履带式行走具有降低接地比压和防止下陷的优点。
Tracked vehicle has the advantages of reducing the ground pressure and avoiding sinking.
阐述了挤压铸造比压对形核率及成长线速度的影响。
Effects of the specific pressure on nucleation rate and linear growth velocity were expounded in squeeze casting.
介绍了硬填料密封的基本结构及密封原理,给出了比压计算式。
The basic structure and the seal principles of the hard packing were presented, and the formula of specific pressure was given.
通过加水或湿沙可调节压路机配重和接地比压,调节方便范围大;
Operating weight and ground contact pressure can be adjusted by filling water or wet sand with greater adjusting scope.
贝克的土壤力学理论为依据,推导橡胶履带车辆接地比压的分布。
Beck and derives the ground bearing distribution of vehicles on rubber tracks.
接地比压视土壤机械性质、机耕船的几何尺寸和重量等因素而定。
The ground pressure depends upon the mechanical properties of soil and the geometry and weight of the machine.
通过对实例的分析提出了比压实功的概念,并在此基础上建立了能量评价标准。
The concept of compared compaction power is presented, based on which appraisal standard of energy is built.
计算结果还表明,比压加大时,本征频率的实部与离子反磁漂移频率有很大的偏离。
The results also show that the increase in plasma beta-value leads to a departure of the real part of the eigenfrequency from...
本文根据液体在低温状态下,分子运动的特性,提出了低温密封液体的比压计算公式。
Based on the molecular motion characteristics of liquid in low temperature, the paper presents the equations for specific pressure for sealing liquid in low temperature.
目前,在计算制动器比压时有几种方法,其物理概念不清,而且算出的结果相差甚大。
There are currently several ways in calculating brake pressure, but their physical concepts are not clear and their results differ considerably.
当刹车比压和能载增加时,经过不同温度处理的四种试样干态及湿态平均动摩擦系数均相应下降。
The average dynamic FC of four kinds of samples treated under different temperatures was reduced in dry and damp condition as brake pressure and energy were raised.
固定浇注温度和铸型温度,研究压射速度和压射比压对压铸am 60 B合金组织与性能的影响。
At proper pouring temperature and mold temperature, the effect of die casting speed and pressure on microstructure and properties of AM60B alloy has been studied.
而且由于阀杆的楔形块与燕尾槽的作用,对阀门增加了强制密封力,增大了密封比压,实现双向密封。
And because the wedge block and the role of the dovetail groove of the stem, the valve increases the forced sealing force, increases the sealing pressure ratio, the two-way sealing.
球体和阀座密封圈都采用金属材料制造,密封比压很大,依靠介质本身的压力已达不到密封的要求,必须施加外力。
Ball and valve seat rings are metal materials, sealing pressure than the large, rely on the media itself can not seal the pressure has reached the requirements to be imposed by external forces.
研究了半固态A356铝合金浆料的成形温度、压射比压和压射冲头速度对半固态A356铝合金流变压铸充填性的影响。
The effect of forming temperature, injection pressure and piston velocity on the filling ability of semi-solid A356 aluminum alloy slurry were investigated.
试验旨在研究在较高轴压比条件下,高弹模PVA纤维对超高强混凝土短柱抗震延性的改善作用。
The primary objective is to study the effect of high-modulus PVA fibers on improving the seismic performance of super-high-strength concrete short columns with high axial pressure ratio.
反推效率随着压比的增大而降低。
The thrust reverser efficiency declines as the increase of the pressure ratio.
相同的充电条件下,正极与负极的活性物质质量比越大,产生的气体越多,内压越高;
At the same charge condition, the larger mass ratio of positive and negative active materials is, the more gas produces, the higher internal pressure is.
基于两榀接近足尺的后张有粘结预应力混凝土框架的试验,对多跨预应力框架的内力重分布进行了研究,重点考虑了框架的连续性和轴压比的影响。
Based on tests of two full-scale double-span prestressed frames, internal force redistribution of frame was studied and continuity of structures and axial compression ratio of column were analyzed.
根据异形柱的受力特点,论述了在设计时应注意轴压比控制和构造措施等方面的要求。
Based on its stress characteristics, the author introduces points for attention in design such as control of axial compression ratio and structural measure.
本文以某气体分馏装置为例,通过严格的流程模拟,分析了产品质量、回流比和塔压等操作参数对总经济效益的影响。
A case study of gas separation system is given to illustrate the effects of product quality, reflux ratio and tower pressure to total economic benefit through flow simulation.
另外,对叠层橡胶支座的阻尼比随剪应变、压应力及荷载频率的变化情况进行了分析。
Moreover, this paper analyses the shear strain and compressive stress and loading frequency dependence of the damping ratio.
模型对传统修正剑桥模型中的剪胀性公式进行了改进,考虑了状态转换应力比与初始有效围压的相关性。
The traditional dilatancy equation of Cam-clay model was modified and the relativity between the phase transformation stress ratio and initial effective pressure was considered.
目的研究使钢管-钢骨混凝土组合柱发生延性破坏时所需要确定的轴压比限值。
The study aims to find out the proper limited values of axial compression ratio of the steel tube-steel concrete composite column under the condition of ductility damage.
剪压比过大是异形柱节点发生斜压破坏的根本原因,控制节点剪压比尤其是腹板剪压比具有重要的意义。
The main reason of the damage of the special-column is the strong shear force ratio, so it's important to control the shear force ratio of the joint.
温压工艺可达到比传统铁粉压块更高的密度与生坯强度。
Warm compaction process yields higher density and improved green strength over conventionally processed iron powder compacts.
用大蒜治疗的那组比用安慰剂的收缩压大约降低了10mmhg。
They found systolic blood pressure was around 10mmhg lower in the group given garlic compared with those given a placebo.
如果你的医生说你的血压是140比90,那意味着你的收缩压是140,舒张压是90。
If your GP says your blood pressure is' 140 over 90 ', it means you have a systolic pressure of 140 and a diastolic pressure of 90.
如果你的医生说你的血压是140比90,那意味着你的收缩压是140,舒张压是90。
If your GP says your blood pressure is' 140 over 90 ', it means you have a systolic pressure of 140 and a diastolic pressure of 90.
应用推荐