交流位置伺服系统广泛应用于工业控制系统中。
The AC position servo systems are extensively used in the industrial control systems.
采用永磁同步伺服电动机，构成多管火箭炮交流位置伺服系统。
The permanent magnetism synchronous servomotor was adopted to construct the AC position servo system of multiple launch rockets.
本文提出了一种新颖的以脉冲序列为位置给定、采用矢量控制方式的永磁同步电动机交流位置伺服系统。
A novel high performance AC servo system with permanent magnet synchronous motor (PMSM) using vector control is presented. A 8096 single chip microcomputer is used as the controller and operator.
利用神经元的自学习功能实现神经元控制器的在线学习，并以神经元控制器作为交流伺服系统的位置调节器；
The neuron controller with its self-learning ability can realize the on-line learning algorithm, and it is adopted as the position controller of the AC servo system.
重点介绍了永磁交流伺服系统的控制策略，位置检测和辨识、主电路和驱动技术等关键技术。
This article introduced emphatically the control strategy, position detection and identification, drive technique as well as main circuit of permanent magnet Ac servo system.
理论分析和仿真结果表明，该控制器可使交流伺服系统具有良好的位置跟踪特性和强的鲁棒性。
Theoretical analysis and simulation results show that the controller can make AC servo systems have good characteristic in position tracking and strong robustness is presents is this paper.
交流伺服系统检测电路由电流、电压、转速及位置检测电路组成。
Test circuit of AC servo system was composed of current test circuit, voltage test circuit, speed and position test circuit.
主要分析了用模糊自适应PI控制构成永磁同步电机交流伺服系统的位置环。
The position control loop composed of self-adjusting PI control based on Fuzzy inferences in AC servo system of permanent magnet synchronous motor was discussed emphaticaly in this paper.
实验表明：双闭环的永磁数字交流伺服系统拥有很高的速度和位置控制性能。
Experiments show that the two-loop Servo System has good performances in speed and position control.
介绍一种无位置、速度传感器的交流伺服系统的设计方法，它采用自适应滑模观测器来估算转子的位置及速度。
This paper introduce a method to design the no-place, velocity sensor ac servo system, use self-adapt slid mode observer to estimate the place and velocity of rotor.
针对交流伺服系统的位置控制，设计出一种新型滑模控制器，以前馈信号作为平均控制，采用模糊推理来调节开关控制的幅度。
A new slide mode controller is designed for AC servo system. The feed forward signal is used as average control, and fuzzy inference is used to regulate the magnitude of on-off control.
在永磁同步电机交流伺服系统中，采用直接转矩控制及模糊自适应PI控制构成位置伺服控制器。
For AC servo system of permanent magnet synchronous motor (PMSM), the position servo controller was constructed with direct torque control and self-adjusting PI control based on Fuzzy inferences.
针对矢量控制交流感应电机伺服系统，提出并设计一种模糊滑模pd型位置控制器。
This paper proposed a fuzzy sliding PD-type position controller for vector controlled induction motor servo drive.
针对矢量控制交流感应电机伺服系统，提出并设计一种模糊滑模pd型位置控制器。
This paper proposed a fuzzy sliding PD-type position controller for vector controlled induction motor servo drive.
应用推荐