• 继电器IC 3断开,保护放大器和钳位二极管。

    Relay IC3 opens, protecting the amplifier and clamping diodes.

    youdao

  • 详细阐述和分析了用于正激变换器的有源钳位拓扑。

    An active clamped topology for forward converters is presented and analyzed in detail.

    youdao

  • 继而在四步模式下,研究了钳位电压和驱动电压对机构负位移的影响。

    The influences of the clamping and driving voltages on the recession displacement were studied.

    youdao

  • 由于直流电压源的钳位作用,交流侧输出电压波形为矩形波,并且与负载阻抗角无关。

    Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.

    youdao

  • 该变换器电路结构上采用正激一零电流准谐振软开关电路拓扑结构,并结合了有源钳位技术;

    This module uses a circuit topology of forward pulse width modulated - zero current quasi - resonance soft - switching , combined with active clamp technology.

    youdao

  • 要确保输入端钳位电压足够的高,以避免由于源接点的非线性而产生的问题。

    Make sure the compliance voltage is high enough to avoid problems due to source contact non-linearity.

    youdao

  • 此功能消除了在大多数应用中需要外部钳位二极管,节省了成本和外部元件数量,同时降低功耗。

    This feature eliminates the need for external clamp diodes in most applications, saving cost and external component count, while minimizing power dissipation.

    youdao

  • 钳位电路用于某些数据设备可使接收器输出为常量,并且可在没有收到数据信号时避免噪音干扰。

    A clamp is used in some data sets to hold receiver output constant and avoid troublesome noise interference when no data signals are being received.

    youdao

  • 然而,由于漏感影响,反激变换器功率开关管关断时将引起电压尖峰,必须用钳位电路加以抑制。

    However, due to leakage effects flyback converter power switch off when the voltage spike caused by the need to be inhibited by clamping circuit.

    youdao

  • 利用有源钳位电路实现主变压器铁心对称复位,功率开关在宽输入电压和宽负载电流范围内零电压开关。

    By using an active clamp circuit, the power transformer core is symmetrically reset. Zero voltage switching conditions are achieved over a broad input voltage and output current range.

    youdao

  • 介绍了在二极管钳位三电平逆变器异步电机调速系统中如何采用空间矢量调制与直接转矩控制相结合的控制方法。

    So this paper focuses on the study of direct torque control of induction motor based on diode-clamped three-level inverter.

    youdao

  • 举例说明,20兆赫兹的峰点是钳位过程结束后主要由场效应晶体管输出电容和变压器漏感引起的寄生振荡产生的。

    For example, the peak at 20 MHz in the spectrum is caused by the parasitic oscillation due to the output capacitance of the MOSFET and the leakage inductance of the transformer.

    youdao

  • 提出了有源钳位准谐振变换器的一种新的驱动方式,它无需经过数字电路延时,只需一个电阻和二极管构成的小网络。

    This paper proposes a new gate drive method for active clamped quasi resonant converters. Instead of a digital delay circuit, only a resistor and a diode are added to produce correct drive waveforms.

    youdao

  • 当被测dut发生短路或其他异常导致电流或电压过高时,钳位电路会将输出电压或电流限制在一个固定值上,以保护器件不被损坏。

    Meanwhile, the clamp circuit will limit the output voltage or current at a fixed value when they are abnormal that caused by a DUT short circuit or other fault in order to protect the device.

    youdao

  • 结论:膜片钳技术使探讨烟碱受体拮抗药的作用位点成为可能。

    CONCLUSION: the patch clamp technique makes it possible to observe the action sites of nicotine receptor antagonists.

    youdao

  • 结论:膜片钳技术使探讨烟碱受体拮抗药的作用位点成为可能。

    CONCLUSION: the patch clamp technique makes it possible to observe the action sites of nicotine receptor antagonists.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定