要设法用表面热电偶检查口模出口温度。
Try checking the die exit temperature with a surface thermocouple.
严格控制冷却水出口温度在结垢温度以下。
Temperature of cooling water outlet shall be strictly controlled below the scaling temperature.
降低挥发物的出口温度，可以降低焦油和气体收率。
The yield of both tar and gas is decreased with the decrease of exhausting temperature of liberated matter.
热运转现象是煤气出口温度过高，超出了规定范围。
Hot running phenomenon is high temperature coal gas exports, beyond the prescribed scope.
该方法还可推广应用到对挤压出口温度等参数的预测。
This method may be popularized to the forecasting of other parameters as extrusive exit temperature.
还增加了煤气出口温度检测，为加煤增加了信息提示。
In addition, temperature detector is also added to the gas exit to give information indicator for adding fuel.
煤气发生炉冷运转现象是煤气发生炉出口温度低于正常值。
Gas occurrence boiler cold running phenomenon is gas occurrence boiler exit temperature below normal.
图6示出了出口温度与坯料位置和挤压速度关系的一组曲线。
FIG. 6 shows a set of curves for exit temperature as a function of billet location and extrusion speed.
分析了超临界锅炉水动力特性对下辐射区水冷壁出口温度的影响。
The influence of supercritical boiler's hydrodynamic characteristics to the outlet temperature of water wall's lower radiation zone is analyzed.
探讨了灰色预测模型GM(1,1)在磨煤机出口温度预测中的应用。
The application of Grey models GM (1, 1) in the exit temperature prediction of coal pulverizer is discussed.
结果表明炉出口温度是最关键因子，为工艺员制定工艺参数提供了依据。
The results showed that temperature of the exit of the distillation furnace is the most key factor. This study has provided references for technicians to select technology parameters.
根据管式裂解炉的特点，提出了一种管式裂解炉出口温度优化控制方法。
According to the characteristic of the pipeline cracking furnace, a new neural network optimization control strategy of cracking furnace′s output temperature is put forward.
介绍大型转炉干法除尘中的核心控制系统——冷却器出口温度自动控制系统。
Automatic control system of cooler outlet temperature is introduced. It is a core control system in dry dedusting of large converter.
结果表明，空塔速度对冷凝效率及成酸浓度影响最大，冷凝器出口温度次之。
The results showed that the condensation efficiency and the sulphuric acid concentration were affected by superficial velocity considerably, then the condensation temperature.
此测量方法已通过实验验证，并得到了用于计算堆芯冷却剂出口温度的经验公式。
This measuring method has been tested by experiments, an empirical formula is for evaluating the core coolant temperature has been obtained.
通过理论和经验数据相结合的方法确定了试验台的热流量、出口温度及压力等参数。
Based on the combination of theory and empirical data, defined the thermal flux, exit temperature and pressure of the experimental bench, and so on.
其中进口温度对板栗粉得率影响最明显，其次是料液浓度，而出口温度的影响最小。
The entrance of temperature obviously affected the rate of power of Chinese chestnut, the next was density of materials, and the last one was the exit of temperature.
结果表明，气体冷却器出口温度、过热度和膨胀机效率对最优高压压力的影响较为明显。
It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.
某炼厂焦化炉注蒸汽控制系统不能正常运行，注汽量突增造成炉管出口温度大的反向响应。
The response of the outlet temperature to the sudden steam increasing is a large inverse response.
人机界面液晶触摸屏控制，可控制进出口温度、气流、空气压力、自动疏通阻塞频率和流量等。
Using proface touchable interface display operation, operator can control temperature, airflow volume, air pressure, pump speed and de-blocker frequency.
为此分析了点火过程中一次风速、煤粉浓度、磨煤机出口温度和煤粉细度等对等离子点火的影响。
Meanwhile analysis was made on how primary air, concentration of pulverized coal, mill outlet temperature and pulverized coal fineness affected ion ignition.
结果，轧机的入口温度较高，实现了在给定的精轧出口温度较低，以及在奥氏体范围内更薄的压力表。
As a result, higher mill entry temperatures, lower mill exit speeds at a given finishing temperature and thinner gauges in the austenite range could be realized.
通过改变集热管进口空气流量来获得尽可能高出口温度的热空气，从而降低热损系数，提高集热效率。
Through experiments of changing the inlet air flow rate, we can adjust the hot air outlet temperature as high as possible, which helps to reduce the heat loss and improve the collector efficiency.
研究结果表明：在发生静态流量漂移时，系统循环流量下降、加热段的进口温度下降而出口温度上升；
The experimental results show that in the process of flow excursion the mass flow rate and the inlet temperature decreases, while the exit temperature increases smoothly.
在冷却介质出口温度或传热温差选定的情况下，可以由第二个条件计算满足热稳定性的平均停留时间。
When the outlet coolant temperature or heat-transfer temperature difference is chosen, the acceptable mean residence time can be calculated by the second limiting condition.
后冷却器出来的压缩空气在其出口温度下应该是水蒸气饱和的，且气流温度应该是压缩空气的压力凝露点。
After cooler out at the exit of compressed air temperature should be saturated steam, and air temperature should be pressure of compressed air condensation point.
在集热器型太阳能干燥装置中，常由于集热器的进口温度低，出口温度达不到干燥工况要求，而影响生产。
In the dry equipment of the import temperature of collector is often so low which makes the ex port temperature not fit the dry work condition, that the product is influenced.
在集热器型太阳能干燥装置中，常由于集热器的进口温度低，出口温度达不到干燥工况要求，而影响生产。
In the dry equipment of the import temperature of collector is often so low which makes the ex port temperature not fit the dry work condition, that the product is influenced.
应用推荐