运动的变换不是必须共面的，也不必须是同心的。
The motion transformation is not necessary coplanar, nor must it be concentric.
当两个物体的面比较接近时，会出现共面的闪烁现象，将大面模型的共面区域掏空。
If the faces of two objects are close enough, the Shared plane will flash.
每一单元具有基底和远侧顶点，当该远侧顶点投影到与该基底共面的平面上时，偏离该基底的中心。
Each unit has a base and a distal apex that is off-center from the base when projected on to a plane that is coplanar with the base.
采用不共面的非线性定标模型和考虑运动不确定性的三维重建方法，能恢复逼真的三维人体骨架模型。
A non-coplanar nonlinear calibration model and a reconstruction approach taken uncertainty into consideration are applied to restore 3d human skeleton model.
分析空间四边平面加工过程中产生不共面的原因，提出了合理标注空间平面尺寸的方法并阐述了其理论根据。
The reason for noncoplane generated by space four latera during machining is analysed. The way for rational marking standard space plane dimensions and its theoretical bases are expounded.
每一单元具有基底(401)和远侧顶点(406)，当该远侧顶点投影到与该基底共面的平面上时，偏离该基底的中心。
Each unit has a base (401) and a distal apex (406) that is off-center from the base when projected on to a plane that is coplanar with the base.
本文提出了由一条二次曲线和与该二次曲线不共面的两条异面直线为导线，与该三导线均相交的直线轨迹是一个直纹四次曲面，并讨论了二次曲线分别为椭圆、双曲线和抛物线时，形成的曲面的形状特征。
In this paper, it is presented that the locus of a line crossedwith each of two guide lines and a guide conic not being on a commonplane is a ruled surface of fourth order.
本文提出了由一条二次曲线和与该二次曲线不共面的两条异面直线为导线，与该三导线均相交的直线轨迹是一个直纹四次曲面，并讨论了二次曲线分别为椭圆、双曲线和抛物线时，形成的曲面的形状特征。
It is presented that the locus of a line crossed with each of two guide line and a guide conic not being on a common plane is a ruled surface of fourth order.
利用棋盘格角点共面特点，将平面到平面的变换引入到角点检测中，实现了角点的自动粗定位。
Since X - corners coplanar, a plane - to - plane transform is introduced and rough location of X - corners is realized.
利用棋盘格角点共面特点，将平面到平面的变换引入到角点检测中，实现了角点的自动粗定位。
Since X - corners coplanar, a plane - to - plane transform is introduced and rough location of X - corners is realized.
应用推荐