在低碳范围几乎得到全部贝氏体组织。
Within the low carbon range the whole bainitic microstructure is available.
离体组织压缩实验验证了该模型的有效性。
The validity of the model was examined by tissue compression experiments in-vitro.
提出了划分低碳贝氏体与高碳贝氏体组织的建议。
And a new way is suggested to classify the bainite structures morphologically. into "low carbon bainite"...
结论：应尽量保存牙体组织，其不足部分用核桩恢复。
Conclusion to save the tissue of tooth and restore the defect with cast post-core.
实验结果表明，采用应变诱导轧制可显著细化铁素体组织；
The results showed that the ferrite grain can be refined by strain induced transformation.
方法：在整体动物和离体组织观察et作用和牛磺酸的拮抗作用。
Methods: the action of et and the influence of taurine in the experiments of animals and isolated tissue were observed.
牙齿磨损是指在没有菌斑、龋坏及外伤情况下牙体组织丧失的现象。
Tooth wear is defined as the loss of the tooth substance which is not caused by dental plague, caries and injuries.
结果表明，当获得针状铁素体组织时，钢板具有最佳的综合力学性能。
The results show that the steel plate has excellent integrated mechanical properties, when it obtain the acicular ferrite.
论证了所谓粒状贝氏体组织实际上是这种演化过程的阶段性组织特征。
It is proved that the so-called granular bainite microstructure is nothing else but the structural characteristic at a certain stage of this evolution.
实物台架试验表明，细小多边形铁素体组织的钢板具有更高的疲劳性能。
Saddle test also shows that the steel plate with fine and polygonal ferrite structure possesses long fatigue life.
只有到后来，离体组织减少到它们的最小体积而产生最大的相对生长速率。
Only later were the tissue isolates reduced to their minimum size to produce the maximum relative growth rates.
简要介绍了宝钢试制的以针状铁素体组织为特征的X80级管线钢热轧板卷。
It represents the trial manufacture of grade X80 pipelines steel hot rolled coil with characteristic of acicular ferrite at BaoSteel Mill.
方法：在表面麻醉下切除肥大的扁桃体及腺样体组织，并给予围手术期精心护理。
Methods: Cutting hypertrophic tonsil and adenoid tissue under superficial anesthesia, offering perioperative nursing care.
比较纤维桩核系统和金属铸造桩核系统修复后牙体组织的抗折裂强度和折裂模式。
Objective To compare the fracture resistance and fracture modes of teeth restored with four diferent post-and-core systems.
采用大的线能量焊接，形成较多的上贝氏体和粒状贝氏体组织，对改善接头性能有利。
With large welding heat input, more upper Bainite and granular Bainite form, which is benefit to improve the property of HAZ.
结果表明，铁素体组织随变形道次的增加逐渐演变为等轴状大角度晶界的亚微晶组织；
The results indicate that the initial ferrite microstructure gradually developed into the equiaxed submicrometer grain microstructure with high angle boundaries with increasing the pass number.
残留细胞注射部位形成畸胎瘤，瘤体组织中存在成熟的内胚层、中胚层和外胚层组织。
The residual cells were able to form teratoma at the injection site, and mature endoderm, mesoderm and ectoderm tissues could be found in teratoma tissues.
而要利用组织培养对离体组织进行染色体加倍，首先要建立高效的组织培养再生体系。
If artificial chromosome doubling in vitro is used, a high-efficient tissue culture system must be established.
方法：运用纤维蛋白平板的方法对19例慢性扁桃体炎患者的扁桃体组织进行初步研究。
Method:We primarily researched the 19 tonsils from patients of chronic tonsillitis by the method of fibrin plates.
这个日本的研究小组使用了老鼠的干细胞——有能力转变为多种体组织的未成熟的细胞。
The Japanese team used mouse stem cells - immature cells that have the ability to turn into many types of body tissue.
结果表明，钢中魏氏体组织、非金属夹杂物及带状组织是导致冲击性能偏低的主要原因。
It is resulted Widmanstatten structure, inclusion and banded structure are mainly reasons causing impact property lowness.
结果表明在相当大的冷却速度范围内，可获得稳定体积百分含量的细片状珠光体加铁素体组织。
The result shows that in a great scope of cooling rates, constant percentage of fine pearlite and ferrite can be obtained.
与马氏体组织相比，由贝氏体铁素体和残余奥氏体组成的准贝氏体组织，其光滑及缺口疲劳强度均较高。
The results shows that the smooth and notch fatigue strength of the meta-bainite consisting of bainite ferrite and retained austenite is higher than that of martensite.
试验结果及分析表明：调整珠光体- 贝氏体组织比例能够提高合金结构钢耐海水腐蚀性能和力学性能。
Possibility of improving seawater corrosion resistance for alloyed structure steels by the adjusting ratio of ferrite to bainite microstructure has also been discussed in this article.
该铸态贝氏体钢通过合金化和控制冷却速度的方法，不需热处理而在铸态下直接得到贝氏体组织和所需性能。
The new bainitic steel formation and its required characteristics were obtained directly in the casting phase without any heat treatment, by the way of alloying and controlled cooling.
试验结果表明，该钢在空冷条件下可获得均匀的粒状贝氏体组织，具有良好的耐回火性和较高综合力学性能。
It shows that even granular bainite structure can be obtained in the condition of air quenching. The temper resistance is better and comprehensive mechanical properties of the steel are higher.
使用TEM研究了钢中贝氏体的精细结构及碳化物的形貌与分布，加入微量元素使贝氏体铁素体组织明显细化。
The fine structure of bainite and the morphology and distribution of carbides in steels were investigated with TEM.
试验钢由针状铁素体和少量块状铁素体组成，焊缝为典型的针状铁素体组织，焊接热影响区粗晶区以粒状贝氏体为主。
The toughness of weld metal is the highest while the coarse grained region in the HAZ is the lowest because of welding thermal cycle and formation of brittle microstructure.
该方程不仅适合微合金中碳钢的铁素体和珠光体组织，而且也适合高碳微合金钢的珠光体组织和低碳微合金钢的铁素体组织。
The equations suit not only ferrite and pearlite in microalloyed medium carbon steel but also pearlite in high carbon microalloyed steel and ferrite in low carbon microalloyed steel.
该方程不仅适合微合金中碳钢的铁素体和珠光体组织，而且也适合高碳微合金钢的珠光体组织和低碳微合金钢的铁素体组织。
The equations suit not only ferrite and pearlite in microalloyed medium carbon steel but also pearlite in high carbon microalloyed steel and ferrite in low carbon microalloyed steel.
应用推荐