吸泥方式分为虹吸、泵吸两种形式。
The absorbing sludge styles have two styles of siphonage and pumping.
潜流交换机理主要包括泵吸交换和冲淤交换。
The main mechanisms of hyporheic exchange include pumping exchange and turnover exchange.
机舱内设有应急舱底水吸口，直通舱底泵吸口。
There is emergency bilge water suction mouth in the engine room, which directly to the suction mouth of bilge pump.
泵吸式直接采用液下泵或自动耦合式潜污泵抽取污泥。
The pumping style takes out sludge directly by unde-water pump or automatic coupling submersible pump.
针对“泵吸”运移机制，对天然气沿断裂运移冲注模式及聚集规律进行了探讨。
Toward the migrating mechanism of "pump suction", it discusses the migrating model and the accumulating law of natural gas through fault.
这些坚固的泵设计用于处理粘性液体，可在各种应用中提供高效、无脉冲的泵吸。
Designed to handle viscous fluids, these rugged pumps provide high efficiency, pulse-free pumping over a wide spectrum of applications.
泵吸中心巨大的压力降使深部的承压流体在富钠质岩系中产生周期性的构造泵吸—水力压裂—沉淀愈合作用。
The large pressure decline in the pumping centre caused the deep-seated confined fluids to develop periodic tectonic pumping, hydrofracturing and precipitation healing in the sodium-rich rock series.
例如，如果加油站当前销售E85燃料，那么它的泵浦就可以接受改造，使其能够从E85和E10的储罐中泵吸燃料，然后输送出一种代用的混合燃料。
If a station is currently selling E85, for instance, the pump could be modified so it could pump fuel from the E85 tank and an E10 tank to deliver an alternative blend.
气力提升泵的水输送量反映了提升管进口的流速情况，而进口流速是衡量吸鱼效果的重要因素。
The water flow velocity in the suction pipe, which is crucial for evaluating the performance on pumping fish, can be measured by the pumped water flow rate of the riser in an air lift pump system.
喷漆泵的吸口一定要加装全新的过滤网，吸口软管也要替换成新的。
Spraypump suction must be equipped with a new filter, suction hose is replaced with new one.
干燥塔、二吸塔串接共塔，且与一吸塔共用循环槽、循环泵，即干燥塔的下塔酸直接引入二吸塔。
The air drying and final absorption towers are installed in series as an integral and share a circulation acid tank and pump with intermediate absorption tower.
这就意味着泵可以干转、自吸以及处理高黏度、高磨损介质。
This means that pumps could be dry turn, self-absorption and processing of high viscosity, high abrasion medium.
单级单吸离心泵是根据国际标准ISO2858所规定的性能和尺寸设计的。
Single-stage single-suction centrifugal pump is designed in compliance with performance and size prescribed in the international standards ISO2858.
双螺杆泵系列产品分为单吸双螺杆泵和双吸双螺杆泵两大类。
Double screw pump series products are divided into single suction of two kinds of double screw pump and double suction double screw pump.
介绍迷宫环封密装置在吸口侧无封水的大功率泥浆泵上的应用，以及迷宫环的设置与安装。
The paper introduces the application and installation of labyrinth sealing device in high - power mud pump without being sealed at suction mouth side.
绞吸挖泥船是利用绞刀松动泥土，使之与水混合，而后用泥泵将泥浆泵出的挖泥船。
Cutter-suction dredger looses the soil to mix with the water by cutter, and pumps the mud by dredge pump.
介绍了主要用于吸泥的双流道无堵塞泵的水力、结构设计。
This paper introduces the hydraulic and structure design of double channel non-jamed pump for sucking sludge .
三根互相啮合的螺杆，在泵缸内按每个导程形成为一个密封腔，造成吸排口之间的密封。
Three mutual engagement of the screw in the pump cylinder for each lead of the formation of a sealed chamber, causing the seal between the suction mouth.
在塞拉利昂克莱恩船厂滑道改建工程中，对吸泥泵组的配套工艺设计及使用情况作以介绍。
This paper presents associated technology design and application of a dredge pump unit in the rehabilitation project in Cline Shipyard, Sierra Leone.
ZW系列自吸式无堵塞排污泵是在反复研究国内外同类技术的基础上开发成功的一种结构新颖的产品。
ZW serial self-priming and non-block sewage pump is a new structure product which is developed on base of reaping study of domestic and foreign similar technology.
论述了石油化工用自吸离心管道泵的设计方法，给出了主要的水力设计与结构设计的计算公式与图表。
The design of self priming centrifugal pipeline pump is discussed, the primary hydraulics and structure design formulas and diagrams are offered.
介绍一个以自吸喷射泵为取样泵的水质自动监测系统取样工程建设方案及其日常维护措施。
A sampling project for the water quality automatic monitoring system was introduced in this paper, self-absorption-ejector pump was used in the system instead of centrifugal pump.
绞吸船的核心技术是根据施工条件确定泥泵的运转参数，由此决定了绞吸船的生产能力。
The core technology of cutter-suction dredger is to determine the pump running parameters according to construction conditions and determine the production capacity.
单吸、单级卧式离心泵，用封闭叶轮。
Single suction, single stage horizontal centrifugal pump with closed impeller.
论述了双吸离心泵增大高效点流量、提高水力性能的原理、方法、实施过程及改造结果。
The principle, method, design process and change result to enlarge capacity of maximum efficiency running point and improve hydraulic performance of double suction pump were presented.
当压力脉动发生在液压泵的吸油管路或液压系统的回油管路等低压管路中时，会引起气泡和气穴的产生及破灭。
When the pressure transients occur in low pressure pipelines such as the suction lines of pumps or the return lines of a hydraulic system, gas bubbles and cavitation will occur inside the fluid.
介绍了所研制的65ZXB—28/28型自吸式船用可移式应急柴油消防泵的结构型式、水力设计和试验结果。
Design and study on the 65ZXB-28/28 type of marine movable self-priming fire pump driven by diesel is introduced.
该类泵具有效率高，自吸能力强，无故障运转周期长，无泄露，噪音低，现场管理方便等特点。
It has advantages such as higher efficiency and inhaling ability, longer running time with no failure, without medium leakage, lower noise, convenient management, etc.
本文提出了有关自吸式离心泵泵体及叶轮主要尺寸的设计公式，泵体储液室、气液分离室等的确定方法。
The artical presented Designing formulas of pump body and impeller and the-defining way of liquid storage chamber and air-liquid-isolating chamber of self priming type centrifugal pump.
本文提出了有关自吸式离心泵泵体及叶轮主要尺寸的设计公式，泵体储液室、气液分离室等的确定方法。
The artical presented Designing formulas of pump body and impeller and the-defining way of liquid storage chamber and air-liquid-isolating chamber of self priming type centrifugal pump.
应用推荐