所得铝基复合材料组织均匀致密、性能稳定。
The obtained aluminium matrix composite is uniform and dense in microstructure and stable in property.
所成型金属零件的组织均匀、致密,没有缺陷。
The as-formed metal parts are fully dense, homogenous and free of defects.
常化处理使组织均匀化并增加有利于磁性提高的织构组分;
Normalizing treatment makes microstructure uniform and increases component of favorable texture.
经过稀土渗入处理后的镁合金,显微组织均匀、致密,有利于耐蚀性的提高。
The treatment may homogenize, densify microstructure, and further more improve the surface corrosion resistance.
本发明的优点在于:能够制备出致密度较高,组织均匀,物相稳定,导热性高的复合材料。
The invention has advantages that: the composite material prepared by the preparation method has higher density, uniform structure, stable phase and high heat conductivity.
经测试发现,铸铁的组织均匀和碳化物细小时,其布氏硬度与机械加工性能之间呈线性关系。
The test results shows that there is a linear relationship between Brinell Hardness and the machinability of cast iron with homogeneous microstructure or tiny carbides.
实验表明:熔渗铜不仅可以提高材料的密度,而且可以改善材料的组织均匀性,提高材料的合金化程度。
It has been found that high density, homogenous of microstructure and high alloying degree can be attained by copper infiltration.
研究了银氧化锡电触头材料的反应合成制备以及制备的银氧化锡电触头材料在大塑性变形加工条件下的组织均匀化过程。
The fabrication of silver tin oxide by reactive synthesis and the microstructure homogenization of reactive synthesis silver tin oxide in the severe plastic deformation were researched.
研究了1.2311塑模钢扁钢尺寸、终轧温度、回火温度等主要工艺参数对其轧后硬度、回火硬度及组织均匀性的影响。
The influence of processing parameters, such as finishing rolling and temper temperatures, on the hardness and microstructure of 1.2311 plastic die flat steel were studied.
结果表明:电渣重熔法生产的A718钢具有高的纯净度和组织均匀性,选用适当的渣系和生产工艺路线,生产总成本有所下降。
The results showed that A718 produced by ESR has a higher cleanliness and structural unity. Taking suitable refining slags and procedures, the total productive cost can be reduced.
由于低屈强比和组织均匀,管线钢采用针状铁素体组织可以具有较好的(管)成型性及耐腐蚀性。 用针状铁素体管线钢平板或卷板制造的焊管的力学性能彼此相差不大。
Pipeline steel adopting the spicular ferrite owns the better properties of forming and anti corrosion for its low ratio of yield strength and tensile strength and uniform microstructure.
花岗石平台(花岗石平板)经长期天然时效,组织结构均匀,线胀系数极小,内应力完全消失,不变形。
A granite platform (Granite Flat Panel) was a long-term natural aging, organizational structure, uniform, linear expansion coefficient is extremely small, internal stress disappear, not deformed.
组织结构均匀,热胀冷缩系数小。
The organizational structure is even and the expansion and shrinkage coefficients are small.
研究表明,薄板坯的二冷强度大,凝固速度快,组织细小、均匀,其内部溶质元素的偏析程度远低于传统连铸板坯。
It shows that thin slab continuous casting has a greater secondary cooling intensity, a faster solidifying rate, a fine and uniform structure and less segregation than conventional slab casting.
研究表明:适量提高剪切速率或降低温度,半固态组织的固相颗粒会变得细小、均匀和圆整。
The results showed that the solid particle became finer, more homogeneous and rounder with the decrease of temperature or the increase of shearing rate.
剪切速率越高,越容易获得细小、圆整和均匀分布的半固态组织。
The higher the shearing rate is, the finer and more homogeneous the spherical grains are.
结果:肿瘤呈局部软组织增厚或团块状肿块,形态不规则,密度较均匀,增强后轻度强化;
Results:The tumors showed as a thickness or bulky mass of the local supraglottic structure with irregular margin, homogeneous attenuation and slight enhancement.
图1CT平扫:腹膜后巨大类圆形软组织肿块,边缘光滑,密度均匀。
Fig. 1 CT plain scan showed a large round-like well-defined mass, with homogeneous density.
本文对先进涡轮盘坯件,即纯洁、均匀、细晶组织的高温合金坯件制备三种工艺,以及涡轮盘零件锻压成形技术进行综合评述。
In this paper the three manufacturing technologies for making high quality preform, namely clean, homogeneous and fine grained preform and the forging practice of advanced turbine disk is reviewed.
研究结果表明,制备的冷喷涂用ZA20、ZA27合金快凝粉末粒度分布均匀,组织为细小的等轴晶;
The results show that the grain size of produced ZA20, ZA27 alloy powder for cold spray is homogeneous, and the phase of the coat is equal axis crystal.
结果发现:稀土显著细化了半固态铝合金的球形晶粒组织,并提高了球形晶粒的圆整度和均匀性。
The experimental result shows that re can refine the globular grains of semisolid Al-alloy remarkably, improve the roundness and uniformity of globular grains.
淬火组织中马氏体与残余奥氏体的成分不均匀及磨削用量参数选择不当是导致裂纹出现的主要原因。
Uneven components of quenched martensite and residual austenite structure and improper grinding parameter are attributed to the main causes for cracks.
虽然这种液压锻机比落锤锻造要昂贵得多,但它除了能给予大零件较高的强度和更均匀的组织外还有其它优点。
Although the hydraulic forging press is a more expensive piece of equipment than a drop-forge, it has advantages beside those of giving greater strength and more uniform structure to large components.
“C”曲线测定结果表明,设计钢具有高的贝氏体淬透性,可在较大截面上获得均匀的组织和性能。
The results of measurement of the "C" curve show that the steels designed have a high bainitic hardenability and the uniform structure within a bigger cross section can be obtained.
本文在总结现有头模型建模方法的基础上,依据实际存在的头部组织电导率不均匀分布的情况建立了四层偏心球模型。
On the basis of current construction methods of head models, four-layer sphere model was constructed in this paper according to asymmetry prosperities of brain tissues.
结果表明,改变铜液流动方式能够细化晶粒,提高凝固组织的均匀性。
The results reveal that the change of flow ways of liquid copper can evidently refine the grain size and improve the distributed uniformity of solidified structure.
结果表明,改变铜液流动方式能够细化晶粒,提高凝固组织的均匀性。
The results reveal that the change of flow ways of liquid copper can evidently refine the grain size and improve the distributed uniformity of solidified structure.
应用推荐