• 在连轧最后的水平辊出口带立辊轧制可使此压应力增加。

    The compressive stress can be increased in the case of continuous rolling with vertical edging rolls at the exit of last horizontal rollers.

    youdao

  • 随着循环量的增大,立管内的负压差梯度及气固相对速度也随之增大;

    The negative pressure gradient and slip velocity in standpipe increase with the increase of circulating rate.

    youdao

  • 得出表征立轧时轧件断面特征的四个参量与侧压量、立辊直径、板坯来料厚度及宽度间的关系,并建立了新的数学模型。

    T he relation of the four parameters with initial slab thickness, initial slab width, width reduction and edger roll diameter was obtained and a new mathematical model was accomplished as well.

    youdao

  • 综合考虑规范对立管强度的要求,防止发生压溃和屈曲扩展的要求及限制立管发生漂浮的要求三个条件,确定了满足条件的最小壁厚。

    Considering the requirements of riser strength, system collapse, propagated buckling and limitation of floating, the smallest thickness that meets the requirements is determined.

    youdao

  • 本文应用快速付立叶变换(FFT)计算分析了冲击发生器与分压器之间的相互作用对全波波头时间测量的影响。

    This paper deals with the influence of impulse generating and measuring system on the measurement of lightning impulse front time by Fast Fourier Transformation (FFT).

    youdao

  • 本文应用快速付立叶变换(FFT)计算分析了冲击发生器与分压器之间的相互作用对全波波头时间测量的影响。

    This paper deals with the influence of impulse generating and measuring system on the measurement of lightning impulse front time by Fast Fourier Transformation (FFT).

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定