我国的木材加工企业绝大多数使用的是蒸汽干燥和炉气干燥。
Most of wood drying kilns in China are steam drying and furnace gas drying.
炉料的成分中，有时含一些有价组分，这些有价组分也可能出现在炉气中。
Constituents of the charge, sometimes including values, may also appear in the furnace gases.
介绍了密闭电石炉炉气利用的实践探索过程及炉气烧余热锅炉产蒸汽技术。
The article tells about the practical process of using furnace gas in closed carbide furnace as well as the technique of producing steam with furnace gas.
在流化床中，粒子和炉气发生剧烈的紊流运动，加快了炉内传热和传质过程。
In fluid bed, both particles and carrier gas occur violent turbulence so that the heat transfer and mass transfer in the furnace are speeded.
通过对数学模型的求解，研究分析了加热炉内炉气、板坯温度分布的变化规律。
By solving the mathematical model, the regulation on the temperature distribution of the furnace gas and slab in heat furnace was analyzed.
基于边界条件替换方法建立了高炉冷却壁本体和捣打料与炉气之间的换热系数计算模型。
A calculation model of the coefficient of heat transfer between gas and stave body and inlaid refractory is built based on the substitution method of boundary condition.
运用物料平衡及反应平衡原理，利用炉气连续分析的数据，建立了转炉冶炼过程的动态模型。
Applying the mass balance and the reaction equilibrium theory, a dynamic model of BOF, steelmaking process based on the continuous analysis of exhaust gas was established.
研究表明，分别以丙烷气和天然气为原料气制备吸热式可控气氛炉气时，天然气要优于丙烷气。
The results showed the natural gas is better than propane when natural gas or propane is used for controllable atmosphere.
如何利用电石炉的炉气使它变废为宝，这不仅是节约能源也是净化空气、减少污染的一项综合性的措施。
Making use of furnace gas can not only convert the waste into a useful material, it is also a comprehensive measure to clean up the air and decrease the pollution.
介绍了利用自行研制的取样枪、测温枪等设备，对武钢第三炼钢厂的大型转炉炉气进行取样、测温的过程及结果。
This paper introduces the measurement of large converter gas parameters at No3 Steelmaking Plant of WISCO using new-developed measuring devices, such as new sampler and new thermoprobe.
在高速升温段，由于局部炉气分布不均匀，修正换热系数较大；而在预热和保温段，计算所得的修正换热系数较小。
The corrected heat transfer coefficient is large in the high-speed heating process due to the local an uneven furnace atmosphere distribution, and is small in the preheating and holding period.
此外，给出了炉气为非灰时的辐射全交换面积的一种计算方法，为准确求解加热炉炉膛内的辐射热交换创造了条件。
Furthermore, a new method is given to calculate total radiation exchange areas which provide advantages for correctly calculating the radiation heat exchange in reheating furnace.
在系统分析NK SV分解炉气固两相运动规律及其性能特点的基础上，指出了NKS V分解炉的不足之处，提出了改进方案。
Based on the analyses of motion mechanism and performance of gas-solid phases in NKSV calciner, the disadvantages of NKSV calciner were presented, and the methods of modifying design are put forward.
对闵行发电厂10号炉乏气送粉制粉系统爆炸事件进行了分析。
Analyzes the explosion accident of the PF bunker type milling system with exhaust gas as the conveyance medium of NO. 10 boiler in Minhang Power Plant.
控制原料气中氯离子含量，选择适宜的过渡段炉管材质以及严格控制转化炉运行参数，可使腐蚀得到控制。
The corrosion can be controlled by selecting proper material for transitional section reformer tubes and strict control of reformer operating parameters.
流态床炉是一种新型的热处理设备，是利用气固流态化技术制成的。
Fluidized—bed furnace is a new type device for heat treatment, which utilises fluidization technology for moving solid particles in a state of suspension by the action of gases.
利用原有锅炉，设计与之匹配的卧式燃烧炉和燃烧器回收造气吹风气潜热。
By utilization of the existing boiler a horizontal combustion furnace and a burner that match have been designed for the recovery of the latent heat in the blow gas.
煤气、水煤气、炉煤气及类似气体，但石油气及其他烃类气除外。
Coal gas, water gas, producer gas and similar gases, other than petroleum gases and other gaseous hydrocarbons.
变压煤气发生炉是一种以碎煤为原料直接生产带压原料煤气和燃料煤气的制气设备。
The pressure swing gas producer is a kind of equipment which can directly produce gas with certain pressure and making use of pieces coal.
实验结果表明，在合成气制备炉下部主要发生甲烷和碳的氧化反应，氧气完全消耗。
Experimental results indicated that oxidation of methane and carbon occurred simultaneously in the lower zone close to the furnace bottom and O2 was used up.
煤气或天然气的确很容易控制，但气压偏低时，你最好能预备一个大功率的电热炉来炒菜或是烧开大锅的沸水。
Gas is certainly the most supple heat source, but if gas pressure is low, it is wise to have one strong electric hot plate for sautes and for boiling large POTS of water.
本系统中的数字量由PLC控制，数字量主要控制真空系统、烧结炉和化学气相沉积炉中各通气管路中的开关量。
In the system the digital is controlled by PLC, digital is mainly used to control the switch data of pipeline in the vacuum system and metallurgical vessel and CVD vessel.
真空炉高温除气工艺可以大大降低不锈钢出气率。
The stainless steel out \ | gassing rates can be reduced greatly by high temperature degassing technology in a vacuum furnace.
介绍了在二氯乙烷裂解炉燃料气中添加氢气的工艺过程和效果。
The process of adding hydrogen gas in fuel gas of ethylidene chloride pyrolyzer and its effects were introduced.
介绍了环式焙烧炉天然气供气监控系统、燃烧架的结构与功能及加热炉室温度控制过程。
The natural gas supply control system, structure and function of burning frame as well as temperature control procedure of furnace of the annular baking furnace are introduced.
介绍了加热炉油改气的实践和使用效果。通过采用新工艺、新材料，提高了加热炉的技术装备水平。
This pape introduces the "convert oil to gas" practice in rolling heating furnace. Using some new techniques and materials, the equipment level has been raised.
通过在移动床气化炉的造气实验表明，该气化型焦完全符合工业化造气用煤要求，可替代焦炭作为生产半水煤气的原料。
It has been proved that the formed coke is qualified to be used as industrial gasification coal that produces gas with the formed coke in the moving bed gasify furnace.
分析了水煤气发生炉造气工艺存在的不合理之处，提出了造气工艺的改进措施。
This paper analyzes the unreasonable matters existed in the gas manufacturing process of water gas generator and presents a proposal of improvement measures for gas manufacturing.
热出口气体从转化炉进入耐火材料衬里的进气室。
The hot exit gas from the reformer enters the refractory-lined inlet chamber.
热出口气体从转化炉进入耐火材料衬里的进气室。
The hot exit gas from the reformer enters the refractory-lined inlet chamber.
应用推荐