提出了预防屏式再热器爆管的有效措施。
The measures to prevent reheater tube failure are presented.
未经清洗的过热器、再热器应进行蒸汽加氧吹洗。
The uncleaned superheater, reheater should have oxygenated blowwash.
用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。
For manufacture wall panel, economizer, reheater, superheater and steam pipeline of boilers.
用于锅炉水冷壁、省煤器、再热器、过热器和蒸气管道的制造。
For manufacture water wall panel, economizer, reheater, superheater and pipeline of boilers.
为解决锅炉水冷壁结焦所引发的二次再热器超温爆漏问题提供了依据。
It also provides the basis for solving the bursting leakage by ultra high temperature of the secondary reheater due to the slagging on boiler water wall.
通过试验得到屏式再热器的壁温分布，分析试验结果找出超温的再热器管。
Through tests, the wall temperature distribution of platen type reheater has been obtained, and the over-temperature of reheater tube being known from the analysis of test results.
锅炉集箱中的流体均匀分布是锅炉过热器，再热器安全设计的关键技术之一。
The uniform distribution of flow in a boiler header constitutes one of the key technological factors ensuring the safe design of boiler superheaters and reheaters.
介绍广东深圳岭澳核电站汽水分离再热器射线底片的运输包装及底片盒的标识方法。
The packing method of radiographic films and identification of containers of the MSR(moisture seprarator reheater)for Lingao nuclear power station is introduced.
重点介绍了再热器爆管的检修处理以及为避免此类故障发生而采取的技术组织措施。
It also gives repair measures and technical procedures for avoiding such kind of breakdowns later on similar boilers.
本文针对汉川电厂1、2号炉末级再热器爆管问题，分析了爆管原因，提出了改进措施。
Based on analysis of the cause of tube explosion, which frequently happens on the hot stage reheater of boilers No. 1and 2 in Hanchan power Plant, authors put forward improvement measures.
采用外螺旋肋片管实现高温侧强化传热后，再热器管壁温度升高，所需贵重金属耗量增加。
The temperature of the tube went up and then the expenditure of expensive alloy increased by using extern spiral finned tube, which enhanced the external heat transfer.
经改进屏式再热器连接方式并减少受热面后，消除了屏式再热器超温，保证了机组安全运行。
Through improving the connection mode of platen reheater and decreasing the heating surface, the overheating of platen reheater was eliminated and the safe operation of unit was ensured.
该新方法更精确的反映了锅炉过热器、再热器壁温分布的内在本质，并使计算方向趋向简明。
This new method predicts the distribution of the super-heater and re-heater's tube temperature more precisely, and the concept of the calculation is more concise.
分析了北仑发电厂600M W锅炉再热器局部超温及旁路改造未能达到预期效果的原因；
The causes for local overtemperature of high temperature reheater of 600 MW boiler in Beilun Power Plant and that bypass retrofit could not realize the expected effect are analyzed;
导出了在再热机组中，排挤单位非调节抽汽流经再热器流量份额的通用计算式，并进行了验证。
A universal formula is raised to calculate flow of reheater when a unit of work substance is pushed out from extraction steam in reheating unit, and verified...
导出了在再热机组中，排挤单位非调节抽汽流经再热器流量份额的通用计算式，并进行了验证。
A universal formula is raised to calculate flow of reheater when a unit of work substance is pushed out from extraction steam in reheating unit, and verified by examples.
在进行了详细的计算分析后，发现主要是由于低温再热器进口流量分配器流量分配系数太小所致。
After a detail calculation and analysis, the reason that the flow distribution coefficient of a flow divider in the primary reheater was too small had been found.
核电站用汽水分离再热器结构复杂，无损检测按英国国家标准和法国ALSTOM公司工程标准进行。
The moisture separator reheater which used in nuclear power station was a complex structure, the NDT was according to British standards and French ALSTOM project standards.
本文提出了用炉内模化试验结果推算对流过热器和对流再热器沿烟造宽度各片出口汽温偏差的一种方法。
A method is presented to deduce steam temperature deviation alcmg flue's width at the outlet of each platen in convection superheaters and reheaters by making use of furnace model test results.
分析循环流化床锅炉运行中出现的高温再热器、二级过热器爆管和给煤系统旋转给料阀经常堵煤等问题。
The causes of SH and RH tube explosion and coal feed system jamming in the operating CFBB are analyzed.
比较了核电机组与火电机组再热系统的不同特性，阐述了重水堆核电机组汽水分离再热器系统的流程和控制。
In this paper, the reheater difference between nuclear power plant and coal-firing power plant was given, and the MSR system's craft and control for nuclear power plant was also discussed.
过热器再热器壁温在线监测技术，可以通过安装少量的炉外壁温测点，实时计算整个管组各部位的金属壁温。
The superheater and reheater on-line metal temperature monitoring technique used a limited number of metal temperature measuring points situated outside of the.
大型循环流化床锅炉高温再热器中所采用的不锈钢膜式壁管屏的制造工艺要点和难点，以及解决的工艺措施。
The article describes the critical and hard parts and technology measures of stainless steel membrane panel's manufacture, which be used in high temperature Reheater of large capacity CFB boiler.
该文介绍引进型300MW机组锅炉、再热器系统经改进，减少再热蒸汽流量偏差和温度偏差的实炉试验结果。
The paper describes the test results of improvement effects on a licensed 300mw set's boiler and its reheater for the purpose of diminishing reheater's mass flow and temperature deviations.
汽水分离再热器（MSR）是核电站常规岛中较复杂的设备，它的技术含量高、制造难度大，一般均在国外制造。
Moisture Separator Reheater (MSR) is a complicated equipment in conventional island of a nuclear power station , it is made in abroad because it contains high technology and difficult manufacturing .
MW锅炉的偏差温度是引起再热器爆管的一个重要原因，在再热器系统表现为沿炉宽方向右1/4区域汽温较高。
The deviation is a important reason causing reheater tube failure of 300MW and 600MW boiler. It is experienced that steam temperature is higher at right 1/4 area of reheater system.
对低温再热器、过热器、凝汽器内氧化皮形成的原因进行了分析，并根据经验介绍了避免氧化皮脱落所采取的措施。
This paper analyzes forming cause of the oxide skin in low temperature reheater, superheater and condenser, and introduces the measures taken to avoid drop of oxide skin on the basis of experience.
对低温再热器、过热器、凝汽器内氧化皮形成的原因进行了分析，并根据经验介绍了避免氧化皮脱落所采取的措施。
This paper analyzes forming cause of the oxide skin in low temperature reheater, superheater and condenser, and introduces the measures taken to avoid drop of oxide skin on the basis of experience.
应用推荐