关于屏蔽小电流、高电阻和高阻电压电路的更多信息，可参考第5章。
Further information on shielding low current, high resistance, and high impedance voltage circuits can be found in Section 5.
更换电压调节器，步骤(从第2页开始)。
承包商可以选择在涂敷日用低于本规范第6部分规定的电压来进行漏涂检查，按照他们自己的操作程序。
The contractor may elect to holiday test on the day of application, using a lower voltage than specified in Section 6.0 of this specification, for his own control procedure.
数字可设定地址的光界面- - -第206部分：控制开关专门要求- - -从数字信号转化为d.c。电压(设备类型5)。
Digital addressable lighting interface - Part 206: Particular requirements for control gear - Conversion from digital signal into d. c. voltage (device type 5).
电磁兼容性。第4- 11部分：试验和测量技术。电压磁倾角、短暂中断及电压随变抗扰性试验。
Electromagnetic compatibility (EMC) - Part 4-11: testing and measurement techniques - voltage dips, short interruptions and voltage variations immunity tests.
可以使用第3.2和3.3节所介绍的低电压和低电阻测量工作中使用的技术来测量电阻。
The resistance is measured using the techniques described in Sections 3.2 and 3.3 for low voltage and low resistance measurements.
注：关于其他电压与频率、绕组保护以及接线盒位置的编码，请见第20页订货号。
Note: About the code of other voltage and frequency, winding protection and connection box position, please refer to Orde No. in page 20.
一个串行端口接点可被用来控制电源，设定G 1,G2和G3电压，选择X线影像增强器视野，或延迟测量实际极间电压(看第4章)。
A serial port interface can be used to take control of the power supply, to set G1, G2 and G3 voltages, to select the XRII field, or to measure back the real electrode voltages (see chapter4).
第 二选择单元依据N位数字信号的N-M个最低位，选择第二组参考电压之一作为输出模拟电压。
The second selected element selects one of the second groups of voltage references as an output analog voltage according to N-M least significant bits of the N-bit digital signal.
忽视第四波段(耐)和第5次带(额定电压)。
Ignore the 4th band (tolerance) and 5th band (voltage rating).
忽视第四波段(耐)和第5次带(额定电压)。
Ignore the 4th band (tolerance) and 5th band (voltage rating).
应用推荐