介绍了膨胀环应力近似计算公式及设计实例。
Formula for approximative stress calculation of expansion loop is described with a design case cited.
由此总结出真-视二级参数间相互关系的近似计算公式。
From the conversion formulas, the approximativeinterrelation formulas between true and apparent parameters are deduced.
主要讨论了电感可调的电容器，及其电感的近似计算公式。
The capacitor with adjustable inductance is analyzed here, and the approximate calculating formula is proposed.
应用广义极限平衡法获得了地基极限荷载的近似计算公式。
An approximate formula for calculating the ultimate load on a foundation was derived by using the generalized limit equilibrium method.
最后应用蒙特卡洛实验，验证了近似计算公式的精度和结论。
At last, Monte Carlo simulations are conducted to verify the approximation precision and conclusions.
泊松定理、隶莫佛-拉普拉斯定理给出了二项分布的近似计算公式。
Poisson theorem and De Moivre-Laplace theorem present the approximate calculation formula of binomial distribution.
得出了单根箔条rcs与相对长度之间的关系图形和近似计算公式。
Finally the relationship graph between the relative length and the RCS of single chaff is got.
在摩擦角小于半锥角的情况下，给出了极限承载能力的近似计算公式。
The approximate formula for limit load is found when the fraction angle is less than the half conical one.
因此，本文对其进行简化，得出满足工程精度要求的简易近似计算公式。
So, predigested calculation was applied to find the simple approximate formula meeting the request of engineering precision.
由经典力学理论，对于球形封头开孔应力集中问题，大都采用近似计算公式。
According to the theory of classical mechanics, the problem of stress concentration of open cell of spherical cover end is always solved by approximate computing formula.
提出了合理的加劲位置以及劲条临界刚度的近似计算公式，可供设计参考使用。
The optimum position of a longitudinal stiffener as well as an approximate expression for computing the critical rigidity of the stiffener have been presented for design reference.
本文还对烟囱竖向地震荷载进行了分析，给出了竖向地震荷载的近似计算公式。
The analysis of vertical seismic load of chimney is carried out and the approximate formulas for vertical seismic loads are also suggested in this paper.
在基本假设的条件下，导出了筒形离心式通风机筒壳内气体流动速度的近似计算公式。
With the condition of the basic hypothesis, the approximate calculation formula was worked out on the gas folwing speed in the tubular centrifugal ventilator.
采用矢量场法，得到了在弱导条件下传导模式的特征方程和截止频率的近似计算公式。
The eigenvalue equation and approximate formula for cut-off frequencies of guided modes are obtained by vector-field-method.
目的寻找一种细长液压缸稳定性校核精确解超越方程的近似计算公式且易于使用方法。
In this paper, a new method about stability check of the slightness hydraulic cylinder is worked out.
本文利用微扰法，导出了克尔型非线性对称平板光波导t E模传播常数的近似计算公式。
A perturbation method has been developed to derive the approximate computing formulae of propagation constants for te modes on Kerr-type nonlinear symmetric slab optical waveguides.
在控制器的设计中利用插值法导出了一个超越方程解函数的具有较高精度的近似计算公式。
An approximate formulation with sufficient high precision is obtained from an implicit function in designing the feedback linearization control law.
在使用普通型采样管时，为了满足采样现场的要求，应有一个与之相适应的等速采样流量近似计算公式。
When using a common sampling tube, a formula for approximate calculation of the flow in the sampling tube is needed to meet the request of equi-speed sampling.
现通过实践，推导出单位炸药消耗量的近似计算公式，与查表求出的数值基本吻合，从而更具有实用性。
Here is another approximation formula come from practice to determine the explosive consumption. It is more practical and could be calculated precisely without the table.
针对目前圆形断面均匀流水深计算公式存在计算误差大、适用范围小的弊端，欲提出一种新的近似计算公式。
For present shortcoming of water depth of uniform flow in circular section, which is great calculating error and small application scope, this paper desired to get a new approximate formula.
本文推导出了自由衰减系统线性内耗准确计算公式，并讨论了原有的自由衰减系统线性内耗近似计算公式应用范围。
An accurate linear damping calculation formula for free vibration system has been deduced and the application limits of the corresponding approximate calculation formula has been discussed as well.
在大量有限元数值计算基础上，给出了包含接头螺纹结构参数及裂纹形态参数在内的应力强度因子的近似计算公式。
On the basis of a certain amount of calculations, the authors present an approximate formula, including the design parameters of the thread and the pattern data of the c…
【目的】针对目前圆形断面均匀流水深计算公式存在计算误差大、适用范围小的弊端，欲提出一种新的近似计算公式。
Objective for present shortcoming of water depth of uniform flow in circular section, which is great calculating error and small application scope, this paper desired to get a new approximate formula.
推导了三种钻模定位误差的通用计算公式和微分近似计算公式，提出了在不同定位误差要求下三种定位钻模适用的加工场合。
The general calculation formulas and differential approximate calculation ones are deduced, and the different machining occasions applying those jigs in condition of different demand o…
分析了城市生活垃圾多循环处置系统无形效益的表现形式，并依据无形效益的传递原理，给出了MSWMRTS无形效益近似计算公式。
The expression form of intangible benefit of MSWMRTS has been analyzed. The paper has put forward the calculation formula of MSWMRTS based on its transmission principle.
通过大量管材弯曲试验，分析了沿弯曲线的切向和管壁厚方向的应力应变状态，给出弯管内、外侧管壁厚变化量和切向应变的近似计算公式。
Based on lots of tube bending experiments, the stress-strain state along the tangential direction of bending line and the direction of the wall thickness is analyzed.
通过大量管材弯曲试验，分析了沿弯曲线的切向和管壁厚方向的应力应变状态，给出弯管内、外侧管壁厚变化量和切向应变的近似计算公式。
Based on lots of tube bending experiments, the stress-strain state along the tangential direction of bending line and the direction of the wall thickness is analyzed.
应用推荐