论述了水力旋流器下锥筒的磨损规律及其分离效率下降的原因；
This article discusses the wear pattern of the lower cone of a hydroclone and the causes of the drop of its separating efficiency.
研究了在外载荷作用下锥齿轮传动转子系统纵弯扭耦合振动的不平衡响应。
The unbalanced responses of bevel geared rotor system under external torque in the coupled axial-lateral-torsional directions were studied.
方法在CT引导下，微创锥颅及用血肿液化剂清除硬膜外血肿。
Methods Under the guidance of CT, micro-wound cones cranium and using hematoma- liquefier clearing epidural hematoma.
在不同的工作锥角度下，比较镀锌钢丝拉拔后的抗拉强度、锌层质量、模子寿命。
The tensile strength, zinc coat mass and service life of die of galvanized steel wire after drawing are compared on the condition of different work cone angle.
如果是这样的情况下，您可能需要有一个锥活检。
在那些含铅玻璃料似乎必不可少的情形下，建议至少在03锥级下烧制釉料，以确保铅与釉料中的成分反应充分。
In those cases where leaded frits seem necessary, it is recommended to fire to at least cone 03, to ensure sufficient reaction of lead and glaze ingredients.
基于静力学原理和地下流体的运动规律方程，建立了底水油藏水锥体侧斜面为曲线情况下的水锥高度模型。
Based on static mechanism and kinetic equation of underground fluid, the model for calculating the height of the water cone with curvilinear side surface is established.
在旋转想搬到一个圆形路径下更大的破坏磁铁。这是部分原因锥摆动。
The Spinner wants to move in a circular path under the larger destabilizing magnet. That is in part why the cones Wobble.
运用通有的方法，研究了在锥变化和挠动的意义下向量优化问题解的上半连续性。
The purpose of this paper is to study the upper semi-continuity on their solutions of optimisation problems on the cone.
研究结果表明，含有锥齿电极结构的电极放电相对均匀、稳定，且在相同的外加条件下具有更高的功率注入效率。
It is shown that, the configuration consisting of cone electrode is relatively homogeneous and stable which has higher power input efficiency under the same applied voltage.
使用修改移植的MCSAP有限元分析程序对某高速弧齿锥齿轮进行了离心载荷下的变形和应力的分析。
MCSAP program was applied to the finite element analysis for the stress and deformation of a high-speed Gleason spiral bevel gear under centrifugal load.
利用耦合模理论分析了在双锥光纤耦合区中声光的相互作用，讨论了在不同耦合区半径下扰动周期与声波频率的关系。
The acoustooptic interaction in biconical optical fiber was analyzed based on coupled mode theory, and the relationship between perturbation period and flexural wave frequency was discussed.
保留锥P为正规锥，将增算子A减弱为弱连续。空间E减弱为弱完备，在条件减弱的情况下，仍然得到了增算子不动点的存在性。
In this paper, we retains the cone P normal cone, increasing operator A weaken the weakly continuous operator, space E weaken the weak complete space.
在摩擦角小于半锥角的情况下，给出了极限承载能力的近似计算公式。
The approximate formula for limit load is found when the fraction angle is less than the half conical one.
不同加载时间下的静态加载试件强度下降的差异无统计学意义，同时不伴随内锥状裂纹的产生。
No significant difference in the strength degradation among all static loading specimens and no inner cone cracks occurred in static loading specimens.
该方程适用于滚子为柱型或锥型凸轮为槽定位或脊定位、单头或多头、左旋或右旋、上转或下转的情况。
The equations is used whether roller is column or cone, cam is in spine or groove location, left or right helical, single head or many heads and how it is turning.
对水轮机模型，测取了从直锥段进口至尾水管出口8个截面共26个测点在6个稳定运行工况下的水压力脉动数据。
In the experimental study, the pressure surge data are acquired at 26 points from the taper pipe intake to the draft tube exit distributing at 8 sections under 6 stable operating conditions.
通过水压力脉动数据的FFT频谱分析，研究了直锥段和尾水管内部在不同位置不同工况下的压力脉动在时域及频域上的变化规律。
With the FFT analysis it is analyzed that the pressure surge changing laws in the taper pipe and draft tube in time domain and frequency domain.
论证了在一定条件下，排种器锥孔中的压力和速度分布可以近似的按角形域进行分析和计算。
In certain conditions pressure and velocity distribution of air flow inside the conical holes of the seed-metering wheel can be analysed and calculated approximately as in an angular region.
锥齿轮在高转速下，在槽底的离心应力和振动应力的组合应力是引起齿轮破坏的主要原因。
At high gearing speed the combined stresses of centrifugal load and resonance vibration at the notches are the main cause for the catastrophic failure of the bevel gear.
目的探讨单纯锥颅引流治疗慢性硬膜下血肿手术疗效。
Objective to explore the operation effect of simple awl cranium drainage in treating chronic subdural hematoma.
本文用三维光弹性法分析锥齿轮在扭矩和离心载荷下的应力分布。
The three-dimensional photoelasticity method is used to analyze the stress distribution in the bevel gear under torsional moment and centrifugal load.
通过对可行域定义新的拟锥条件，给出相应同伦方程，并证明此同伦算法在此拟锥条件下具有全局收敛性。
We defined the new quasi-cone condition, established the homotopy equation and proved the global convergence of this homotopy method.
结果腹腔镜下可清晰观察到侧锥筋膜和融合筋膜。
Results Under laparoscope lateral conal fascia continues from the fascia of quadratus lumborum at its lateral border.
完整井情况下的锥探灌浆，其渗入型式可按单向渠道网络模型下的竖向渗流形式来考虑。
For a full well excavated down to the impervious stratum, the penetrating pattern could be considered as a model of canal network according to the seepage laws of vertical flow.
光弹性试验结果表明锥齿轮在两种载荷分别作用下，齿根应力分布是不同的。
The results show that the stress distributions in roots of the bevel gear are different under respective loads.
通过在齿根贴电阻应变计，测量了在不同载荷下螺旋锥齿轮的重合度。
Using strain gauge at roots of the teeth, the contact ratio of gears is measured under different loads.
数值模拟了不同海拔高度、不同来流速度、不同弹丸头部半径、不同半锥角条件下弹丸的烧蚀情况，给出了弹丸按时间顺序排列的烧蚀外形图。
At the conditions of different altitudes, velocity, shapes, the deformation of projectile are numerical simulated. The ablation profiles of the projectile are given in chronological orders.
数值模拟了不同海拔高度、不同来流速度、不同弹丸头部半径、不同半锥角条件下弹丸的烧蚀情况，给出了弹丸按时间顺序排列的烧蚀外形图。
At the conditions of different altitudes, velocity, shapes, the deformation of projectile are numerical simulated. The ablation profiles of the projectile are given in chronological orders.
应用推荐