伪随机码在扩频通信中得到广泛应用。
The pseudo random noise ranging code has been applied extensively to spread spectrum communications.
在计算机通讯中,可采用伪随机码技术来进行识别。
In computer communications, the pseudo - random code technique is used for recognition.
达到高精度的关键是应用了伪随机码扩谱及差分定位技术。
Spread-spectrum PN code ranging and differential Positioning technology are used to make it possible to reach such accuracy.
为了解决上述问题,我们研制了基于伪随机码调制的超声波测距。
In order to solve the above problems, we develop ultrasonic range-finder which is based on pseudorandom code.
Loop使用一个新生成的随机码重复这个循环,直到行扫描不再生成匹配值。
Loop repeats the cycle with a newly generated random code until a scan of the rows does not produce a match.
如果扩频序列采用正交性能好的伪随机码,系统的性能可以优于其他系统;
The dissertation use theories analysis , computer simulation methods with hardware to analyze system performance , data-mapping method and effect of PN code.
信号采用伪随机编码进行相位调制,相当于是用载频对伪随机码进行上变频。
Using pseudo random code to modulate the signal's phase equals to frequency up-conversion of the pseudo random code by the carrier frequency.
其次,介绍了几种常用的伪随机码捕获方法及不适合于P码直接快速捕获的原因。
Secondly, this thesis introduces several conventional code acquisition methods and the reason why they are not fit for direct P-code acquisition.
针对激光制导武器使用的有限位伪随机码的特点,提出了对其最小周期的识别算法。
Based on the characteristic of the pseudo-random code, the algorithm of identify the minimum period was given.
被高速伪随机码调制的扩频信号,其伪随机码是具有随机编码信号特征的周期信号。
The spread spectrum (SS) signal is modulated by high-rate pseudo noise code, and belongs to typically periodic signal.
说明硬件测试中伪随机码序列特点和生成原理,并对比较时如何使数据对应做出讨论。
The comparing program in VB, how to produce a pseudorandom bit stream, and how to make the compared synchronous data correspondingly is described.
为提高伪随机码连续波(PRC - CW)雷达性能,讨论了近距离目标干扰抑制方法。
A method for suppressing the interference of close-in targets for pseudo random code continuous wave (PRC-CW) radar is discussed to improve the radar's performance.
本文提出了一种能同时测量血管平均流速和局部流速的改进伪随机码互相关直接提取方法。
This paper put forward an improved direct extraction method with pseudorandom cross correlation function, by which, the average and local velocity in blood vessel are measured simultaneously.
在计算机通讯中,可采用伪随机码技术来进行识别。本文给出了识别装置的硬件和软件设计方法。
In computer communications, the pseudo - random code technique is used for recognition. A process of hardware and software design for the recognizing device is given in this paper.
研究了直扩系统的数学模型,扩频用的伪随机码,扩频信号的相关接收,扩频系统的同步和跟踪等。
The mathematics model of DSSS, PN code, correlative reception of spread spectrum signal, synchronization and tracking are studied.
本文将伪随机码应用于超声波测距中,解决了超声波测距中存在的测距精度低和测量距离近的问题。
PRBS is applied in ultrasonic distance measurement in this article, which resolves some problems existing in it.
针对目前在研的激光引信探测的关键问题,即激光引信的前倾探测和伪随机码探测技术进行了分析。
The key technology of laser fuse is studied at present, including mainly pitch detection technology and pseudorandom code technology are introduced.
利用有效星历所提供的先验信息,对伪随机码的搜索范围进行压缩,缩短了伪随机码失锁重捕的时间;
The searching range of pseudo noise code was narrowed utilizing to the information provided by epicheirema. The lost reacquisition time was shortened.
载波跟踪环用于对接收信号的载波频率进行精确跟踪,而码跟踪环是用于实现伪随机码延时的精确对准。
The former is used to achieve the fine estimation of the carrier frequency while the later is used to achieve the fine estimation of the code delay of the PRN code.
第五章对雷达干扰进行了阐述,主要的干扰信号有连续噪声调相干扰、伪随机码噪声干扰、多假目标干扰。
In chapter 5 the jamming such as phase modulation noise, binary pseudo random sequence and multiple pseudo targets are discussed.
讨论了高动态下GPS伪随机码并行搜索的基本原理,以及自适应门限确定方法与搜索过程中应注意的问题。
Discusses the basic theory of PN code parallel fast acquisition of high dynamic in GPS, the method of confirming the auto adaptive threshold and some important problems in acquisition process.
分析了伪随机码的相关特性,讨论了基于伪码相关技术的超声波液位测量原理,设计并完成了液位测量系统。
The relative characteristics of the pseudo code are analyzed. With discussion on the principle ol ultrasonic level measurement based on pseudo code technology, the level measuring system is designed.
针对伪随机码的特点,增加了简单的信号处理过程,只需接收三个激光制导信号,就可以对其实施有效干扰。
If simple signal processing technology was used, LGW which use fake-random laser code can be jammed effective when three indicator laser pulses were received.
为使星载激光高度计实现高空间分辨率,提出了一种联合采用伪随机码调制光纤激光器和单光子计数的测距方法。
A method combining pseudorandom modulation of the fiber laser and single-photon counting is proposed to realize a high spatial resolution for the space-borne laser altimeter.
使用完全正交的伪随机码代替单脉冲信号对超声信号进行调制,以提高发送信号的抗干扰能力和系统的测距精度;
The pseudorandom code instead of single impulse is used for modulation to improve the capability of anti-jamming and precision of measuring range.
论文重点研究了DVB - H系统中各个信道编码,包括伪随机码,RS码,压缩卷积码和内外交织的编解码算法。
Then it researches the different kinds of channel codec in DVB-H system, including pseudo random code, RS code, punctured convolutional code and interleaving.
讨论了一种伪随机码跟踪环的特性,分析了码相关间隔、预检积分时间、环路带宽及信噪比等参数对码跟踪性能的影响。
The characteristics of PN code tracking-loop is discussed. The impact of parameters, e. g. correlation slot, integration time, loop width and SNR on code tracking performance is analyzed.
伪随机码绝对式编码器采用M序列伪随机码作为编码方法,采用双狭缝技术进行分时位置读取,并采用ROM元件进行译码输出。
M sequence pseudorandom code is used for encoding the pseudorandom code absolute encoder, double slit technique is used to perform time sharing reading and ROM is used as the coding device.
结合实际情况对这几种方法进行分析比较,在现有技术设备条件下得到了一种比较理想的伪随机码测距方法—星上处理伪随机码测距。
Also these methods a re analyzed and compared in the factual condition and a perfect pseudo noise code ranging method is educed. That is PN code ranging with on -board processing.
结合实际情况对这几种方法进行分析比较,在现有技术设备条件下得到了一种比较理想的伪随机码测距方法—星上处理伪随机码测距。
Also these methods a re analyzed and compared in the factual condition and a perfect pseudo noise code ranging method is educed. That is PN code ranging with on -board processing.
应用推荐