采用机器视觉技术对同步环装配与否进行检测,是一种高效准确的在线检测方法。
Machine vision is a kind of efficient and exact test method in the system of inspecting assembled quality of automobile synchronizing rings.
在机械设计中,装配尺寸链的组成环公差,一般是采用等公差法或等精度法来确定。
During machine design, tolerance of unit ring in assembly dimension chain is usually determined by using either equal tolerance or equal accuracy method.
以最低制造成本为优化目标,介绍了求解装配尺寸链的综合因子法、最低成本法和线性规划法,为合理分配装配尺寸链中各环公差提供参考。
By taking the minimum cost as optimization aim, the synthetic factor method, minimum cost method, and linear programming method of solving assembled dimensional chains are introduced.
如果固定环端面硬度低于HRC40,则应先在端面上重新堆焊一层硬质合金,经磨光后再装配。
If the set collar end hardness is lower than HRC40, should first on the end surface again a built-up welding hard alloy, after the polish repackaging.
如果固定环端面硬度低于HRC40,则应先在端面上重新堆焊一层硬质合金,经磨光后再装配。
If the set collar end hardness is lower than HRC40, should first on the end surface again a built-up welding hard alloy, after the polish repackaging.
应用推荐