在达到试验目的的同时避免了触头的烧损。
When the test purpose is achieved, the burning and destroying to the contact is simultaneously avoided.
分析了影响工业炉的燃耗与烧损的主要因素。
The main factors affecting fuel consumption and ignition loss of industrial furnace are analyzed.
烟烧损了喉咙和肺。
高浓度的强氧化酸甚至会引起烧损，应注意观察。
High concentrations of strong oxidizing acids may even cause burning and should observe.
轧钢加热过程中，降低燃耗与烧损具有重要意义。
In the heating process of rolling reduction of fuel consumption and ignition loss is of great significance.
分析了废钢比和吹炼元素烧损对钢铁料消耗的影响；
The influence of scrap ratio and loss of elements by burning on ferrous charge consumption is also analyzed.
通过洗炉、稳定煤气流措施使风口频繁烧损现象消除。
According to flushing furnace, stabilized BF Gas flow, phenomena of tuyeres damaged were removed.
焊接闪光烧损量、退回距离及复位距离都可自由调整。
Welding flash damages, moving back space and resetting distance can be adjusted freely.
这粉与水混合，以三或四倍每天减少糖尿、口渴烧损。
This powder mixed with water, taken three or four times daily reduces sugar in the urine and allays thirst.
往复炉排能适应低热值煤的燃烧，但是炉排片经常烧损。
The reciprocating-grade is generally adapted in burning lower-grade coals, but its grade bars are frequently damaged by burning.
采用防火结构，即使软密封材料烧损，金属密封仍能起到作用。
Adopts the fireproof structure. Even if the soft sealing material is burned, the metal seal still takes effect.
根据观察、测量及分析，找出了发电机碳刷烧损事故的主要原因。
Based on observation, measurement, and specialists analysis, the main causes of burnout failure for carbon brush on said generators have been found.
钢铁材料的氧化烧损严重影响着材料的应用，一直是人们关注的对象。
Due to the severe decrease of the steel properties, the oxidation of steel is always paid attention to.
燃油舱和滑油舱，分段阶段进行扫砂处理和清洁，后续烧损打磨清洁。
For fuel oil tank and lubrication oil tank, shipyard plan to sweep blasting and cleaning at block stage. For the burnt damage areas should be grinding and cleaning at quay stage.
江苏沙河抽水蓄能电站2号机组在调试过程中曾出现上导瓦烧损事故。
The upper guide bearing pads of unit 2 in Jiangsu Shahe Pumped-storage Power Plant had been burned to damage during commissioning period.
分析和归纳汽车空调压缩机电磁离合器烧损原因，并提出相应的预防措施。
This paper analyzes and summarizes the causes of burning loss of magnetic clutch for automotive air-conditioning compressor, advances the corresponding protective measures.
防止诸如破损、进入灰尘和污泥、水、油、油漆飞溅、烧损等损耗和危害。
Wear and tear to be prevented as well as damage, ingress of grit and dirt, water and oil, paint over spray, burning damages etc.
如果安装质量和设备缺陷引起推力瓦在运行中受力不均，会导致推力瓦烧损。
Burning accident can be resulted from non uniform pressure on the thrust bearing pad due to under performance of installation and equipment.
结合生产实践，摸索烧损规律并改善其在大规格自耗锭中的纵向、径向偏析。
Combining with practice, explored its regularity of burning down and improved the longitudinal and radial segregation in the large ingots.
本文详细介绍了江都四站推力瓦的烧损情况，并对烧损的原因进行了理论分析。
Details of burning accidents of Jiangdu forth pumpimg station are described and theoretic analysis of the cause is given in this paper.
讨论了不同结合剂与不同性质沥青相配合时修补料的烧结强度指数及烧损率的变化。
The changes of the sintering strength index and sintering loss rate of the mixes with different binders and pitches were discussed.
简要叙述了镇海1号燃机燃烧筒烧损的现象并分析了原因，提出了相应的防范措施。
This paper describes the condition of combustion chambers of No. 1 gas turbine burned in Zhenghai Power Plant, analyses the cause of this failure and gives some countermeasures.
为了节省能源、减少烧损、缩短生产周期，国外钢铁企业十分关注它们的一体化管理。
To save energy, reduce burning loss, and shorten manufacturing cycle, foreign iron and steel corporations focus on the integrated planning and scheduling of them.
如果油缸内残留空气受急剧夹压时，那么，由于液压油的作用，有可能使密封圈烧损。
If the residual air in cylinder is impacted by abrupt clamp pressure the seal ring will be damaged due to the effect of diesel oil.
在加热模套时，可放入少量颗粒木炭，通过木炭的燃烧消耗氧气达到减少氧化烧损的目的。
As heating die sleeve, a few grain charcoal is added and oxygen is consumed by charcoal burning so that oxidation burning loss is reduced.
从而避免了传统电镀锌板直接焊接成型油箱内表面漏镀、焊缝及热影响区锌层烧损等缺陷。
It can also avoid pretermission of plating, burnout of zinc layer on weld beam and heat affected zone, and other limitations on the inner surface of fuel tank made of galvanized sheet.
加热炉的生产目的是满足轧制要求的钢坯温度分布，并实现钢坯表面氧化烧损最少和能耗最小。
The purpose of reheat furnace production is to acquire the slab temperature distribution rolling required, and achieve the fewest stock scale loss and energy consumption.
分析矿用鼠笼型电机定子、转子烧损的原因，提出设计、制造及其使用中预防电机烧损的措施。
This paper analyzes the causes of overfire for stators and rotors of mining cage motors and points out the measures of preventing the overfire for motors in design, manufacture and use.
分析矿用鼠笼型电机定子、转子烧损的原因，提出设计、制造及其使用中预防电机烧损的措施。
This paper analyzes the causes of overfire for stators and rotors of mining cage motors and points out the measures of preventing the overfire for motors in design, manufacture and use.
应用推荐