黄铜灯泡和黄铜锅炉烟栈均形所使用的手工具,而纺纱对车床。
The brass bulb and brass boiler smoke stack were both shaped by the use of hand tools while spinning on a lathe.
实际切圆直径是锅炉稳定安全运行的一个重要参数,炉膛出口残余旋转是造成烟温偏差的主要原因。
The diameter of actual tangent circle is an important parameter for safety of boiler, the residual rotation is the key factor of flue gas temperature deviation at furnace exit.
大型四角切圆燃烧锅炉的烟、汽温度偏差对其安全运行具有重要影响。
The temperature deviation of gas and steam influences the safe operating of large pulverized combustion boiler with tangential firing.
协调锅炉水、煤、风、烟、电之间的平衡配合,实现机组的安全、经济、优化控制。
Coordinate equilibrium cooperation among boiler water, coal, wind, cigarette and electricity, realize the security, economy, optimize controlling of the unit.
并用它表征塑性材料的抗磨性能。该系数可直接应用于计算燃煤锅炉对流受热面的安全烟速。
The coefficient can be indicative of the material abrasion resistance properly and directly used to calculate the safety gas velocity in the convection heating surface of coal-fired boilers.
本产品出厂时由五大部分组成:锅炉主体、烟风道、除尘器、管路系统。
This product is made up of five parts: boiler main body, smoke air duct, dust collector, pipe system.
大型电站锅炉的烟温偏差与汽温偏差是影响机组运行可靠性的主要因素之一。
Temperature deviation of flue gas and steam in large capacity utility boilers is one of the main factors affecting the operating reliability of power unit.
阐述了一台利用石化行业催化裂解装置废气的余热锅炉设计过程,重点介绍解决锅炉积灰、磨损和漏烟问题的方法。
The design of a waste heat boiler as well as methods concerning the ash deposit, abrasion and flue gas leakage for the petrochemistrys catalytic cracking process are introduced.
本文对手烧锅炉燃烧时产生的黑烟进行了分析和评述,介绍了向湿法除尘器里添加洗衣粉的消烟除尘方法。
The black flue from boiler was analyzed. The method of removing flue dust in which washing powder is filled into wet dust remover is introduced.
锅炉密封、保温是锅炉性能的重要组成部分,是防止锅炉漏烟、漏灰、漏风的关键所在。
Furnace sealing of boiler is an important part of the boiler performance, which is critical for prevention of flue gas leakage and ash leakage.
测试结果表明:工业锅炉中,炉内燃烧室与燃烬室之间的折烟墙的形状对炉内燃料燃烧有较大影响。
It indicates that the fold smoke wall's shape of firebox and reburning chamber may influence the burn efficiency in the industrial boiler.
四角切圆燃烧锅炉炉膛出口气流的残余旋转,是形成炉膛出口和水平烟道两侧烟温偏差的重要原因,可造成高温受热面热偏差和超温爆管。
In circular firing system, residual rotation of airflow at furnace outlet is the main reason for gas temperature deviation between two sides of furnace outlet and horizontal gas duct.
证实了炉内增拱可较大的提高炉内燃烧强度,提高抛煤机锅炉的热效率和炉膛出口烟温。
It is confirmed that, the operation level of stoker boilers can be improved such as enhancing the combustion intensity, boiler thermal efficiency and flue gas temperature of furnace outlet.
由于炉膛出口烟温的偏差使我国许多电站锅炉的出力达不到额定值,因而直接影响到整个电厂的安全经济运行。
Now, in our nation power station, there is the large deviation between the actual exit flue gas temperature and the designed exit flue gas temperature.
讨论了四角切圆燃烧锅炉炉膛出口烟温偏差的原因,提出了消除偏差措施的设想。
Discussing the cause of flue gas temperature difference at furnace outlet in 4 corners tangentially coal fired boilers and proposing measures to eliminate such difference.
锅炉炉膛出口烟温偏差给安全经济运行带来危害。
Deviation of flue gas temperature at furnace exit may bring about harm to the safety and economic operation of the boiler.
论文分析了该锅炉设计所依据的热力方法的缺陷,使炉膛出口和对流烟道烟温的计算值严重偏低;
Defects in thermal calculation method on which boiler design is based were analyzed. Such defects caused the calculated value of gas temp. at furnace outlet and convection Pass being lower.
对卧式内燃燃油燃气锅炉炉膛出口烟温计算公式进行分析,通过计算实例,比较不同的计算方法,从而得出相同的结果。
The different formulas are analyzed about the smoke temperature of the furnace outlet in the paper. Different calculation methods are compared by the example, and the same results are concluded.
文中介绍了一种实现锅炉尾烟含氧量软测量的方法。
A new method realizing the soft-sensing of oxygen content in boiler flue gases is presented.
打开锅炉的前后烟箱门,检查密封垫片及烟垢,以决定是否更换和清理,同时检修浇注的耐火混凝土和密封石棉垫(绳);
Open the smoke chamber of boiler; check the seal patch and smoke dirt to decide if it needs to clean up or replacement.
锅炉减速机冷灰斗处漏风会举高火焰中间,火焰拉长,致使炉膛出口烟温升高,锅炉减速机简单导致屏过结焦。
Boiler reducer cold hopper leakage will give high flame, flame stretch, the furnace exit flue gas temperature rise, simple to screen a coke boiler reducer.
本发明公开了一种烟煤消烟剂,适用于在工业锅炉、工业窑炉及民用炉以各种烟煤为燃 料的消烟除尘。
The bitumenite smoke suppressor is suitable for eliminating smoke and dust of various kinds of bitumenite for different types of boiler, kiln and furnace.
广泛用于电厂锅炉炉膛折烟角、炉顶穿墙密封等部位。
There are widespread application in such parts as the smoke deflecting corner of furnace chamber of power plant and the wall seal of furnace top.
广泛用于电厂锅炉炉膛折烟角、炉顶穿墙密封等部位。
There are widespread application in such parts as the smoke deflecting corner of furnace chamber of power plant and the wall seal of furnace top.
应用推荐