接下来用紫外光射透石英板，使液体硬化成聚合物，再将晶片做进一步的完成步骤。
The mold is then set down atop a layer of a liquid monomer on the surface of a chip.
为了计算出射光瞳，可将孔径(单位mm)除以目镜的放大倍数。
To calculate exit pupil, divide the aperture (in mm) by the power of the eyepiece being used.
越多的光直接出射而没有被反射器反射后再出射的话，就会得到更高的效率。
The more light that exits directly without being controlled by the reflector, the higher the efficiency.
虽然还要经过衍射过程，但是这样，出射光便可以被更好的转换为特殊形式的室内光。
A diffraction process is also used, but in this case, the light output can be more finely turned to produce particular internal light patterns.
结果表明将三个因素良好的结合来达到更高的取光效率和良好的出射光均匀性，将是今后研究的重点。
The results indicate that how to combine the three factors to achieve higher efficiency and good uniformity of emergent light will be the focus of future research.
在此基础上，对采用基尔霍夫近似进行自仿射分形随机表面的散射光场数值计算的精确程度进行了研究。
Then we study the accuracy of Kirchhoff's approximation in the scattering of light field from the random self-affine fractal surface.
通过分析水平分光光路和保偏光纤特性，找出产生对射光功率波动的原因，并给出一种简单实用的解决方案。
By analyzing the horizontal optical system and the feature of PMF, we found the reason and report a simply but available project for the problem.
角分辩的光散射轮廓及自仿射分形表面的粗糙指数的实验研究。
Experimental Study on Angle-resolved Light Intensity Scattered Profile and Roughness Exponent of Self-affine Fractal Surface.
从折射定理出发，给出旋转双光楔的入射光线和出射光线之间的对应关系。
Starting from refraction theorem, the corresponding relation between incident light and outgoing light of the rotating double optical wedges is given.
准光模式变换器主要采用矢量绕射理论和几何光学理论，并结合两种理论设计复杂反射曲面。
Quasi-Optical Mode Converter is mainly adopted vector diffraction theory and Geometry optics theory, and the numerical results of complex reflector are analyzed.
亚微米光栅型导光板通过光栅空频控制出射光方向、控制槽深调节衍射效率，达到导光板出射光强的均匀性。
The transmission angle is controlled by grating frequency and the diffraction efficiency is controlled by groove depth of sub-micro gratings to get uniformity of transmission filed.
光的性质、波动光学、几何光学及高斯近似、光的干涉、相干性、光的偏振、光的绕射、一些重要的应用实例。
Nature of Light, Geometrical Optics, and Gaussian Approximation, Wave Optics, Interference of Light, Coherence, Polarization of Light, Diffraction of Light.
受激射效应影响，消光比及频率啁啾在弛豫振荡频率处达到极大值。
Due to the lasing effect, the peak modulation frequency of extinction ratio and chirp occur at the relaxation oscillation frequency.
四极子量子级联微腔激光器带来的光的方向性激射，解决了对称型微腔激光器光的方向性激射的困难。
Directional emission of light guided by quadrupolar-shaped quantum cascade microcavity lasers solves the difficulty about the directional emission of symmetrical microcavity lasers.
借助于纤端出射光场的光通量分布函数，分析了该传感器的补偿机理。
The output optical field distribution function of the fiber end is ussd to analyze the compensation mechanism of this sensor.
通过设计特别的前向散射实验得到了此配置下由于晶体出射面对入射光的反射造成的背向散射的强度。
In the special experiment designed by ourselves we obtained the backscattering signal excited by the laser light reflected by the sample's rear surfaces.
采用“光重心法”对光纤出射光斑信号进行处理，获取光纤端部的位置特征。
The light center of gravity method is applied to processing optic fiber exited spot signal for acquiring the position features of optic fiber ends.
介绍一种根据出射光平行度要求计算斜方棱镜面形误差的方法。
A calculation method to calculate the surface shape error of rhombic prism according to parallelism demand of emergent beam is introduced.
模拟结果表明，对于这种脉冲激光，光化学中双光子反应主要是由起始时未被充分散射和吸收的脉冲所驱动，而单光子反应是由经散射后的浸射光所驱动。
For the impulse, the two-photon reactions were dominated by the initial primary (unscattered and unabsorbed) pulse and the single—photon reactions were dominated by the scattered diffuse light.
信号光在耦合器中发生干涉，经过整形的信号光脉冲从脉冲整形器的出射端出射，信号脉冲的波形由非线性附加相移的波形决定。
Signal laser interferes in fiber coupler, then shaped signal pulse transmits from output port of this pulse shaper. Signal pulse's waveform is determined by the profile of the nonlinear phase shift.
可精确定位发射器：导向射束可精确表明需进行X光检查的区域。
For exact positioning of the emitter: the pilot beam indicates exactly which area will be X-rayed.
半导体激光器发出的激光经过柱透镜形成一出射光片。它与母材成一定角度投射到接头上，光片与搭接接头会成一单光纹，而母材垂直上方的CCD摄像机拍摄折线光纹，同步送计算机处理。
The light-plate that is shot by semiconductor laser comes to a certain Angle to throw overlap joint, which brings a single vein of light, and CCD camcorder shoots and sends it to the computer.
全光线是由对射的红外线光线和接收器组合成的，共有单光和双光两个光束组成。
The whole light is composed of a pair of infrared rays and receivers, consisting of two beams of single light and double light.
分析了线偏振光垂直入射到角锥棱镜经三个直角面依次反射后出射光线偏振态的变化。
The polarization variation of a reflector light after a bundle of linear polarization light is incident on the ideal cube corner retroreflector is analyzed.
在对染料以及光致荧光理论知识分析和讨论的基础上，提出了一种新的测试液体激光染料激射寿命的方法。
Based on the theoretical analysis of the dye and the photo-induced fluorescence, a new method for testing the liquid laser dye's lasing lifetime was introduced.
控制器驱动外部NPN晶体管的射极，并与变压器串联构成反激式拓扑，系统通过变压器和光耦实现离线式的要求。
It drives the emitter of an external NPN transistor, and series with transformer to consist a flyback topology. The system is offline through the use of transformers and optocoupler transistor.
研究表明，所制备的体散射导光板样品的出射光主要分布在偏离出光面法线一定角度的方向上，具有良好的光学均匀度。
The results show that the output light mainly distributes in deviation from the normal of LGP at certain angle direction and a good uniformity of intensity can be achieved.
研究表明，所制备的体散射导光板样品的出射光主要分布在偏离出光面法线一定角度的方向上，具有良好的光学均匀度。
The results show that the output light mainly distributes in deviation from the normal of LGP at certain angle direction and a good uniformity of intensity can be achieved.
应用推荐