投入容量的大小对电网电压的影响。
The basic theory for voltage and reactive control and the taps changed in transformer and shunt capacitor switched affect the voltage value are discussed in the paper.
首先分析电压无功控制原理，考虑了分接头的变化及电容器组的投切对无功和电压的综合影响，针对电压、无功的各种运行控制区域给出了相应调节策略。
The regulating tactics are provided on different control zone of voltage and reactive power, according to integrated influence of voltage and reactive power with tap change and capacitor action .
该系统控制策略以九区图为基础，并且在容易引起频繁动作的边界上采用人工神经网络预测变压器分接头调节和电容器投切后的电压无功，以决定采用何种控制方式。
The control strategy is based on nine-zone diagram and combined with artificial neural network, which makes a decision about the change of transformer taps and capacitor switching.
这也从分形理论的角度证明了在超塑性固相焊接头的形成过程中，焊接面各微区的焊合状态是非均匀性的。
It is proved by fractal theory that the welded state of every micro zone at welded surface is uneven in the formation process of isothermal superplastic solid-state welding joint.
嫁接头发可能听起来十分不舒服，但却是完全无痛苦的做法。
Attaching hair extensions may sound eye - wateringly uncomfortable , but it ' s a pain - free procedure.
产品各部件采用快速接头和螺纹连接，使用时，装配只需1分钟左右即可连接完备。
Its parts are connected with quick joints and screw threads. When application, they can be assembled completely only within 1 minute or so.
光缆接头筒外形是椭圆型直立式结构设计，筒和底座采用抱箍锁紧固定密封，安装十分方便。
Dome is a vertical type. hoop is used to fix and seal fosc cover and base, and its installation is quite simple.
飞行器。牵引杆附属接头的接口要求。第1部分：干线飞行器。
Aircraft - Tow bar attachment fittings interface requirements - Part 1: main line aircraft.
嫁接头发可能听起来十分不舒服，但却是完全无痛苦的做法。
Attaching hair extensions may sound eye - wateringly uncomfortable , but its a pain - free procedure.
将帘子接头拆开一部分，按原状重新编制，使帘子两端的尺度一致。
Take the connection of the chick partly, reorganize it according to its original order while keeping both ends balanced.
后面的车配备了球窝接头，以便它能够自由流动的倾向后，前面的一部分。
The rear of the bike is equipped with a ball joint so that it can move freely following the leaning of the front part.
飞行器。牵引杆附属接头的接口要求。第2部分：地方飞行器。
Aircraft - Tow bar attachment fittings interface requirements - Part 2: regional aircraft.
电缆接头是电力系统安全运行中的最薄弱环节，实时的掌握电缆接头的运行温度对电力系统的安全运行有十分重要的意义。
The cable joint is the most weakness of power system 'safe operation. So it is significant to inspect the temperature of cable joints on-line.
用短毛刷将配合后的粘合剂分两次均匀涂刷在干燥的接头表面。
Thirdly, apply the mixed adhesive with a short brush, on dried joints surface.
法兰及其接头。PN指定法兰用垫圈的尺寸。第3部分：非金属聚四氟乙烯封装垫圈。
Flanges and their joints. Dimensions of gaskets for PN-designated flanges. Part 3: non-metallic PTFE envelope gaskets.
必须注意，首先要保证焊接头表面十分清洁，因为污物会减弱焊缝的强度。
Care must be taken to ensure that the surfaces are thoroughly clean first, for dirt will weaken the weld.
通过利用自行研制的分束焊接头将一束激光分为能量相当的两束激光，在沿焊缝方向上串联产生了两个焦点。
A self designed welding head is described. The welding head can divide one torch into two equally and the two focuses are in series along the weld.
我公司同样开发生产了规格齐全的土层非开挖钻具，包括导向钻头、分动器、筒式扩孔器、流道式扩孔器、板式扩孔器、变径接头等。
Pangolin also develop and produce a complete range of soil non-excavation drill, including Bit-oriented, sub-actuators, Drum-type Reamer, Flow-type Reamer, Plate-type Reamer, Adjustable joints.
该接头阀优选为回转阀，其可通过相对于接头的另一部分转动接头的一部分来操作该阀。
The fitting's valve is preferably a rotary valve, which can be operated by turning one part of the fitting with respect to another.
该接头阀优选为回转阀，其可通过相对于接头的另一部分转动接头的一部分来操作该阀。
The fitting's valve is preferably a rotary valve, which can be operated by turning one part of the fitting with respect to another.
应用推荐